answersLogoWhite

0

Datsun

Datsun was an automobile brand created in 1932 by the DAT Motorcar Co. for a new car model. The brand was phased out in 1986. The Datsun name is best known for the sports cars called Fairlady roadsters and Fairlady (240Z) coupes.

606 Questions

Where can you get a Datsun 1200 Ute for a good price?

One can purchase a Datsun 1200 UTE for a good price in online stores such as Carpoint, Carsales and eBay. It is also available on Gum Tree and Australia Trovit.

Will a 1982 280zx tranny fit in a 1981 280zx?

Yes it will. Also if you have the 5-speed (borg-warner t-5), you can also use one out of an 80s Camero or foxbody Mustang.

What causes a ignition coil to blow?

Improperly installing the connections in correct position. Moisture connstant on and around the coil plug cap . if the plug wire cap is worn out and their is sufficient moisture, it will create a short in the electrical spark detonating from the coil, thus causing the coil to basically burn itself out over a period of time. Best to check your plug wires for cracks, tears, and damage when changing the engine oil.

What does the name Nissan mean?

Nissan means beautiful , loyal , intelligent , and fun !

Where is the hood release on a Nissan Datsun?

you should be more specific as to the model of the car but for almost all of the z and zx models its to the left under the steering whell, the hood pops up near the windshield, it opens forward

Where is the spare tire on a 1982 Datsun 280zx?

It should be located behind the right side panel of the trunk, along with a jack

How do you remove a mirror from a 1977 280Z?

easiest way is to cut it off with a saws-all or hack saw- i did mine with a saws-all, just cut through the neck holding the mirror on, mirror falls free, and can easily grab the bolt that falls on the inside of the door-

What causes a car to idle high and fast?

vacuum leak or accelerator cable and or linkage sticking.

**ALSO...the electronic choke. When the engine has warmed up enough, there should

be 12V on the wire leading to the choke from the small relay located on the left

fender wall on the late 70s and early 80s. It may be hidden inside a black metal box.

I have an 80 210SL Hatchbck**

Where can you find a vacuum diagram for a 1974 Datsun 260 z?

If it wasn't so old I'd say inside the engine compartment, but that is probably long gone by now.

You should get a manual for your car, it will have that and much more.

How many miles can you get out of a 1978 280zx?

as many as you want with proper care. with not changing the oil or adding any kind of treatment, around 150,000

Where could one purchase a Datsun 120Y?

A Datsun 120Y can be purchased from a variety of outlets. The lowest prices can be found on the eBay Motors website but they are also offered on Auto Trader and owner forums.

Firing order for distributor cap of 1974 Datsun?

More information is needed. Which 1974 datsun, and which motor? The make, and model of the car, as well as the numbers of cylinders are needed, total displacement of the engine would also be helpful.

The datsun pickup across that year, the datsun 240/260 series cars, and several others had substantially different engines and distributors.

How do you bleed clutch on 1977 Datsun 280Z?

How do you clutch bleed?

One person in the cab to work the clutch pedal.

One person underneath the car, rt side of transmission, with small hose on bleed nipple - other end into brake fluid bottle, and box wrench on the nipple.

Ck reservoir for fluid. Don't do more than 4 cycles without refilling the reservoir. Go more -- you're pumping air...

Can't get the nipple open? Unbolt the whole thing - called a the slave cylinder - and replace it. They are 20$ at Advance or Autozone...

Procedure:

Person in cab presses on clutch pedal to floor. Open bleed nipple and allow any fluid that comes out to flow into the open brake fluid container.

Tighten bleed nipple, tell person in cab to release pedal.

Repeat process until only fluid comes out on each pedal press with no air bubbles...

Pedal should now have pressure and work the clutch correctly...

What is the MPG of an 83 Datsun 280zx?

around 18-20 mpg, but that was brand new so 30's later it could have changed quite a bit

How much does a 1972 Datsun 620 pickup truck weigh?

depends how heavy the driver and cargo is www.thankgodi.com

Where is the fuel pump located on 1978 Datsun 280 Z?

The fuel pump is located on the undercarriage of the car. It will have four 12 mm bolts holding it in place on a steel plate.

How many miles per gallon should a 1980 Datsun 280zx 2 2 get?

My 1980 280ZX GL model still gets 25mpg after 250,000 miles. A tank of gas (20 gallons) should get you 500 miles. It's a manual 5-speed transmission.

Where can you get a vacuum diagram for a 1983 Nissan 280zx?

Shop manuals are the best place to find the diagrams but there is also a vacuum diagram sticker stuck to the lower right of the inside of your hood.

What is the engine size for a 1979 Datsun king cab pick up truck?

The stock engine displacement was 2 liters, rounded up from the actual 1,951 cu cm. (or was it 1,952?)

Why would a Datsun 280Z stall then die while driving?

Answerive had a few 260 z 2+2 and c210 skylines with the L series engines in them and a few times i have driven down the road and they have died on me at any speed here is a small check list of things to check, points,gap,plugs,timing and carby settings all play a crucial roll and lets not forget altenator, compression and valve clearances,head gasket just to name a few the L series motors can be tricky to work out but when you go over them a few times you will be able to fix it each time and you will be happy for doing it your self i say buy a book on the L series 6 and you can fix it with ease.

**********

There were no 280z's with points or carbs. A more likely culprit would be a bad ground or clogged fuel filter.

**********

If the car shuts off like you turned the key off, it maybe an electrical problem. Cleaning the fusible link connections (make them shine with Brasso) sometimes fixes this issue.

**********usually its the hall effect switch or ignition module