answersLogoWhite

0

📱

Windows XP

MS Windows XP operating system that was released for PC computers in 2001

9,737 Questions

Isn't Windows 2000 the same as Windows XP?

Windows Server 2003 (also referred to as Win2K3) is a server operating system produced by Microsoft. Introduced on 24 April 2003 as the successor to Windows 2000 Server, it is considered by Microsoft to be the cornerstone of its Windows Server System line of business server products[citation needed]. An updated version, Windows Server 2003 R2, was released to manufacturing on 6 December 2005. Its successor, Windows Server 2008, was released on 4 February 2008.

According to Microsoft, Windows Server 2003 is more scalable and delivers better performance than its predecessor, Windows 2000.[2]

So, it isn't.

What is the capacity of a hard disk?

this changes with time. currently average storage of a hard disk is about 250 GB when purchasing a new computer. The highest amount of space I have seen on a new hard drive is 1.5 TB (that's 1024 GB * 1.5) and the smallest I have seen is down to a few MB (1024 MB = 1 GB) but that's for a very very old hard disk.

How do you obtain mac address of HP Laserjet P2055dn?

Usually you don't need the MAC address directly - except perhaps to improve the documentation in a large network.

If you know a device's IP address, you can do a pingcommand; before and after, compare the ARP cache - the one that shows assignments of IP addresses to MAC addresses. In Windows, the steps would be more or less like this:

  • Open a command window
    • arp -d * (this will delete the ARP cache)
    • arp -a (this will show the ARP cache)
    • ping ... (this will connect to the IP address you specify)
    • arp -a (show the ARP cache again. Compare with the previous one.)

      Usually you don't need the MAC address directly - except perhaps to improve the documentation in a large network.

      If you know a device's IP address, you can do a pingcommand; before and after, compare the ARP cache - the one that shows assignments of IP addresses to MAC addresses. In Windows, the steps would be more or less like this:

    • Open a command window
    • arp -d * (this will delete the ARP cache)
    • arp -a (this will show the ARP cache)
    • ping ... (this will connect to the IP address you specify)
    • arp -a (show the ARP cache again. Compare with the previous one.)

      Usually you don't need the MAC address directly - except perhaps to improve the documentation in a large network.

      If you know a device's IP address, you can do a pingcommand; before and after, compare the ARP cache - the one that shows assignments of IP addresses to MAC addresses. In Windows, the steps would be more or less like this:

    • Open a command window
    • arp -d * (this will delete the ARP cache)
    • arp -a (this will show the ARP cache)
    • ping ... (this will connect to the IP address you specify)
    • arp -a (show the ARP cache again. Compare with the previous one.)

      Usually you don't need the MAC address directly - except perhaps to improve the documentation in a large network.

      If you know a device's IP address, you can do a pingcommand; before and after, compare the ARP cache - the one that shows assignments of IP addresses to MAC addresses. In Windows, the steps would be more or less like this:

    • Open a command window
    • arp -d * (this will delete the ARP cache)
    • arp -a (this will show the ARP cache)
    • ping ... (this will connect to the IP address you specify)
    • arp -a (show the ARP cache again. Compare with the previous one.)
  • What are the features of MS-Word?

    Create visually compelling documents more easily than ever

    Save time and simplify your work

    Work together more successfully

    Access your information from more places

    Discover an improved search and navigation experience.

    Work with others without having to wait your turn.

    Access and share your documents from virtually anywhere.

    Add visual effects to your text.

    Turn your text into compelling diagrams.

    Add visual impact to your document.

    Recover work you thought was lost.

    Transcend communication barriers.

    Insert screenshots and handwriting into your documents.

    Accomplish more with an enhanced user experience.

    A box that asks you to make a decision about an indivdiual object or topic is called an what box?

    A tv will give you things to think about such as to like or unlike a person or give you a topic to have about 90% of the time this day in age. when referring to windows Operating system the answer is a dialog box

    1Why does Microsoft recommend using Add Remove Programs to remove an installed application?

    It is recommended by Microsoft as a more complete and thorough way to remove an application rather than using the proprietary un-install option on the software installed. However, occasionally some files and folders can be left behind and these will have to be removed manually from the "program files" folder.

    When you enter tally 7.2 cost centre message is coming as exiting tally internal error contact tally solutions software exception c0000005 memory access violation?

    There are many causes of 'Memory Access Violation' error when working with Tally. I suggest you backup you data by copying your "data" folder in your Tally program folder to a safe place. Then follow the instructions on this page on 'Tally memory access error' http://computing-tips.net/memory_access_error_tally/

    What is the location of the ntoskrnl exe file?

    ntoskrnl.exe is the Windows kernel file. Without it, Windows cannot boot.

    ------------------------------------------------------------------------------------------

    Ntoskrnl.exe error is described by experienced PC users to be a severe system error for it is closely tied with ntoskrnl.exe. Ntoskrnl.exe serves as the critical component for the family of Microsoft Windows NT operating systems. It is designed to provide the Kernel and Executive layers of the Windows NT kernel space, and is responsible for the running of various system services such as hardware virtualization, system process and memory operation. Ntoskrnl.exe manages the running of the Cache Manager, the Executive, the Kernel, the Security Reference Monitor, the Memory Manager, and the Scheduler and other system services.

    The associated files of ntoskrnl.exe contain wnaspi32.dll, win32s16.dll, ntdll.dll, np16b6.tmp, msgina.dll, itcc.dll, HookDll.dll, imagehlp.dll, mhn.dll, bwmib.dll and wtopl32.dll. There are various kinds of system problem can possibly result in ntoskrnl.exe error messages, including damage or incompatible ntoskrnl.exe, missing ntoskrnl.exe, damaged ntoskrnl.exe removal/repair failure, corrupt program install/uninstall, driver file corruption, driver update failure, incorrect modification on Windows registry, associated .dll files and registry files corruption, malware attacks and incorrect removal of system components.

    What stands for CD-rw?

    dorejhhg ffdfghyuyujikut gyhtuuihbbtrtb frfrft ffyhjnhyded hert

    What method can you use to test memory on a windows xp system by using by using the vista memory diagnostics too without having to install vista on the system?

    There are a few steps you will have to go through to be able to test your memory on your Windows XP computer. You will need to use the DVD booting, then click on repair your computer, after that you will select Windows Memory Diagnostic tool. There you will be able to test your memory.

    How can you reuse a trial version program after expiry?

    This is tricky, most modern software places entries into the Windows registry - the heart of Windows. Even when the trial version of software is uninstalled fully, entries (keys) for the software can still remain in the registry. When the trial software is reinstalled, it checks these entries in the registry and therefore "knows" if the software has been previously installed, used and if the trial period has expired. Because of the way these entries are placed, most registry cleaners will not remove them either, as they appear current and valid. Further info can be found here: http://www.addictivetips.com/windows-tips/how-to-reinstall-trial-software-after-trial-period-has-expired/ WARNING: Unless you are experienced in accessing and modifying the Windows Registry, it is strongly advised to avoid making any changes, as these particular entries are usually buried and they are not obvious. Deleting entries in the Windows registry incorrectly can cause system instability and even failure.

    What tool in windows 7 can be used to temporarily disable a startup program?

    The msconfig tool.

    To do this, type into the start menu msconfig and press enter. Go to the startup tab and uncheck the ones that you don't what to run on windows startup, once you've finished, click ok and reboot windows

    What is the purpose of the Wow6432Node subkey in the Windows registry?

    The parent of each 64-bit registry node is the Image-Specific Node or ISN. The registry redirector transparently directs an application's registry access to the appropriate ISN subnode. Redirection subnodes in the registry tree are created automatically by the WOW64 component using the name Wow6432Node. As a result, it is essential not to name any registry key you create Wow6432Node.

    Can computer games be installed on more than one computer?

    Many software licenses restrict the use of a program to a single computer.

    A software license for multiple computers will specify the number of machines on which the program may be installed. Software license agreements for medium to large sized businesses are commonly referred to as, "Enterprise License Agreements".

    Some "Enterprise License Agreement" plans allow the Information Technology (I.T.) support staff or employees to install and use a program on multiple computers provided they do not operate both computers at the same time. In other words, an employee may begin work on their office computer, save it, transport the document home and continue the work there as long as they do not have the software running "concurrently" in the first location.

    Finally, in some instances employees may be granted a temporary license to use software on one or more personally owned computers for the term of their employment. This is most commonly found with Anti-virus software and serves the purpose of preventing a computer virus from transferring from a Personal (i.e. "Home") computer to a business computer.

    How do you format your USB drive to FAT32?

    Don't use DOS for large hard drives. Don't use Computer Management either.

    Use:

    http://tokiwa.qee.jp/EN/Fat32Formatter/index.HTML

    Download and run as instructed.

    This will format a drive of any size in one (or more if desired) partition. Remember that files larger that 4GB will not be recognised in FAT32 format. So break larger files up.

    I ran mine in 'quick format' and it did it in seconds (otherwise it takes hours). Works perfectly.

    Hope this helps.

    What is the use of sysvol folder?

    All security and policy related information are stored in SYSVOL folder that's shared. It's replicate all security & policy related between all DC(Domain Controler). It locate in \\C:\window\.

    Can you change admin password from non admin users in xp?

    To remove an administration password on Microsoft xp,simply go to start,control panel then go to user accounts.In user accounts,click on administrator and the click create a password.After clicking on create a password,type in the current password and click change password(Do not insert a new password or hint,just type the current password and click change password.)That will remove the password in the administrator profile.

    How long does it take to send a fax on average?

    It would only take a few minutes. With the online fax technology, that uses the high speed Internet connection, faxing technique has become so fast and almost in an instant.

    What is the svchost?

    svchost.exe is a system process belonging to the Microsoft Windows Operating System which handles processes executed from DLLs. This program is important for the stable and secure running of your computer and should not be terminated.

    What is the difference between Restart and Reboot?

    Restart is a "soft" operation which you might need to use if you have problems with software or hardware. Restart is handled by software and happens in automatic mode.Reset is "rough" operation which you have use when you cannot restart or turn your PC off. Reset is based on hardware and happens only if you are manually doing that.

    Does Windows XP support USB 2.0?

    Yes. Your motherboard determine support for USB 3.0 .

    Your USB 3.0 devices can still be used in a USB 2.0 port but not with the upgraded speed. And USB 2.0 can be used in USB 3.0 port with it's original speed. Often USB 3.0 is marked with the color blue.

    How much megbytes of addittional storage of hard disk is requires for upgrading Windows 7 Starter to Windows 7 ultimate?

    Windows 7 Starter is only available for a 32-bit system, with the maximum RAM at 2 GB. Windows 7 Ultimate for a 32-bit system has a maximum RAM of 4 GB. Two more gigabytes are required. And if one gigabyte is equal to 1024 megabytes, then two are equal to 2048 MB.

    In short, the requirement is 2048 MB to upgrade from Starter to Ultimate.

    What do you do if you have forgotton your password for Windows XP?

    Method 1: Have a rest and try to remember the forgotten password.

    Sometimes, human being is a little weird. After you have a coffee, or take a snap, you may found that you suddently strike your password.

    Method 2: Try No Password Administrator Login Backdoor

    In Windows XP (not Windows Vista as Administrator account is not enabled by default), there is built-in Administrator user account, that has administrative credentials, enabled by default, and without any password to protect the account from been access. If you didn't change this Administrator's password, then try to sign in to Windows XP without password.

    Method 3: Reset password from another user account with administrator credentials

    If you cannot log on to Windows by using a particular user account, but you can log on to another account that has administrative credentials, follow these steps on how to do the trick: Log on to Windows by using an administrator account that has a password that you remember. You may need to start WinXP in safe mode. Click Start, and then click Run. In the Open box, type "control userpasswords, and then click OK. Click the user account that you forgot the password for, and then click Reset Password. Type a new password in both the New password and the Confirm new password boxes, and then click OK.

    Method 4: Use software program like Windows Password Recovery Basic.Opracker