Local Area Network

Yes and no. Yes, you should not connect in WLAN part other cables except internet cable. No, you have other ports which are similar to each other and it doesnt' matter which of them you are using.

it isn't

Private IP Address

Bus topology is the most popular topology. Justify.

A routable protocol contains a network address as well as a device address. Non-routable protocol, on the other hand, regulate the transfer of data and always makes use of interior routing system to transmit data.

That's called the "MAC address" or "Hardware address". It's a unique set of numbers assigned to a network device. Anything that access the internet whether phones, wireless cards, computers, etc, all have a MAC address.

The address with all one's (FF-FF-FF-FF-FF-FF) is the broadcast address. All devices on the physical segment will see and respond to a message with that destination.

ip

default-network

address

sarita also tiger also

for one machine no wire.

for 2 machines one wire.

for 3 machines two wire.

....

similarly for n machine (n-1) wires are required.

The UTP (Unshielded twisted pair) cable is preferred; it's far less expensive to install in large amounts.

1)90% of maximum dry density should be achieved on each test.

2)Frequency of tests is one test per 845 square meter.

3)You could test the 1st layer and the layer in case of multi-layers.

A switch would record multiple entries for a single switch port in its MAC address table if it does not contain the Mac address of a particular destination in the address table. It will broadcast to all ports besides the port where entry comes from.

PING : Packet Internet Groper

http://images.google.com/images?hl=en&q=typical+lan&btnG=Search+Images&gbv=2

It all depends on this geographical area. You could use two wireless routers. Given the distance isn't too far. 2 linksys routers with ddwrt firmware, put one both networks and that will be a good job.

If it is far, you could be looking at running a wire from one network to the next.

If neither of these are feasible you could look into VPN's.

Have you got servers...??

NOS or "Network operating systems."

WANs

There are three different types of NAT (Static, Dynamic, and Overloading). The one you're most likely talking about is static NAT. It provides a one to one mapping.

Provides values that enable different transport layer protocols to perform different functions

it can be much prettier. of course it also moves electricity away from water alway a good thing, but a properly installed 12 volt light is also very safe and much less expensive.

A fiber optic lighting rig can also provide light that is more evenly distributed through the pool and requires only one light source. Changing a burnt bulb is also much less of a hassle since the lamp is not below the water line.

Collision domains are really bad. Not only does each computer get everyone's frames, but only one PC can transmit at a time! Your total bandwidth is reduced every time you add a PC to the network. Your network will come to a screeching halt!

Peer-to-peer is one of the network communication models whereby each of the nodes involved has equal rights and capabilities to initiate a communication session. One can implement this model in a torrent network.

packets

Janell