Mazda RX-8

There is no particular tire for them. Prices range from $150-500 per tire. Depending on brand and type of tire.

the computer port is right above the gas pedal under the steering wheel at the bottem

The coolant sensor is a common fault which causes this issue. You will need to replace the coolant expansion tank as the coolant sensor is built into the bottom of the unit.

you have to take the front bumper off start with the side marker lights then there is a guard in front , youll see it when the hood is opened pull that off youll see some bolt. then look for your bolts under ur head light mount there's 3 and then one on top then one final one after the mount is off.

Am afarid that's not really true, all you need to do is turn the wheel in the way (passenger or driver side), take out the black plastic plugs and remove the panels then you will be able to see at least 1 screw and certainly feel the second maybe see it depends how far in you can get. Remove those two screws and the indicator lense will come straight out. ***Note though do not pull it right out as the bulb and wire are still connected, you need to disconnect them first.

usually located on the driver door panel it will say what month and year the car was made and where

My 2005 bone stock Rx8 does 140. Not 1 mph more.

2.

Open the hood and remove the 1 screw holding the side marker. The marker, with a little presure, will push staight out forward.

In the drivers cabin passenger side, first remove the glove compartment. look up a little and away from the center of the car there is a rectangular tray. remove it, lift out the air filter, replace and reinstall

Im only a casual driver but have owned an rx7 as well as the 8. The first rx8 engines were very disappointing, 2004 being the slowest and most prone to stalling in my opinion. We got Mazda to change out our engine & replace it with a 2009. Now we have ma

from what i know since my cousin has this car it does a lot of nice stuff. for the doors if your wondering about if the back 2 doors open they do from the inside. it has 6 speed manual. the class of it is a sports car. if your at a place to get one just hope your lucky because to get a cheap one like my cousin got one that's $18,000. the trunk of the car has good room. its nice and cozy inside and it has a nice looking interior with good air conditioning and a 6 CD input for the music. and you can hook your iPod in it to charge. its got good speed 195mph. it has good room for the seats in the back and it has a sun roof. theres nothing to not like about the car. its got front and side airbags, four-wheel anti-lock disc brakes, stability control with traction control and tire pressure monitoring. it has 212 horsepower and The RX-8 is available in four trims, Sport, Touring, Grand Touring and the R3. hope this helps

turn the key over then tap the brakes 20 times ur oil gauge will go up then back down. turn ur key bk off wait about 30 sec then start ur car up.

No picture, sorry, one is in the Exhaust manifold, and the other is downstream in the Catalytic converter.

Hello there sir i would love to answer your Question but ever to do that i will need some more information from you what sort of alarm system do you have installed like is it a mongoose alarm or uniden they would be after market alarms. then you get factory alarms with the immobilsers in them. Basicly like What an Immobilser is, a remote controled kill switch installed into the cars electrical system. let me give you an idear lets say you have a battery a light bulb and a switch now if eveything is connected and the switch is on the light will light up. now what if we had two switchs one is the igition and the other is the immobilser switch if you tryed to start the car an the immobilser switch is off it doesnt complete the ciricit and the car doesnt start.

It differs - but in all honesty you are unlikely to get insurance on an Rx8 at this age. It would be very very expensive otherwise

Dual rotor, four spark plug, side ported rotary engine.

Between 170 and 200 RWHP stock with a 9,000RPM rev limit for the manual 6 speed and 7,200 RPM limit for the automatic transmission..

The Mazda rx8 yields approx. 16mpg city, and 24highway. Driving habits will cause slight variation.

NGK Inidium RX-8 spark plugs.

YOU NEED TO BE MORE SPECIFIC NOT STARTING CAN MEAN CRANKING NOT STARTING OR NOT CRANKING AT ALL NOT CRANKING AT ALL STARTS WITH THE BATTERY .Is IT CHARGED? IF NOT THEN MAKE SURE IT HAS A GOOD CHARGE IF IT DOES CRANK AND SOUNDS LIKE ITS JUST SPINNING AND NO COMPRESSION THEN IT MIGHT BE LOAdED UP IN THAT CASE REMOVE THE FUEL PUMP FUSE AND CRANK TILL YOU DON'T HEAR A VARIANCE IN ENGINE SPEED THAT ensures no fuel is in the combustion chambers next put fuse back in and lightly touch the gas pedel as you here that familiar pop of an engine trying to start if this does not do this then remove the upper spark plugs and remove the plugs to the coils and remove the fuel pump fuse so there is no spark and no fuel while u crank it there by not turning the engine compartment into a flame thrower and burning the car to the ground nex clean out the iridium spark plugs with brake clean or bu new ones at 25.00 a pop your choice and reinstall install fuel pump fuse crank er up and should start

16mpg/city - 24 mpg/Hwy

how do i remove the starter motor Mazda rx8

You will need wheel chocs, jack, jack stand, philips screw driver No.2, 8 mm socket/wrench, 21mm to remove wheel. Begin by chocing your wheels (use a brick or big rock if needed) front and back opposite to the side you are working on. Loosen, but DO NOT remove your lug nuts on the side with the burned out bulb, jack wheel off ground by two to three inches. Place jack stand securely under vehicle near where the rear of the lower control arm attaches to the body. Remove the wheel, remove the lower portion of the inner wheel well. Three front screws UNDER front of vehicle plus two plastic clips. Leave the three screws used to attach mud flap to wheel well cover intact. 6-7 plastic clips inside the wheel well including the row just above the seam. To remove plastic clips hold outer ring firmly and carefully turn the ceter portion with the number 2 philips (stuby works well). Now remove wheel well cover twist the bulb balast remove from housing. Replace bulb, installation is reverse of removal. Be sure to check your lug nuts after 50km.

If fuel injector cleaner in the gas tank does not correct the problem, see a real mechanic.

You should not attempt the removal of the fuel injectors unless you know exactly what you are doing.

My guess.

Your tires are different diameters, the dynamic stability control will not like that.

No.