Where is the starter motor on a citroen xsara?
Under the airfilterbox. there is only one screw holding it place together with the lid.
The screw are on the front of the airintakehose. ondo that, take of the lid, and with a little fiddeling it will come out. The startermotor are facing the gearbox and the connections are at the back of it, but it can be seen clearly from the top.
my remote central locking as just stoped working any ideas batt on key fob is new
locked car up at night next morning just wont open got to use key
underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on
How do you change the air filter on a 1.6hdi 110 HP Citroen Picasso?
The air filter is the black box at the back of the engine. You will see the turbo intake pipe that comes from the airbox lid to the turbo. Undo the jubilee clip at the turbo and remove the pipe, then pull out the rocker cover breather. Now that these are free remove the 2 Allen bolts from the front edge of the airbox and the other bolt at the right hand side. The lid should now lift off the box. You can now remove the old filter and replace with the new filter. To replace the airbox lid feed tongues into rear wall of airbox body and then close lid. Now reinsert Allen bolts and reconnect rocker cover breather and turbo pipe.
How do you stop the 'warning inactive overspeed' flashing up on the citroen Picasso display?
press the end of the wiper stalk in
Where is blower fuse in 2001 citroen Picasso?
Depends on the exact model, but in my 2001 Pic 2.0HDi it is number 40 in the fusebox in the fascia on the driver's side. No. 40 is the very top left, and if I recall correctly it is the only 40A fuse in the box.
How do I remove the rear light cover on Citroen Xsara Picasso 04?
Open the boot.
Look behind the brake light in the interior, you will see a section of boot lining about 5cm square that can fold open. Open this towards you.
You will see a square of grey foam, pull that out.
Now you can see the wires going into the back of the light, shine a torch downwards in here and you will see a shiny metal clip that latches the light (red plastic) into a square metal
hole of the car body. Using a screwdriver lever this clip up and outwards.
This will release the bottom of the light. From outside the car pull the light cluster down and away from the vehicle to release the top clip. Disconnect the wiring plug from the lights and unclip the bulb board from the light cluster to access the bulbs. Once the light is reassembled just push it back into the hole making sure it is lined up properly to refit.
How do you change the clock time on a c4 Picasso?
To change the clock time on a Citroën C4 Picasso, first turn on the ignition. Then, press the "Menu" button on the dashboard to access the settings. Navigate to the "Date & Time" option using the control buttons, and adjust the time using the appropriate buttons or knobs. Once you've set the correct time, confirm your selection to save the changes.
How do you Change a headlight on a citroen xsara?
I have just replaced the nearside headlamp in my Xsara Picasso (2001) and after some headscratching I did it so I feel quite pleased. So much so I thought I'd pop down a few words here.
First gently pull out the electrical connector gripping the square plastic body not the wires (!). Might need a wiggle.
Next carefully prise up the robber boot cover thingy - get your fingernails under the edge of it and it should pull away. Pull it off the back of the bulb as well so it is entirely free and put it somewhere safe.
Next, the tricky bit, getting the old lamp out. I fiddled about with fingers of both hands to no avail. So I got a screwdriver and pushed down with the blade carefully on the bare wire that hooks under the fitting. A little pressure will cause it to depress and pop out and away. You hinge it up clear of the back of the lamp and then retrieve the lamp. Keep the wire bit out of the way.
Carefully unbox the new lamp - DO NOT TOUCH THE GLASS - hold by the metal end and pop it into the gap in the headlamp housing keeping the glass bulb clear of the sides etc. Wiggle/rotate it into place.
That done bring over the bare wire clip thingy and firmly push down and it should ping into place locking the bulb in place.
Put the rubber boot thing back on. Then firmly but carefully push in the electrical connector - this may need some aligning.
Before you close the bonnet switch on the headlights to check you have done it right!
Check the oil and water levels while you're at it!
Close bonnet, lock car and go back in the house and boast to your family what a clever chap you are not letting on you read how to do it on the web!
Maybe someone will post a video on YT on how to do this....
How do you replace the windscreen washer pump on an R reg Citroen Xsara Estate?
If its the same as the Picasso you will find the pump on the drivers side front wheel. you need to remove the wheel and liner to get access. after that it self evident.
Where is your fuel cut off switch on your 1997 citroen xsara diesel?
Stand in front of the engine.
It's placed back a little left of the middel app. 2/3's back
How do you change a light on dashboard display on citroen Picasso?
Easy,(IGNITION MUST BE OFF THROUGH OUT ALL STAGES)
Simply put a small flat screw in each corner of the display cover and gently pull it away then I belive its a 20-25 torxs to release each corner.After this just disconnect the left terminal and turn it around towards you, with small long nosed pliers turn and release each bulb holder when I did mine i changed every bulb as there cheap enough (10 at least),Also check and clean all the top bulbs are not blown, belive if a jobs worth doing do it once.
I then reconnected the terminal and put the ignition on before putting back together,just to check it worked.
Repeat the process but in reverse to put back together.
Jobs a good one hope it helps..................
How do you remove glove box on citreon xsara?
There is 8 hexscrews situated inside at the edge all the way around the glovebox. Undo theese and then gently pull out the gloveboxlight. then it will just slide out as a complete unit.