Swimming Pools

22.44 gallons for each inch of the water's depth.

there are 231 cubic inches in a gallon of water so there are 598.44 gallons of water in that size pool.

at 7.48 gallons per cubic foot, that is

7.48 x pi x 24 x 24/4*46/12 = 12,965 gallons

Well, measuring the water evaporation from your swimming pool is as simple as placing a bucket filled with pool water on the pool steps. Mark the water level inside the bucket and on the pool edge. After a few days, compare the water loss in the bucket to the pool water loss - that difference is your evaporation rate. Remember, it's all about taking your time and enjoying the process, just like painting happy little clouds in the sky.

One of the differences between plaster and fiberglass pools is that fiberglass stays smooth. Plaster can become rough. Another difference is that unlike plaster, fiberglass does not chip, and crack.

Well, isn't that just a happy little accident! When you have more swimmers in your pool than usual, you'll want to add a higher dosage of chlorine to keep the water clean and safe for everyone. Just like adding a touch of color to a painting, a little extra chlorine will help maintain that beautiful, crystal-clear pool for all to enjoy. Just remember, a little goes a long way, so add it slowly and carefully to achieve that perfect balance.

jacuzzi sex is great

i speak from expierience but some of the germs and the bacteria in the water could get into you and that is not good!!! but if you are on a pill during jacuzzi sex than you will most likely be ok

how to have it?

for guys

start by massaging your girls boobs slowly and softly pull down her bottoms and massage her butt

when hers are off pull down yours and rub your penis on her face and boobs start sucking and licking and kissing her boobs

let her rub kiss lick and suck your penis

rub your penis on her vagina and put it in slowly and gently the rest is history

for girls

start making out then pull down his pants pull down yours and lick his penis

pull off your top and rub your boobs on his face and penis

lets him suck your boobs and nipples

suck on his penis and put it in

you know the rest

hope this helped

It depends on what you call a lap. Does down and back equal one lap or does from one end to the other equal one lap? 25 yards is 75 feet. 50 x 75 =3750 feet if one end to the other is one lap. 7500 feet if down and back is one lap. 3750feet is roughly 3/4 of one mile. 7500 feet is roughly 1 1/2 miles.

The volume of water in the rectangular swimming pool can be calculated using the formula for the volume of a rectangular prism, which is length x width x height. In this case, the volume would be 18m x 10m x 2.5m = 450 cubic meters.

To go to space, you would need a spacecraft that can support human life in the harsh conditions of space, including vehicles like rockets or space shuttles. Other necessary equipment includes spacesuits, life support systems, communication devices, and navigation systems. Specialized training for astronauts is also essential for space travel.

64 tons or

64 000 kg or

140800 lbs

1 cubic meter of fresh water is 1000kg or 2200lbs. It actually differs slightly with elevation but this is the general rule. A swimming pool will not consist of pure water (chlorine, urine etc.) and these substances can have different densities than water so the result can vary a tiny bit.

Yes, a swimming pool can be an analogy of a vacuole in a cell. Just as a swimming pool stores water for a specific purpose, a vacuole in a cell stores substances such as water, nutrients, or waste. Both structures serve to maintain internal balance and support the overall function of their respective systems.

The water in a swimming pool is on the Earth's surface, while Earth's interior consists of solid and molten rock layers. The swimming pool water is a liquid contained in a confined space, whereas Earth's interior is a dynamic system of various layers, including the crust, mantle, outer core, and inner core. Additionally, the swimming pool water is influenced by external factors such as temperature and chemicals, while the Earth's interior is driven by geologic processes like convection and heat transfer.

pH stands for potiential of hydrogen it is a measure of the waters acidity. A high pH indicates that the water is more alkaline based and more subject to staining or allowing calcium buildup. A low pH is more acidic and will prevent or reverse staining, but can cause etching of the plaster.

A unit like inches or centimeters would be best to measure the length of your pinkie finger. These units are commonly used for measuring smaller lengths accurately.

yes, but's not a dye. dye would change the colour of the pool without someone peeing.

This is a question of volume. Assuming the pool is round and is 10 feet in diameter and 30 inches deep or high, we can apply the formula for volume of a cylindrical shape: V = pi r2 h. Since the diameter is 10 feet, the radius is half that or 5 feet. To make sure our answer comes out right, we also have to use the same units of measurement for everything. So we will convert 5 feet to 5 x 12 = 60 inches. V = 3.14 x 602 x 30 = approximately 339,120 square inches of water. With 1728 square inches in a square foot (12 x 12 x 12), this comes out to about 196.25 square feet of water. Converting to gallons, there are about 7.48 gallons of water in a cubic foot of water, so 196.25 x 7.48 = about 1468 gallons of water in the pool.

The water in a swimming pool is a liquid made up of hydrogen and oxygen molecules, while Earth's interior consists of solid and molten rock materials like iron and nickel. Additionally, the temperature and pressure conditions in Earth's interior are much higher compared to a swimming pool which is at a much lower temperature and pressure.

Don't do anything. Chlorine goes away on its own, which is why you must monitor it and keep it at the correct level. If you have too much, wait a few days. If it is hotter than normal out, the chlorine will go away faster than normal.

Filter earth coming out of the main drains in your pool can be caused by a broken or damaged filter grid inside the pool filter, allowing the filter media to escape. It could also be due to high pressure in the filter system, causing the filter media to be forced back into the pool. Check the filter system for any damage or blockages, and ensure proper maintenance and cleaning of the filter.

Yes, a saltwater pool can freeze in cold temperatures just like a traditional freshwater pool. It's important to take precautions to prevent freezing, such as running the filtration system continuously and using a pool cover.

Yes, it is possible to get struck by lightning in a hot tub that is on a deck. Water is a good conductor of electricity, so if lightning strikes the hot tub or the deck, the electricity could travel through the water and potentially harm anyone inside the hot tub. It is important to follow safety guidelines during thunderstorms and avoid being in a hot tub during lightning storms.

Geothermal pools are formed where the hot rocks below the surface of the earth are close enough to warm pools of water on the surface. Areas of volcanic activity typically have hot springs, as in the North Island of New Zealand.

Having just done an experiment in class I think I can answer this. In a test tube collect some swimming pool water then add some bromthymol blue and phenolphthalein and using pH paper dip it in the solution to determine the pH.

First the answer should be in meters so it is helpful to convert all the feet measurements into meters.

24 ft = 7.315 m

5 ft = 1.524 m

The way I read the question is that 24 ft (7.315 m) is the circumference of the pool. From this I make the assumption that the pool is a round pool. Thus we can model it as a cylinder. The formula for the volume of a cylinder is:

V = PI * r * r * h

Which means you take the math constant PI (approx. 3.14) multiply it by the radius of the circular face and again multiply it by the radius then multiply it by the height (or depth in the question).

The formula to find the circumference is:

C = 2 * PI * r

To get the radius from the circumference just divide the circumference by (2 * PI).

r = C / (2 * PI)

Plugging in the numbers we get

V = 314 * (7.315 / (2 * 3.14)) * (7.315 / (2 * 3.14)) * 1.524

Calculating this out you get:

V = 6.49 m^3 (meters cubed)