Chrysler

use type F automatic transmission fluid, internals for torqueflites are same as c-4 or c-6 ford transmissions

While i do not know the answer to your question, i can say if you have a chrysler air handler it is definitely advised to get it replaced. They stopped being made around 40 years ago, and parts are no longer sold for them from the manufacturer.

Chrysler does not use cut off or inertia switches.

You are overloading the factory speakers.

18009921997

Turn it counterclockwise on the vast majority of automobiles. There were some cars in the early days that did have lug nuts that had left handed threads on the left side of the car, but not today. An impact wrench will make quick work of removing lug nuts. Do not use a impact wrench to install the lug nuts. Use a torque wrench and tighten them to the exact specifications listed in your owner's manual. Otherwise you will warp the rotors.

Mopar atf+3 or atf+4

If equipped it is located under a removable screen at the passenger side base of the windshield.

If the key is gray or has built in buttons, yes. If black with no buttons, no.

Belt

After several months of my car starting normally and then not starting at all randomly, I also replaced starter, battery, ignition switch, replaced all relay fuses, and was able to start the car using the positive cable to the starter, just no fuel relay kicking in. Got to the point that the fuel relay would die, stalling the car, and then couldn't restart it. Finally had it towed to a garage and had to wait for it NOT to start again. It was determined that the computer in the Power Fuse Box was not working and needs to be replaced. I also understand that even though no one knows about this, it seems to be a rather common problem. Thing is, new parts costs over 700.00 and may not be worth putting into the vehicle, used parts may be cheaper but who knows if this was an issue with the car that the part came from. All in all, investigate the power fuse box, this may be the issue. Good luck!

change impeller or check for blocks in water lines

Usually the gauge in on the dashboard with all the other gauges. That way you can read it while driving.

It has 77 floors

It has a belt.

It would be a good idea to find a 4 speed Crossfire and trade in your car.

Under the hood there should be a Vehicle Emission Control Information (VECI) Decal which is a chart of the emissions system. It should tell you where the evap canister is.

If it's missing, a dealership should be able to direct you where to purchase one.

Or, you can always go to a licensed state inspection location and ask them.

USA, Canada, Mexico.

This can be a broken belt in a tire, low tire pressure, or defective wheel bearing. Jack up the rear and rotate the wheels listening for any noise. Inspect the tire for uneven wear or anything out of the ordinary. Look for bulges in the sidewall, I would suspect you have a tire problem.

i believe that because it's a big block mopar, the firing order should be 1-8-4-3-6-5-7-2

They were known as the Big 3. But after Chrysler was sold to Daimler, the term fell into disuse.

Yes, Dodge is a part of the Chrysler corporation

The body computer and engine computer both control theft alarm functions. It is not an individual module.

Yes, it is a safe game to download. If your anti-virus says it has a virus, you can be sure it's safe if you downloaded it from the official website.

If you aren't sure, don't do it and contact support.