Electric Windows

replace 1987 dodge pickup/power window motor

You can see the blueprint of the door on a 1997 Grand Marquis/Crown Victoria at the related link below. This will aid in the removal of the panel.

It is located on the engine.

how to repair a window motor on a 380sl mercedes

Replacing the window regulator in a 2002 Mazda Miata can be moderately challenging, especially for those with limited automotive experience. It typically requires removing the interior door panel, disconnecting electrical components, and carefully maneuvering the regulator out of the door. While it can be done with basic hand tools and some patience, having a repair manual or online guide can significantly help in navigating the process. Overall, it's a manageable task for someone with a bit of mechanical skill.

Any body shop should be able to do that for you.

i think you should probably go to O'brian or something and ask them but the same thing happened to me and over time it came back up and it all depeneds if you want to spend money on it. if you don;t want to spend money than i dont know.

sos

A complete door consist of subframe,frame,architrave and lock with door handle

Once the windows are fully down push the down button in the down position and hold it there until you hear a double click from the motor, about three seconds. Do the same in the up mode.

try taking to the car dealer they usually fix that stuff for free

To restore tension in the window spring of a 1992 Firebird passenger side window motor, you need to remove the door panel to access the motor and regulator assembly. Carefully detach the motor from the regulator to access the spring mechanism. Using a suitable tool, such as pliers, you can manually wind the spring to increase tension, ensuring it is securely reattached to the regulator. Reassemble the motor and door panel, ensuring everything is properly aligned and secured before testing the window operation.

No, you cannot usually fix or repair a power window cable. The ends of the cable are pressed on with a pressing machine. A person has to buy a whole new track and cable setup.

Depends on the vehicle and manufacturer. On GM Passlock, you have to wait about 10 minutes for the system to automatically reset before you try it with the key again.

Lintel

you could possibly have some sort of shortage

main switch is bad

If the motor is bad in your car, you 1st try to roll it up then it will roll up a tiny bit but you will have to try the window and then what bait and then try the window again. If you are planing on getting new motor, get one used not new. You will pay about $400 to $500 for new and only 2 or 3 hundred for a used. I have a Toyota Highlander that is a 2001 and the right backseat window went out and the automotive store said we could ether get it used or new and we got used and it has been the best window in the car now.

possibly check for a blown fuse , otherwise it could be a bad problem

Copied from another answer:

Because if power windows moved too fast; they might break, get jammed, or cut off someones body part. The power windows are slow, because they last longer, and are less likely to injure someone

.

Although there could be several possibilities, the most probable is that the switch has become defective/worn out. If so, that's probably due to either an original defect in materials or assembly in manufacture, OR someone may have spilled liquid on and into the switch which caused corrosion on the contacts inside the switch.

I diagnose what is wrong and repair or replace the failed components.

A switch controls electricity to an electric motor, called a regulator, A shaft in the regulator spins a cog and rail mechanism, or cable loop to raise or lower the window which is guided by rails, slots or tracks.. Many power windows cut off after a short predetermined time when excessive resistance causes raised power consumption. when the window is fully seated up/down, or an obstruction, such as a mother-in-law's head or a drunken teenager's buttock. arm, finger etc. Attaching a razor sharp blade to the top edge of the window can be a economical picnic vegetable slicer, a budget finger amputation device or even a humane and disturbingly satisfying method to dispatch stray cats with toxic and malicious spraying compulsions. and well worth the mess.... The hardest part about changing an electric regulator and track is removing the door panel without destroying an excessive number of the clippy thingys, as tend to be constructed of the most delicate plastic modern science has been able to formulate, spawning a billion dollar a year replacement clippy thingy industry. Clippy thingys are commonly available in a extreme variety of nifty sizes and shapes for under a buck each, (even the fancy ones), at most all auto parts stores... Regulator replacement in direct sunlight on a hot day, with someone chanting "You can't do that, you're gonna break it... only experts can do that..", or in time pressured conditions is not advised, and has been linked to, and may induce "Tourette's Syndrome", a condition of involuntary cursing, often accompanied by inappropriate or politically incorrect emotional outbursts, tool slinging, restraining orders, fraudalant insurance claims, as well as tragic premature vehicle abandonment. Take your time, enjoy it if possible, by reflecting on how much cash you will save taking an hour or two slowly tinkering with it! Most car door panel disassemble fairly easily, and a few minutes of relaxed analysis often yields easy success!

behind the dash, located behine the fuses on the drivers side

It's located on the fuse block.

up your mothers a%%%