0
Dodge Caliber
Introduced in 2006 (for the 2007 model year), the compact Dodge Caliber replaced the Dodge Neon. During the summer of 2012, the Caliber will be replaced by the 2013 Dodge Dart. Questions about the Dodge Caliber can be asked here.
433 Questions
What causes a loud clunking noise coming from the back tire of a 2008 Dodge Caliber?
A loud clunking noise from the back tire of a 2008 Dodge Caliber could be caused by several issues, including a worn or damaged suspension component, such as a shock absorber or strut. It may also indicate a problem with the wheel bearings, loose or damaged brake components, or an issue with the rear axle. Additionally, a foreign object lodged in the tire or wheel well might create a clunking sound. It's advisable to have a mechanic inspect the vehicle to diagnose and address the issue.
How do you service 07 Dodge Caliber brake calipers?
To service the brake calipers on a 2007 Dodge Caliber, start by safely lifting the vehicle and removing the wheel to access the caliper. Inspect the caliper for any leaks or damage, and if necessary, remove it by unbolting it from the bracket. Clean the caliper, replace any worn or damaged seals, and ensure the brake pads are in good condition before reassembling it. Finally, bleed the brake lines to remove any air and check the fluid level in the master cylinder.
2007 Dodge Caliber wheel speed sensor where is it located and how you replace it?
The wheel speed sensor on a 2007 Dodge Caliber is typically located at each wheel hub, mounted on or near the brake assembly. To replace it, first lift the vehicle and remove the wheel for access. Disconnect the sensor's electrical connector, remove the retaining bolt, and pull the sensor out of its housing. Install the new sensor by reversing the steps, ensuring it’s securely fastened and reconnected.
Where is the headlight fuse for your dodge caliber?
The headlight fuse for a Dodge Caliber is typically located in the fuse box under the hood. To find it, open the hood and look for the fuse box, which is usually near the battery. The fuse diagram on the cover of the fuse box will indicate the specific location of the headlight fuse. Always consult your owner’s manual for the most accurate information regarding your specific vehicle model and year.
Where is the electronic throttle control actuator on your 2010 Dodge Caliber?
The electronic throttle control actuator on a 2010 Dodge Caliber is integrated within the throttle body assembly, which is located on the intake manifold. To access it, you'll need to remove the air intake duct and any associated components to reach the throttle body. The actuator is responsible for controlling the throttle plate position based on signals from the engine control module. Ensure to disconnect the battery before servicing to avoid electrical issues.
What type oil do you put in 2006 Dodge Caliber crd manual gearbox?
For a 2006 Dodge Caliber CRD with a manual gearbox, you should use a high-quality API GL-4 or GL-5 rated gear oil. The recommended viscosity is typically 75W-85 or 75W-90. Always consult the owner's manual for specific recommendations and to ensure you are using the correct fluid for your vehicle.
Will the 17 inch rims from a Dodge Caliber fit on a Jeep Grand Cherokee?
The compatibility of 17-inch rims from a Dodge Caliber with a Jeep Grand Cherokee depends on several factors, including bolt pattern, offset, and center bore. The Dodge Caliber typically has a 5x100 bolt pattern, while most Jeep Grand Cherokees use a 5x5 bolt pattern. Therefore, the rims are unlikely to fit without significant modifications or adapters. It's best to consult compatibility guides or a professional before attempting to use them.
