answersLogoWhite

0

Chrysler Pacifica

Includes information and repair questions about Chrysler Pacifica model cars

645 Questions

What do you use to glue down the dash panes on the 2004 Chrysler pacifica?

Windshield urethane, and you must stretch the dash as far as you can. Use Duct tape to hold it in place until it dries.

Good luck.

How do you replace the front wheel bearing on a 2005 Chrysler pacifica?

I have an 04, but imagine it would be similar: take off your wheel, remove the axle cotter pin and nut cover. You'll need a 32mm socket to remove the axle nut (be prepared to have either an air hammer or heat source to do this...there is a LOT of ft lb torque on that nut). Disconnect the ABS sensor lead, located in the wheel well behind the plastic fascia toward the fender. Remove the brake caliper unit. There are two retaining bolts that allow you to remove it without too much disassembly. You will need a 15mm box end socket to remove the four retaining bolts of the bearing unit. You will NOT be able to get a socket on all the bolt heads due to the close proximity to the axle bell. There's a lot of aluminum parts, so don't go crazy banging anything. The box end wrench should give you enough grip to remove it with assertive pressure. Replace in reverse order.

Where is 06 pacifica liftgate chime located?

Underneath the chrome trim above the license plate. Remove the 4 or 5 screws that hold the trim in place and the chime will be the round speaker attached next to the license plate light.

Where is the transmission dipstick on a 2007 Chrysler pacifica?

Right side of the engine, next to the battery department. It has a little cap, can't change it yourself have to take it to the dealer to have it changed...

How do you replace a low beam bulb on a 2006 Chrysler Pacifica?

You have to unbolt the headlight completely. once u do then the bulb holder can be pulled from the back and the bulb taken out.. FYI it isn't as easy as it sounds... the clipps holding in the headlight are a pain.. BTW bulb is about $15!!

How much should replacing brake rotors cost on a Chrysler Pacifica?

Replacing brake rotors on a Chrysler Pacifica will vary in price depend on the labor cost. The price should be around $150 dollars.

How do you retrain the tire pressure sensor on a 2004 Chrysler Pacifica?

You will require a "magnetic doughnut" from your local dealership. It goes over the tire stem, then you retrain the pressure sensors though the computer prompts.

How to adjust headlights in a 2005 Chrysler Pacifica?

Open the hood and on the metal frame right above the headlight you want to adjust you will see a hole that when you look into it, there is asmall adjustment hex nut. Not sure what size but I used a deep 1/4" drive socket with a screwdriver handle and it worked fine. I parked the vehicle close to my garage door at night and obviously with the headlights on I turned the nut until it was adjusted to the same height as the other headlight. Clockwise the light lowers and counter clockwise it goes up. If you drive around and other drivers flash their highbeams than you didn't adjust it right.

How do you remove brake rotor on 2004 Chrysler pacifica?

chanching rotors on a pacifica is simple pull out the cotter pin in the middle and the rotor should come right off

How to change the air filter on a 2006 Chrysler Pacifica?

standing on passengerside of truck..near the middle theres a medium black case..to unhook theres two or three screws it the front of the case..front meaning away from you...then you must push on the case from the side nearest you to unsnap the case..raise top of case and remove filter

How do you get your 2005 chryslers gas pedal to stop sticking?

Clean out the throttle body, you can do it yourself in about 15 minutes. Take air cleaner off, spray throttle body cleaner in, whip out with clean cloth around the edges and your ready to go. I had to pay a dealer 150 bucks to do this and when I did it myself I was ashamed that I payed anyone to do it. Just bought another one, I have a 2005 and 2006.

My 2005 chrysler pacifica went dead and wont crank?

If your 2005 Chryler Pacifica went dead and won't turn over, you should check the battery and other parts of the charging system such as the alternator and starter.
Try giving a jump start to your 2005 Chrysler Pacifica to see if it will accept a charge.

Where is the Low pressure air-conditioning service port on a 2005 Chrysler Pacifica?

if looking at engine from front, locate highside (black cap) port and go couple inches to the right and way back under (or close to) the fire wall. Very hard to get a charging hose in there.

2005 Chrysler pacifica radio no sound fuses ok?

fuses appear ok. Still no sound, radio, CD player, DVD player appear to be working

How do you reset my engine light on 2005 Chrysler pacifica?

I use a scan tool after repairing the failure that set the code.