answersLogoWhite

0

Mazda MX-3

The MX-3 was a 4-seat hatchback manufactured by Mazda Motor Corporation from September 1991-1998. This 3-door vehicle was known for its capability to use a wide range of engines such as the KL-ZE and V6.

407 Questions

How do you change the rear running lights on a 2001 VW Beetle?

First make sure fuses are o.k.,remove trim bezel from in front of radio/dash area.Unscrew dash cluster,pull forward enough to disconnect speedo cable(or discon. from counter box under hood).Unplug enough to tilt down speedo clstr,remove bulbs.

How do you repair a speedometer on a 1993 Mazda MX-3?

We had a speedometer problem it was the key that locked the speedometer driver gear to the transmission output shaft. The key was broke had to pull the rear housing on the transmission to get to the gear. Yea you have to pull the transmission. Ez

Whats the spark plug gap setting for a 1993 Mazda mx3?

Most likely .032, but check to be certain...I have a '91 B2200 and am assuming it to be the same.

Where can you get a diagram to change a throttle position sensor in a 1992 Mazda mX3?

the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it

What motors can go in a mx-3?

withouth much modifications: <br/>see http://en.wikipedia.org/wiki/File:MX-3_engine_swap_chart.gif<br/>but if you are a good welder you can put whatever you want

Where is the fuel pressure regulator in a 1993 Mazda mx3?

The fuel pressure regulator is located on the fuel rail of the vehicle.

Where is the fuel pump on a 1992 mx-3 4 cylinder?

Under the rear seat cushion.

You should start your car and then unplug the wiring harness that you see under the rear seat cushion, the car will die after a few seconds. Then turn your key off. What this does is relieve the fuel pressure. You then can disconnect both of the fuel lines. Have a couple of plugs handy to place over the 2 ports that the lines connect too. Then remove the screws that fasten the fuel access port. You can then carefully lift it out of the tank, your fuel pump is attached to this port.

Where is the cabin filter on a 2005 Mazda 3?

http://torontomazda3.com/forum/showthread.php?t=9806&highlight=cabin+filter

How do you run diagnostics yourself on a 93 Mazda Mx3 GS 6CYL?

conect the ten pen and ground pin on the diagnostic tester with a jumper wire and turn on ignition do not start count the flashes from engine light to get the codes.