0
Mazda 6
Known for its sprinted, insightful and stylish design, the Mazda 6 is a mid-size car manufactured by Mazda Motor Corporation since 2002. The company’s Mazda 6 2011 model is equipped with a rearview camera, 17-inch alloy wheels and new cloth seat materials.
775 Questions
hey i just had this problem and fixed it right away. this is what i did. check the fuse marked ROOM15a, at the left of the driver side, fuse box
PULL IT OUT and change it whether blown or not, should fix it
What is the routing for a serpentine belt on a 2003 Mazda 6 3.0 v6 dohc?
Serpentine belt diagran 2003 mazda 6
How can you connect your Ipod to your 2004 Mazda 6 without having to use an FM transmitter?
You CAN'T! There's other alternatives but it required some soldering of the internal parts of the stereo.
http://www.cushieaudio.com.au/mazda-ipd3.html
What does the TCM fuse of a 2004 Mazda 6 control?
The TCM fuse controls the Transmission Control Module. which control the transmission.
How can you turn on passenger airbag in mazda6?
The passenger seat has a weight sensor which automatically turns the airbag 'on' at a certain weight. If there isn't enough weight in the seat, the system determines that there is no passenger in the seat and leaves the airbag OFF.
The weight sensor can also cause the passenger airbag to deploy with less force if it determines the passenger is small and might be injured by a full-force deployment.
How do you replace the passenger side low beam on a 2004 Mazda 6?
I have had to replace the low beam bulbs on my 04 maz'6. It can be done. In your owners manual you'll find the indicator to which is the burnt out bulb, follow that wire to the connection and twist and pull, the bulb should come out. good luck, hopefully you have small hands to fit in those tight areas.
How do you change main fuse in 2006 Mazda 6?
The fuse block under the hood needs to be raised. There are four tabs around the perimeter of the block. There are 2 small bolts that hold the fuse in place. Remove the 10mm bolts then simply pull out the fuse and replace it, reinstall the bolts and place the fuse block back in place. There are sliding guides that will align the block.
What does airbag code 18 on a 2005 Mazda 6 mean?
It's a passenger airbag deactivated mines doing the same at minute
The ECT sensor is usually the Engine Coolant Temperature sensor. Most modern cars have such a sensor to advise the ECM/PCM about the operating temperature of the engine. Ford also uses a Cylinder Head Temperature sensor to detect overheating condition in the case of lost coolant..... The ETC, via the PCM, also controls the cold-start quantity of fuel required (given a specific temperature);.. in other words, it acts like a choke operation in cold weather!... I f malfubctioning, can cause prolonged cranking before engine start in cold weather.
What is the part number for a low beam on a 2009 Mazda 6?
The low-beams for my '09 mazda6 iSport are a size H7 (Halogen/Xenon) bulb. They are available at any auto store, even walmart. Costs around $13-$17 per unit, or $9-$20 (plus s&h) online at amazon.
I just got a pair, about to replace them. ;)
- R
How do you turn the speed sensitive volume control off on a Mazda 6?
Push the radio tuner knob in, it will cycle through bass, treble...etc, when you get to ACL, set it to your desired level, it is 0(ff), 1, 2, 3(max).
How do you remove the door panel off the driver side door of your Mazda 6 2006 with the door closed?
Nobody knows.. Or they wont tell you... Have to take it to the mazda dealer...
How far can you drive after the low fuel light comes on in a 2006 Mazda 6?
It is a good practice to fill up when the tank is 1/4 full and never let it get below 1/4 full. You can easily suck trash from the bottom of the tank and clog the fuel filter. A partially clogged fuel filter, overworking the pump, is a major cause of fuel pump failure. But to answer your question, I don't recommend it, but, you can easily drive 25 miles after the light comes on. Beyond that is pure speculation. It all depends on how much the reserve is on this car. Normally it will be 2 gallons.
How do you torque the camshaft?
If you do not have a manual for this vehicle, DO NOT PROCEDE! You have invaded the heart of the engine, and if you do not have a manual, you run the risk of doing damage to the engine if you put it back together wrong. YOU MUST GET THE CAMSHAFT ALIGNED WITH THE CRANKSHAFT IF THE ENGINE IS TO RUN CORRECTLY! Anytime you are reassembling a large component, with multiple screws or bolts, finger tighten all fastners until all fastners have been run down finger tight. Then, working across the component, tighten one fastner snug, then go to the diagonal fastner, and tighten it snug. FOLLOW TORQUE SPECIFICATIONS! If you are working without a torgue wrench, try to tighten all fastners as uniformly as possible. Torgue specifications are critical on many automotive parts, and it is worth buying or renting a torque wrench to get them right. Work all fastners down in steps, avoid tightening one faster all the way while others are loose or only finger tight. This can cause warpage of parts, and may prevent all fastners from being tightened properly.
Why is your Mazda 6 leaking anti-freeze?
Check radiator hose, leaking water pump, look for hole in radiator, leaking coolant bottle or leaking seals.
How many gallons does a 2006 Mazda 6 have?
The 2006 Mazda 6 has an 18 gallon tank and has has an estimated MPG of 23 city and 32 highway.
How turn off check engine light off for Mazda 6?
Unplug negative cable of battery, wait 30 sec & plug cable wite back, engine light reset ...walah!
Will,Bill,Hill,Ill etc. x
gill, Bill, kill, fill, frill, chill, pill, mill, etc..
How do you calculate how much fuel you will use?
You need to know the vehicle's average economy and have an estimate of how many miles you plan on driving.
To calculate the car's average fuel economy, you need to fill the tank and write down the vehicle's mileage and then drive it until empty (using your normal driving habits). when you fill the tank again, get the mileage and subtract the first mileage reading from that. Take that number and divide it by the number of gallons you purchased and that will tell you the car's average mileage.
*(Mileage 1- Mileage 2)/ gallons= average fuel economy*
To calculate future fuel usage, take your average economy and multiply that by the number of miles you plan on driving.
*average fuel economy X estimated miles= estimated future fuel usage*
Why did Ashoka give up fighting wars?
he gave up war seeing bloodshed got very sad and stopped fighting wars
