Construction Tools

A phillips screwdriver is generally made of a steel shaft with a plastic handle

There really isn't just a 'tension saw', its more a group name. my closest answer would be either a hacksaw for cutting metal or plastic and a coping saw which is for cutting wood.

A phillips screwdriver helps you by getting more grip on a screw than a flat blade can.

The purpose of a standard screwdriver is to turn screws so they go into or come out of the work.

The standard screwdriver is designed to turn screws in or out.

This means the telescope component brings things visually 30 times closer. Many theodolites used by various government agencies used to be pro-rated at 25X more than adequate for most tasks including trackint weather balloons- this being called a Pibal ( Pilot-Balloon) theodolite. the term pilot is somewhat misleading, as it is not a manned and controlled ( hence piloted) vehicle but an unmanned balloon that, of course follows the wind currents aloft- and moves at the same rate and direction! These instruments, while rivalled by more modern gadgetry- are still used by the Weather bureau and particularily at airports and similar sites where wind functions are important to safe operation of aircraft. I understand some modern Theodolites are l00X ( for building surveying work)- but this might be a misunderstanding with the standard Focus of l00 feet- like the various fixed focusing stops on a camera. all theodolites have adjustable focusing, in part to adapt the instrument to different lightint conditions brought about by- you guessed it, the weather ( more sophisticated one might say diminution of light caused by atmospheric refraction, switch up the lens power!

Metabo power tools are made in Germany and USA.

The hammer can hammer nails in, it can pull those nails out, it can be used delicately to 'adjust' things that don't quite fit. Some hammers can fix dents in auto body work, other big hammers can pound stakes into the ground.

The Stihl company, Headquartered in Germany makes all Stihl tools,including chainsaws.

It means the blade can be tipped in two directions. Either left or right. A single bevel saw can only lean the blade in one direction. You can do the same cuts with a single bevel saw, but a dual bevel can save time and can make some cuts easier.

20 degree

The uses of these files are generally to make wood smoother. This works on many other thing such as laminate counter tops, where fine files are used to smooth edges and on many plastics where they smooth out saw marks.

A road drill.

40 ml only of 46 grade hyd oil. note - 40 ml only.

That's just a tiny bit less than one inch.

Nope: they are levers.

57rc

First of all, the drill bit is not considered a lever.

The drill bit is, however, considered a ramp or inclined plane.

Yes, they break and get blunt all the time.

A Kerf.

The motor on a pillar drill is usually under the back of the belt casing.

For cutting very thin woods such as for marquetry or puzzles.

Fiberglass Insulation, R Value of 3.14. Pine board has an R Value of 1.74

it is a drill bit usually with a square male tip that inserts into a female square screw head-- many of these square head screws are used for building cabinetry-- it is basically a carpenters or builders choice of use but not mandatory for building.

You put the material you are sawing in the vice.