Which is faster a cagllari pocket rocket or mx3 pocket rocket?
They both are very close. The mx3 pocket rocket brand new cost $350. The Cagllari brand new cost $300. The mx3 is a little better quality. I would have to say the mx3 is better.
Is the Razor E325 better than the E300?
No. They have the same guts. Called Razor and asked myself. The E300 and E325 are the same scooter just different paint job.
Does the gearbox of a pocket bike x7 fits a pocket bike x8?
If you do not know you should ask your nearest MOM!!!!!!
A book is a set of written, printed, illustrated, or blank sheets, made of ink, paper, parchment, or other materials, usually fastened together to hing.
How much is a 1988 Kawasaki KD80X worth?
depends greatly on condition, both cosmetic and running condition.
What wheels are better for a scooter metal or plastic?
Metal because they are much stronger... I would recommend eagle sport wheel as they are the strongest metal core wheel or get yak metal core.
What is the fastest 50cc scooter on the market?
{The fastest 50cc moped was a Kreidler. Henk van Kessel rode 140 miles/hour (226 km/u) in 1977.
Kreidler went bankrupt in 1983, but the mopeds are still for sale second hand, and John Bos is building new ones in Holland.}
This is true, but 50cc scooters are not permitted to go over 70km/h on streets.
How do you remove valves on a 5hp Briggs?
Take the head off the engine then you will see the top of the valves. Look on the side of the motor right below the valves you will see a cover with two screws remove them and you will see behind it the stems of the valves - there are two springs you have to push one at a time and there is a slide clip which slides and pops off. Then push the valves up and pull it out of the engine.
What is best french id or jd bug?
i would say a jd bug because i have both and my jd bug is better but the best in the world is a madd gear nitro and dont get a micro because they are rubbish.
What gear ratio is your 96 4.3 liter S10?
There are three ways. 1 A dealer can normally tell from the vin number. 2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement info. 3 You can count how many times you have to turn the driveshft to get one complete turn of the tires.
What is the charger for an x7 electric scooter?
what is the
charger for an sharper image x7 electric scooter
Why does the Briggs side shaft 5hp the only way it will run is to hold your hand over the carb?
Most probably the carburettor is out of tune, or clogged. Holding your hand over it is basically the same as giving it choke. If it runs that way it means that it isn't getting enough fuel otherwise.