Construction Tools

The trigger of a pneumatic nail gun has nothing to do with the pressure. The pressure exerted is generated by the compressor and then the impact hammer inside the cylinder of the nail gun. If you are having a no firing or misfiring problem the 'o' ring around the piston is possibly broken or dry . -Have you been regularly using air tool oil, - NOT oiling is the commonest reason for this failure.

You use a 0.875 bit or a 7/8 bit . They are the same size.

You would have to call a store that sells them for that information. A lot depends on who or what level of customer you are.

Locking pliers are used mainly in aircraft maintenance, and mostly in the military. Many nuts that may be subject to loosening under vibration have small holes drilled in 3 places on the outer edge. A thin stainless steel wire is threaded through one of these holes when the nut is torqued up, and then the ends of the wire are gripped in the locking pliers and twisted till they reach an anchoring point nearby, threaded through it,and gripped and twisted again. In this way the nut can be held immobile.

Yes it will. Not enough oil to lube it will ruin the bearings, then your motor is junk .

A mobilization advance is an amount of upfront money paid by the client to the contractor. This reduces the amount of working capital the contractor needs to come up with to start the job.

Two part

Combined

Supplementing

Directive

Mass

In my area this is called a kiln.

Yes, you can drill Lucite. Keep to a fairly low speed so as not to melt it (below 500 rpm.)

A saw is not a wedge, it's a cutting tool.

Depending how strongly they must be fixed I would use plastic or alloy EZE-anchors.

A caisson is what you make to keep water away while you construct a column in a river or lake.

You may mean TENON saw. This is a short broad saw with small teeth and a stiffener plate on top of the blade

Explain "Aframe" -if you mean an A-Frame shelter to work on the septic field, that's permissible. If you are loosely referring to an A- Frame dwelling that's absolutely NOT allowed in any civilised country.

It solves the problem through practical means, therefore it takes a much shorter time than emotion focused coping.

Hope this helps! =]

It is a masonry bond with all courses laid as stretchers and with the vertical joint of one course falling midway between the joints of the courses above and below. It makes the wall stronger and more decorative

It is a light carpenters hammer.

A finish hammer is a lightweight hammer (usually 12 to 16 oz) intended to dent the wood less (or hopefully not at all) if the nail head is missed during striking.

Yes, a wrench is easy to use.

"Although it may not be made specifically with the small handed in mind, the general consensus is that Makita drills are ideal for smaller hands. Many with small hands use the Makita drills with ease."

If they are self tapping screws, the drill bit is as thick as the solid barrel of the screw. If you want the screw to go through easily to have a nut on the other side, then the drill bit is slightly larger than thread size.

That is ten tons, so I know the answer can't be 'who', but 'what'. Many large construction machines or fork trucks could carry this.

I've never seen one in many years of working with all kinds of tools - a screwdriver is JUST that.

Yes, just different brands. Often cheaper and more 'homeowner use' rather than professional quality.