Computer Networking

Crossover cable

It's very hard to tell because both have shields. Last version of STP must be better than coaxial.

There is no single protocol used between a server and a client; the protocol depends on what the server and client are doing and how they are currently communicating.

The most common computer in the 1960's was the ENIAC, it took up 680 square feet.

Yes, there are.

because internet that comes down a telephone line are analogue signals and the computer on understands digital signals ( 1 and 0s , Machine code, binary) so the modem translates the analogue signals from the phone line to digital and translates digital signals from the computer to analogue

In order to begin the handshake process, the client sends a SYN packet to the server. This is required to establish a synchronization with the server in order to ensure that both the client and the server will maintain and keep their exchange of packets in the right order. In order to complete the "handshake," the reponse from the server will be an ACK packet.

Turn the knob on top of the camera next to the button to take the picture, turn it three times until the light goes from red to green and then touch the picture button to take the picture! Your welcome!

You can use an adapter from any brand, you do not have to get from Dlink.

http://www.computercablestore.com/images/products/No%20Manufacturer/0-RG6.jpg

Or, for a creative commons image which you can use freely, then look here:
http://commons.wikimedia.org/wiki/File:Coaxial_cable_cutaway.svg

two types of exchange server:-

exchange server standerd

exchange server enterprise

An SSH client is often used for sending data over a secure connection between two networked computers. The best-known use for the SSH protocol is to access shell accounts.

Network traffic management is an information technology term used to describe the management of the usage on a computer network and is routinely implemented to keep speeds high by controlling what a person can and can't access.

Research has shown that crossover ethernet cables are widely available. One can purchase these cables at stores such as Best Buy, Radio Shack and Tiger Direct. One will also find these available online on site such as Amazon and eBay.

Router access list is the list of condition that categorize packet and also filter unwanted packets.

And at 1 interface per direction, per protocol there should be only 1 ACL.

ACL list are of two types

Standard and Extended

In Number standard ACL range is 1-99, 1300-1999.

In Number standard ACL range is 100-199, 2000-2699.

A "Mainframe" computer is usually a term for a large server. Using that as a central are for running processes. But what you are asking is complex. The technical answer is yes.

Static IP always remains the same if you shut the computer down and restart. The floating IP (or the one assigned by DHCP), changes sometimes on a daily or hourly basis, mostly depending on if you shut your computer down and restart it. During the time your computer is (offline), the DHCP server can assign that former IP to a unit that was just booted up. In that case you would be assigned a new IP when you booted up.

switch(config)#int type <no>

switch(config-if)#switchport mode trunk

switch(config-if)#switchport trunk allowed vlan all/vlan no

switch(config-if)#exit

switch(config)#exit

switch#

This will happen for several reasons, the most likely is the cable is plugged into the network card at the computer, but not at the switch or hub. It could also be that the port on the switch the cable is plugged into is disabled, or broken, network card could also be broken.

Token ring is a loacal area network technology. It is limited in ldistance by its physical layer connection requirements.

Yes, ofcourse

no

They probably would implement both depending on the clientelle. For large customers, dynamic addressing seems the best option.

using showmount -e "nfs server name" command , can check status of nfs server.