Where are matching numbers found on 1967 Plymouth barracuda?
transmission, engine block, then verify by the vin. there is also a sequence number across the radiator support that is the model number. (I'm dealing with the same issue.)
Gfish: Barracuda's don't have VIN # on the radiator support, but my have them on the drivers side dash, drivers side fender tag, and some may have them printed on the cowl sheet metal. Vin numbers are not on engines, or transmissions, these are date coded, build dates the same as that on the VIN are acceptable, but may vary as much as a month, or more.
How rare is a 1968 Barracuda Formula S coupe with the 325 horsepower 340 4 speed?
Not sure about the Numbers Try Here perhaps they can help.
An whatever you do Hang onto that Cuda they are Great cars.
Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
Gfish: very rare, since all 340's ( except 6 bbl motors 290 bhp ) are rated at either 275 bhp, from 1968 to 71, or 245 later.
Will 1967 Barracuda notchback rear glass fit 1968?
Yes it will the trim clips are made different in 1968 my understanding is you have to add them after you measure a 68 for spacing and use a 68 seal and trim but the window glass is supposed to be identical. I had researched this because I have a 67 notchback coupe that needs a replacement window.
What is the gear ratio for a 1974 Plymouth Barracuda with automatic transmission?
The gear ratio was whatever the customer ordered back then, you could get anything from a 2.76 ratio to a 4.10 rear gear.
What causes a coil to over heat?
I would say that nothing causes a coil to overheat except for a bad coil, replace the coil and see what happens.
How do you remove rear glass from 1967 barracuda?
it's best to get a glass co. out to do that job as it's pretty tricky.
How do you know if your idler arm bushings are bad?
Wasn't aware a Merc 190 had an idler arm. However, clunky steering and wander. Observation of the idler arm will show excessive lateral movement
Where is the 1969 Plymouth barracuda engine vin located on a 383 HP?
on the passenger side of the engine under the exhaust manifolds on the side of the block.
Which direction do you set a distributor drive gear in a mopar 440?
In a mopar 440 the distributor drive gear notch is set inline with the crankshaft, but it's just a reccomended starting point as long as you have enough space to turn the distributor in either direction to adjust timing when installed.
What fuse controls a turn signal on a 74 cuda?
On the fusebox, below each fuse, written in white, it will say what each one is for. It will probably say "directional."
How many types of Plymouth barracudas where ever made?
barracuda, formula s, cuda, AAR cuda, 2dr. coupe, 2dr. fastback.
What is the difference between Cuda and Barracuda?
Nothing, it's the same car (or fish)
Actually there is a difference! It is basically the same car but the Cuda was the high perfomance model of the Barracuda. The title of a Cuda even says "Cuda", not "Barracuda". The Cuda usually had a 340 six pack, or a 383 Commando, or 440 with dual quads or six pack, or a Hemi.
barracudas where slant 6 or 318 cudas where any 340 4barrel and above but all parts are the same bolth mopar e body
How many 1969 formula S 383 factory 4 speed barracudas made?
The number "53" that previously was given is partially incorrect.
If it's a hardtop, then that's correct.
But if it's a fastback, the number should be 331. And a ragtop? Seven!
These numbers are for US-spec cars and not Canadian and export cars.
Where can you get a vacuum line diagram for a 1967 Plymouth barracuda 273 cid 2-bbl?
go to the library and get a chiltons repair manual for your year plymouth.