0
Pontiac Aztek
The Pontiac Aztek is a mid-size crossover produced by General Motors from 2001 to 2005. This 4-door SUV is powered by a 3.4-L LA1 V6 engine and comes with a 4-speed 4T65-E automatic transmission.
460 Questions
How do you replace a turn signal switch for a 2003 Pontiac aztek?
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
How do you reset oil light for a 2002 Pontiac aztek?
It depends on if you have the Driver information center or not the owners manual will let you know or most dealerships will do it for you no charge
What could cause the anti-lock light on your dashboard to turn on?
Bring to a shop that has an ABS scanner to determine the problem
What does the code P0128 mean for a 2001 Pontiac aztek?
Coolant Temp below thermostat regulating temp.
For a 2003 Pontiac Aztec where is the radiator drain so you can flush the coolant system?
you have to take off the cover then it is on the driver side, plastic butterfly bolt
How do you replace rear spark plug wires on a 2003 Pontiac Aztec?
i have an 03 aztek. i change plugs myself, i have skinny arms to reach from underneath the car.
What does srv mean in the auto industry?
SRV stands for Sport Recreational Vehicle (Note: SUV stands for Sport Utility Vehicle).
Sounds like the heater core is leaking its a big job probably best left to the professionals
Replace alternator on Pontiac aztek?
The alternator on a Pontiac Aztek is replaced by removing the engine accessories, loosening the serpentine belt, and removing the retaining bolts. The alternator can then be pulled from its retaining bracket and a new one installed.
ABS and traction control light stays on at all times on a 2003 Pontiac Aztek?
Chances are its a wheel speed sensor and will need the wheel bearing replaced. or it can be a loose or corroded wire attached to the sensor as well.
What kind of Coolant in a 2003 Pontiac aztek?
Dexcool unless you flush thoroughly and use the green stuff
Why did your all wheel drive stop working on your aztek?
IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT . IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT . IT MAY HAVE TO DEAL WITH WHEEL HUB OR HUBS OUT OF LINE! OR GOING OUT .
What causes the traction control light to come on 2002 Pontiac Aztec?
On my 02 sunfire i found a broken wire not far from the sensor on the drivers side.if you remove both wheels you will find on both sides behind the rotor two plugs which can be distached and two wires wrapped in plastic loom running off thos plugs up to the front end under the rad and then tying into other harnessses..I found my broken wir within 8inches of the sensor within the loom and re-attached with a wire splicer,taped up,replaced the loom and all was good...I would say to look in theses areas first(from the rotor back 2 fett anyways) do to this area is open to stress from turnung and gravel or debris on the roads..Once you see what i meen you will understand..If this is noyt the case then it might be the sensors them selves which don;t look like much,,so shouldn;t cost too much..(mind you this would be a dealer part most likely) Good-Luck!!!
I drove to my local Home Depot pulled my key out and was unable to put the key back in I played with it for a few hours I sprayed WD40 into the key lock cylinder and used a paper clip in and out and finally the key went in and I had the lock replace shortly after that.
How do you know if the noise is bad wheel bearings?
The way to tell if you have a bad wheel bearing is when you are driving and go into a hard corner. The wheel that is on the inside of the corner stops making a humming noise. I just replaced my Driver Rear bearing on my 2004 VW Gti
I had the same problem with my 2001 Aztek, the cheap plastic plug overheated, and no longer made good contact, but if you wiggled the wires the A/C would work again for a while.
I looked up under the dash, and easily found the bad plug, on the side of the round fan assembly, simply by wiggling the wires with the key ON.I unplugged it, and put a little dab of RTV/Silcone around the outside of the plug to keep it from moving around, then plugged it back in, making sure that it was working. Once the silicon dried, I haven't had anymore problems with it losing contact.
It's a less than permanent fix, but a lot cheaper than taking it to a dealer to repair, and when I do decide to replace the bad Plug, the Silicon comes off easily, so it won't leave me with a big mess to clean up.
How do you replace the headlight of a 2003 Pontiac Aztek?
Pry the white 'tab' from the w/ screwdriver, the tab will pop up about half of an inch. Tab should pop right up and head lamp pull out pretty good. When putting headlight assy. back in to place, align the headlamp up to holes behind the assy. Push on the headlamp and push tab down, and that should be it.
AnswerThere is a white plastic piece that you will see if you open the hood of the car and look behind where the headlight is. You then pull up on this piece which releases the headlight. The headlight will come out of the front of the car, then you take off the rubber piece on the back. A turn of the bulb will have the bulb out and ready to be replaced.
Answer(add to above) If you pull up the white tab too far, the headlight won't release, so just pull it up about 1/2 inch. You'll feel it "click". The headlamps are common types that you can find at any auto store. The INSIDE SET (brights) are part number 9005 and the OUTSIDE SET (regular) are part number 9006. I found them right under the front counter displays at Auto Zone.
yes to above, add -pry lower inside corner of headlamp assembly loose, then pry forward on headlamp assembly with one hand, while dithering the loosened white tab vertically with your other hand. You will find the proper vertical position of the white tab by feel and the headlamp will pop right out.
How remove instrument cluster 2003 suburban?
push emergency brake, pull gear lever all the way down, tilt steering wheel all the way down, grab the big trim piece that goes from the left of the steering wheel to the right of the radio and pull it off (no screws) unscrew the 4- 7mm screws holding the cluster onto the dash, unplug the harness from the back of the cluster and Presto youre done!!!!!
How do you know if somthing is wrong with your front passenger axel 2003 Pontiac Aztec?
if you have a bad axle they will usually make a clicking noise when turning
Where is low port for R134 located on a 2001 Pontiac Aztec?
Follow larger hose from air compressor usually by passenger side firewall near accumulator/drier
