Construction Tools

A hammer with different faces like flat, hemispherical, broad or otherwise differently shaped, but not with a claw.

Use 7/64 as tap drill and 9/64 as clearance drill

It is the thin line a saw cuts in material.

I will must believe the brick would crumble before that happened.

Yes it does.

Home Depot, Lowes, Henrys Hardware, True Value, Ebay, Craiglist

A Pad foundation is just a concrete slab with no foundation walls. They are typically used in the South where this is no or minimal frost lines.

You use a standard HSS drill bit.

Most power drills are now VSR. (Variable Speed, Reversible)

when you add your rise and your run the two numbers have to equal between 15-17 inches. Typically there are 13.

Might be an idea to tell us the SIZE of the basement to start with.

It's a band saw where the blade is horizontal, not vertical like most band saws have it. These are fairly specialized tools.

There are two different kinds of these.

The first is the metal-cutting horizontal band saw. The saw is attached to a stand by a pivot, so you can cut with it like you would a chopsaw. These are used when cutting nonsparking metals (basically anything except ferrous metals), which shouldn't be cut with an abrasive wheel because the metal dust will clog the wheel, or when you're cutting in an environment where sparks would be dangerous.

The second is the wood-cutting horizontal band saw. These are also called portable sawmills. You use them when you're cutting boards out of a log.

Thick vinyl pond liner.

what is center line plan construction

Since sheet rock is already manufactured, there is nothing to "put in" it. To soundproof on interior walls the best solution is to add insulation between the stud walls--usually rolled insulation works best, is relatively cheap and will not shrink the room size.

No, a wrench is a wrench

Because sometimes you need to pound things, and that's not good to do with a wrench or screwdriver.

The spindle moves up and down and carries the shaft of the drill inside it. As the drill turns inside the spindle, the spindle can be lowered, bringing the drill bit into contact with the work.

Pliers are used to secure the opening of the stem of the pipet to ensure a tight seal and prevent any leakage of liquids during transfer. This is particularly important when working with volatile or hazardous substances, as it minimizes the risk of contamination or spills. Additionally, using pliers helps maintain consistent pressure on the pipet, allowing for accurate and controlled dispensing of liquids.

When the vertical circle of the theodolite is to the left of observer, it is in face left position. Similarly when the vertical circle is to the right of observer it is in face right position.

A theodolite is a survey instrument. A tachometer tells you how many Revs per minute an engine is turning.

None really, you just have to extra careful working near finished surfaces.

I'm sure it's worth a lot to you, but nobody cares about good quality tools any more. There is so much cheap junk on the market, people now would rather buy something cheap and gaudy than a quality made tool.