Power Tools

It's for taking off a lot of wood surface fast - for instance if a door rubs in one corner this is what to use.

Yes, the sockets are different in all battery chargers so you can only insert the correct battery.

Any HSS drill bit will make a hole in a nickel. Be careful how you hold the nickel as the bit will very likely jam into it. I use 'vice-grips' when doing something like that, pliers are not strong enough.

No, a drill is different. A screw has regular threads and is screwed into material, a drill cuts holes.

Yes you can,

You can drill very accurate sized holes,

you can drill very large holes with the use of hole saws,

you can drill many identically placed holes, with use of jigs

you can drill holes in many sheets of thin materials if clamped together,

you can drill large holes in very thin materials with use of a fly cutter,

you can drill holes to a precise depth with Forstner bits.

you can mill things flat with milling bits

and many more things - a drill press is a very versatile machine

To cut hard things down.... like trees.

The drill bit's tip is cutting away wood or metal and creating heat because of the friction involved. If you touch the blade of a saw after cutting, you'll notice the same.

You can use a standard HSS drill bit with the edge slightly dulled with a grinder so it does not 'break through' at the outside edge. -Drill slowly and hold the drill steady. I always put a piece of smooth scrap wood at the point where the drill bit is going to come out.

Yes, you can, but be careful of it bouncing back.

NO, when most people say 'power saw' they mean something like a rotary saw.

Because they were big and relatively expensive. Once mitre saws got more versatile and especially when sliding mitre saws became cheaply available, the radial arm became a tool for the woodworking 'purist'.

The colour is irrelevant , that just depends on the manufacturer. To cut through concrete you need a 'carbide tipped' drill bit. This tip is a little wider than the drill bit and is quite obvious.

Some places allow you to donate it for recycling purposes.

so they can take the tools to space

An analyzing tool for the web based game Travian.

The helical flute is best as it carries waste away faster.

Mark it properly and very visibly where you are going to cut. Put the plywood on 2 work-horses, cut it (being sure to MISS the work-horses. Keep your hands out of the way of the blade.

You cannot put tools in your carry-on luggage on an airplane. They may be in your checked luggage to fly, or if you travel by bus or train.

If materials get caught by the drill bit, the material will start to whip around and this is dangerous. Even if injury to the operator is avoided, damage to the material is certain . -Be safe, and clamp all work to the drill table.

Sure if you're adept with tools and welding. -When I was a teen my first kart had a McCulloch chain saw engine. It went great. - Your biggest problem with fitting one on a go-ped will be finding a rear chain ring to fit on the back wheel. You will need a chain ring with about 140-150 teeth, and a solid way to mount it on a spoked wheel..

Gopeds ( real gopeds) do not have spoked wheels. a goped sport has a solid wheel. and solid tire. same with qa goped bigfoot. except it is an airtire. anyhoo have ot make sure engine rotates in proper direction. going backwards at 40 would not be fun. NOW, a goped gsr sure. but youd need to grqab one ofthose Chinese pocket bike transmissions. ( around $20 ) same with my gtr, and other gopeds. same with the Chinese scooters. often incorrectly referred to a goped.