0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
You will also have to change the driveshaft because the v6 is shorter then the v8. Not the mention that the bell housing might be different too. I am not sure what you mean by pulleys? The ones on each engine should remain with each engine. Not many pulleys on different engines are interchangeable.
Do you have a wire diagram for a 1965 Chevy 283?
A 1965 Chevrolet 283 engine wire diagram can be obtained from most Chevrolet dealerships. Many auto-parts stores will have the wiring diagram.
What is the engine oil capacity for a 1964 Chevrolet 292 6 cylinder engine?
5 Qts. with filter (check after adding 4)
How is a Chevy 301 made.I have read somewhere it is a destroked 327 but what specs?
4" bore, 3" stroke
My 301:
High-nickel content 283 (1963 Impala) block bored to 4"
283 crank (3" stroke)
302 dome-top pistons and "pink" rods
291 Camel-hump heads (unported)
Pretty much 302 parts with a 283 crank/block
What s the horsepower rating on a stock 454?
The stock Chevrolet 454 was originally rated at about 250 horsepower. This varies greatly depending on the model and year of the motor.
Does distributor go clockwise or counterclockwise on a 1991 Chevy?
ive got a 87 gmc it runs clockwise
How do you locate 1 cylinder on 1993 Chevy 4.3 vortex?
Looking at the front of the engine driver's side front to rear 1-3-5. Passenger side front to rear 2-4-6. Firing order 1-6-5-4-3-2 Rotor turns Clockwise. Remove all spark plugs and remove the distributor cap. Turn the engine over until you feel compression on the #1 spark plug hole. You can place your thumb over the hole or a compression gage. When you start to feel compression, stop and place a long screwdriver in the hole and touch the top of cylinder 1. Now slowly turn the engine over by hand until the cylinder reaches TDC. The rotor will now be pointing at the #1 point on the distributor cap.
What are the values for GM vats?
There are 15 different values: Value: Ohms 02 - 0.523 03 - 0.681 04 - 0.887 05 - 1.130 06 - 1.470 07 - 1.870 08 - 2.370 09 - 3.010 10 - 3.740 11 - 4.750 12 - 6.040 13 - 7.500 14 - 9.530 15 - 11.801 It could be any of those. If you're trying to bypass it doesn't have to be exact but it does need to be close. To make the correct value of resistor, get resistors of different values and add them up. Solder them in-line to each other. If you don't know the correct value start at the bottom and work your way up. There's a 4 minute wait between trys and the ignition needs to go to the OFF position before you start the wait.
Where is the engine coolant drain plug on a 1998 Chevy 4.3 L. V-6?
Most blocks of the same displacement are the same even in different years of manufacture, so this may answer your question: On my 1991 Sierra pickup with a 4.3 v6, the passenger side drain plug is between the starter and the engine mount just above the oil pan rail; the driver's side drain plug is between the oil filter and the engine mount just above the oil pan rail [directly across from the other drain plug] the knock sensor is the drain plug here.
Why would a 454 Chevy engine backfire through the exhaust after new plugs and wires were installed?
You have connected the plug wires wrong. Firing order is 1-8-4-3-6-5-7-2 Distributor rotates Clockwise, # 1 cylinder is located on driver's side front of engine.
Where is the oil plug on the oil pan on a 1993 Chevy 1500?
Near the rear of the pan. It is there, you need to look more closely.
If a thermostat remains open will this cause your car to overheat?
A stuck open thermostat will cause a car to run cooler than needed. It will cause oil to sludge, a loss of gas mileage due to running rich and numerous other problems.
Your 96 Chevy Taheo has single exhaust Will gas mileage increase by converting to dual exhaust?
depending on your driving, it could increase up to 4 or 5 mpg. But gas mileage will be determined by driving style.
How do you set ignition timing for a Chevy 400 small block engine?
Try it at 12 degrees BTDC. If there is no noticeable pinging, advance two degrees at a time until you notice pinging and then back off 2 degrees. With good fuel, you could get up to 16 degrees or so without problems.
What is the spark plug gap for a 1994 Chevy 5.7?
The recommended spark plug gap for a 1994 Chevy 5.7L Pickup is .035" The recommended spark plug gap for a 1994 Chevy 5.7L Pickup is .035"
How do you disable the driver side airbag on a 1997 Chevrolet 1500 pickup?
It is illegal to disable an air bag without written permission from the NHTSA.
Why is my 1993 Chevrolet pickup radio lighting up but won't play and controls do not work?
This is a common problem in Chevrolet pickups. You will have to buy another radio or possibly have that one repaired.
Where is the cam position sensor on a 2000 Chevy 1500 4.3 liter v-6?
I do believe it is on the bottom of the timing chain cover.
Intake air temperature sensor location on a 1994 Chevy 454 big block?
The 1994 Chevy 454 cubic inch big block engine temperature sensor is located on the front of the engine. The engine temperature sensor will be a few inches above the thermostat housing.
