0
Chevy Camaro
This category covers general questions about the Chevrolet Camaro, a pony car manufactured by General Motors and sold through its Chevrolet division. The Camaro was designed to compete with the Ford Mustang. Production of the model began in 1966.
4,208 Questions
What is the curb weight of the 2011 Chevrolet Camaro?
The curb weight of the 2011 Chevrolet Camaro is 3780 lbs..
What is the normal RPM for a 1994 Chevrolet Camaro 3.4 automatic at 70 mph?
depending on tire size, around 2100-2200 rpm
What transmission would be a good street strip trany for a 1994 camaro Z28?
a powerglide is great for the strip but a 4l60e is great all around. The powerglide is better for the strip but will give you bad gas mileage.
What year did they start making the camaro?
1967 was the first model year. So the answer to the question is 1966.
The source of the water is probably from faulty or failed window seals surrounding your front & rear windsheilds.
Why is your 97 camaro v6 running hot?
Could be a number of reasons - you may be low on coolant, you may have a defective cooling system, or you may have a blown head gasket (or all of the above).
What is a 1987 RS Camaro worth?
As usual it depends on the overall condition, mileage, options, etc...
Where is the turn signal flasher located on a 1999 Corvette?
== == It's in the AC vent above the radio
The Chevy Camaro was made as a response to the popular Ford Mustang. Like the Mustang, it has remained a popular sporty model which is still produced nearly 50 years after its inception.
Oil leak between the motor and transmission?
If it is red fluid leaking, then you have a transmission leak.
If it is oil then the rear main oil seal is leaking on the back of the engine.
You need to look at the top back part of the engine to make sure the back of the intake is not leaking oil, check back corners of the valve covers for leaks too.
Need to make sure the oil sending unit that is back beside the distributor is not leaking oil. Ruel these things out before you tackle the rear main oil seal.
Where will you locate the oil pressure sending unit on a 1995 Chevrolet Camaro 3.4L V6?
Your oil pressure sending unit should be located above the oil filter, on the housing the oil filter screws up to.
How can you bypass the key pass your chip came out of your key?
Simplest is to get another good key.
If that is not available then you need to modify the wiring harness to bypass the chip reader by inserting the resistor elsewhere in the circuit.
No, I wouldn't think so. I have a question, though? Why are you changing the pan gasket?
How do you reset computer on 94 camaro 5.7?
most of the time all you have to do is pull the terminal wires off of the battery for a couple minutes then put them back on.
Change oil pan gasket 98 olds intrigue?
Do you mean "how to change the oil pan gasket?", or "should I change the oil pan gasket?". I assume you have a leak around the pan and need to change the gasket. If so, be sure that it is indeed a gasket leak by cleaning off the engine and pan and checking it again after an hour of driving. The 3.5L are notorious for using oil (about 1 qt every 1000 mi is considered average). Don't just assume this oil is leaking out.
To change the gasket is a lot of labor but is fairly straightforward. Drain the oil, remove the dozen or so bolts from the pan, and pry it off being as careful as possible to not gouge the block or bend the pan lip. Remove the old gasket with a scraper, again being careful to not scratch up the block or the pan. Install a new gasket (they come in a kit with the proper sealant, I believe (never done an Olds myself)). Bolt it back on and retorque the bolts to the level and in the order specified in the kit. The pan on the 3.5L includes the oil filter carrier, which may need replacement if it is worn. These can leak as well.
