0
Oldsmobile Delta 88
The Delta 88 was a full-size car manufactured by General Motors. It was a rebadged sixth-generation model of the Oldsmobile 88. The car was available as a two-door hardtop, a two-door convertible, a four-door hardtop and a four-door sedan.
566 Questions
Can you put an idler on your 91 oldsmobile 88 royale instead of having ac?
Yes, you can install an idler pulley on your 1991 Oldsmobile 88 Royale instead of the air conditioning compressor if you want to remove the AC system. This will help maintain proper belt tension and alignment. Make sure to use the correct size belt for the configuration without the AC to ensure proper function of the remaining accessories. Always consult a repair manual or a professional for specific guidance on the conversion process.
Yes, you can install an external electric fuel pump while keeping the existing pump inside the fuel tank, but it requires careful consideration of the system's design. The external pump must be compatible with the fuel system's pressure and flow requirements, and proper routing of fuel lines is essential to prevent vapor lock and ensure reliable operation. Additionally, ensure that the internal pump is not left running dry, as that could damage it. Always consult the vehicle's service manual or a professional to ensure proper installation and functionality.
Where is the fusebox on a 1978 delta 88 located?
In a 1978 Oldsmobile Delta 88, the fuse box is typically located under the dashboard on the driver's side. You may need to remove a cover or panel to access it. Additionally, some models may have a secondary fuse box in the engine compartment. Always refer to the vehicle's owner's manual for specific details and diagrams.
What is the firing order on an 1997 olds 88?
The firing order for a 1997 Oldsmobile 88, which typically has a 3.8L V6 engine, is 1-2-3-4-5-6. The cylinder numbering starts from the front of the engine on the driver's side, with cylinders 1, 3, and 5 on the left and 2, 4, and 6 on the right. This order is important for proper engine operation and performance.
How do you take your door panel off im 1991 delta 88?
To remove the door panel from a 1991 Delta 88, start by disconnecting the negative battery terminal for safety. Then, locate and remove any screws securing the panel, often found near the armrest, door handle, and along the bottom edge. Carefully pry the panel away from the door using a trim removal tool, starting at the edges to avoid damaging the clips. Once loose, disconnect any wiring for power windows or locks before fully removing the panel.
Why would gas go into oil pan?
Here is a general list in a loose order of likely hood:
- One of the cylinders has quit running
- The car would not start and has been badly flooded
- One of the injectors has failed open
- If the car is old enough an engine mounted fuel pump could fail, these go with carburetor engines only
- Carburetor trouble
What are the original size tires that fit on a 82 delta 88?
I believe they would have been 215/70 R15.
