Mechanical Engineering

Its d schedule rating of pressure of pipe...

depending upon the place of operation, the following people must be informed.

Chief Inspector of Boilers

Inspector of Factories

Local Police (for the incident)

Insurance company

A person who works with a metal pin for passing through holes in two or more plates or pieces to hold them together, usually made with a head at one end, the other end being hammered into a head after insertion.

Modulus of rupture > Splitting strength > Direct tensile strength

no

If the gland steam condenser level is high, it can lead to potential issues such as reduced efficiency of the condenser system, risk of water carryover into the steam system, and possible flooding of the condenser. This can compromise the performance of the turbine and other connected equipment, leading to increased maintenance needs and operational disturbances. Additionally, high water levels can affect heat transfer efficiency and may trigger safety systems to prevent damage. Regular monitoring and control of water levels are essential to maintain optimal operation.

shear stress is defined as the component of sress co-oplanner with a material cros section.

the pressure exerted on the wall of the ventricle before being filled up.

in present scinario if u want to be stable in any organization , you need to analyze ur skills and compare with organizational requirments . u must be jack of all trades.

A projectile has no motor/rocket on it, so all of its momentum is given to it as it is launched. An example of a projectile would be pen that you throw accross a room. A rocket or missile does have a motor/rocket on it so it can accelerate itself while moving and so resist other forces such as gravity. answer

in mechanics point of view projectile dont have any particular shape it is a point mass. whereas rocket has a particular shpe and hence it has center of gravity situated at particular point on its body.Therefore rocket motion comes under kinetics and projectile comes under kinematics

One S.

Sprains and strains can be prevented by warming-up before exercising, using proper lifting techniques, wearing properly fitting shoes, and taping or bracing the joint.

Because is makes cars go

No. Many VW Jetta's with Turbochargers are fueled by gasoline.

The turbo greatly enhances the performance of a diesel powered vehicle. Turbo's are powered via exhaust from the engine that forces more air into the intake manifold. This increases power. Works on gas and diesel powered vehicles

In-die tapping is the process of tapping stamped parts in a progressive die while in a punch press. In-die tapping eliminates the need for a secondary tapping operation of stamped parts.

Generally pumps work on principle of vaccum.

a bearing that is locked in position an not able to move.

Submerged arc welding is called "submerged" because the high voltage electrical current (called the "arc") that heats the metal and wire to weld together is submerged underneath layers of granular earth materials called "flux". About 50% to 90% of this flux can be re-used and fed back into the system with the proper equipment.

it is mainly provided to save the difram of lp turbine,

it is initially use to seal d vacuum's.

Grinding a bore.

That depends on the load.

in older cars like a model a ford,

the carborator was gravity fed so perhaps .5 psi or zero uphill with a low tank

carborators and a fuel pump 5 psi is plenty to lift the gasoline 10 ' or so

with fuel injection about 100 psi is common

diesel can be about 1000psi fuel injected at TDC

In order to have your question answered, you would have to state which bar material. Young's Modulus is different and specific to the material to which it is applied. It will be different for steel than for iron or aluminum.