Power Tools

You dismantle the top and unstick the piston . Sounds like it hasn't been getting regular lubrication. -These guns need a few drops of oil in the airway every day that you use them.

You can work faster and with more efficiency using them.

Tools with generic names like that are generally made in China.

Squirt some "Rust Check" in it and wait an hour or so then try to turn it each way a bit at a time. -I have found that Rust Check is far better than most similar oils for freeing up tools

- Made in Canada and available at Canadian Tire and many auto parts stores.

For all practical purposes an 8mm drill is equal to 5/16 inch.

All types of smooth shaft bits up to 3/8 are compatible with this drill.

what charger wil fit the task force cordless drill a 12v and a 9.6?

As far as I can find out, GearWrench makes their tools at or near Sparks, Maryland. I have used their ratcheting wrenches and they are excellent, not cheap junk as you often find.

Check Ebay, there is an advertisement showiing it was built around 1952.

A bad workman always blames his tools (it is not the tools, but how they are employed)

You should inquire at your nearest True Value hardware store. I've found out that they have a way of ordering parts for this tool line.

How much is it worth? I just bought one for $40-. I've seen them range from $15- to $65-, depending on the stand (if there is one) and how well it works. Mine came with a beautiful homemade stand and extra blades. It runs like a champ!

As far as I can tell, they were made from 1944 or so, when King-Selly bought the Companion Co. that had been making a similar product, to no later than 1962, when Emerson bought King-Selly. My saw has a Craftsman decal below the blade in front that also has the King-Selly name on it. The manual for mine is dated Feb 1951.

Many scroll saws are very durable, but like any tool that depends a lot on how you take care of it.

Planer Blades Knives For Makita 2012 2012NB High Speed Steel 305x32x3mm Pack of 2 pieces of 30.5CM (12 Inches) long, HSS, planer blades to Makita 2012 2012NB Planer.

Buy Planer Blades at Woodfordtooling online shop with low cost.

As of April 4, 2012 Balck and Decker Outlets were notified that all stores are closing nationwide. Most stores have until the end of the month.

Strategy manufactures Strategy power tools. Strategy power tools were sold by QVC.

Those types of blades and bits are mainly for cutting tiles and stone.

It's a bit heavy to carry around to jobs away from your shop. There are NO other disadvantages.

It is always on the primary label, where the type and model # is.

You can apply a penetrating oil like WD-40 or PB Blaster and let it sit for a few hours to help lubricate and loosen the bolt. Heat the bolt with a propane torch to expand the metal, making it easier to turn. Using a breaker bar or a longer wrench for additional leverage can also help loosen a stuck bolt.

I would use a tenon saw for that.

Possibly, most 230 volt saws draw about 16-18 amps on each line. There will be a spec plate on or by the motor which has the amp draw marked. CHECK this first.

A piece of string and a ruler or tape measure.

That gun fires 2 -3.5 inch nail strips at 28 degrees. That's a common size for a framing nailer.