answersLogoWhite

0


Best Answer
Copy

after over 200 nuts, bolts, and screws i extracted the heater core. ordered it from the auto parts store and it was the wrong one. all previous and later models show the same part.Mazda quest and Ford Vans show the same thing. looks like i might have to work with the dealer!this seems to be a common problem. the dealer shows no recall or campaign for this problem. be careful when ordering and ensure you are ordering the right part. two other auto parts stores show the same thing but isn't Evan close. had to remove the dash and metal support bar to get it out.there might be a better way but im an electrician not a mechanic.

GOOD LUCK!!!!!

User Avatar

Wiki User

โˆ™ 2011-09-13 00:23:01
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change the heater core on a 1996 Mercury Villager?
Write your answer...
Submit

Related Questions

Is a 1996 mercury villager the same as a 1997 mercury villager?

They are mostly identical, yes.


What oil was 1996 Mercury Villager use?

5W-30 is the preferred oil ( according to the 1996 Mercury Villager Owner Guide )


Where is the front heater blower motor on a 1996 Mercury Villager?

Remove the glove box. The front blower motor and the resistor can be accessed from there.


Is the 1996 mercury villager an interference engine?

No, it is not.


Is the engine in a 1993 Mercury Villager the same size as the engine in a 1996 Mercury Villager?

Yes, exactly the same.


How do you remove the driver's seat from a 1996 Mercury Villager?

How do you remove the driver s seat from a1997 mercury villager


How many quarts of oil does a 1995 mercury villager need during an oil change?

I assume it is the same as the ( 1996 ) Mercury Villager : With engine oil filter change : ( 4.2 US. quarts of 5W-30 engine oil )


Does 1996 mercury villager transmission fit in the 1995 villager?

Yes, it should fit.


What is the oil capacity on a 1996 Mercury Villager?

According to the 1996 Mercury Villager Owner Guide : With engine oil filter change : The 3.0 liter V6 engine takes : ( 4.2 U.S. quarts / 4.0 liters , 5W-30 preferred )


How many quarts does a mercury villager need with a new filter change?

I looked at the Mercury Villager Owner Guides from ( 1996 , 1999 , and 2002 ) With engine oil filter change : Each Owner Guide shows ( 4.2 U.S. quarts )


How do you change spark plugs on a 1996 Mercury Villager Van?

With a spark plug socket and socket wrenches and extensions.


How do you replace a heater blower in a 1996 mercury villager?

Open the glove compartment and remove it. Disconnect the electrical connector and the three mounting screws. Remove motor.


How do you put freon in a 2000 mercury villager?

Go look at the answer that was posted for, "How do I put freon in a 1996 mercury villager?" This answer is most likely what you are looking for.


How much oil does 95 mercury villager take?

According to the ( 1996 ) Mercury Villager Owner Guide : With engine oil filter change : The 3.0L V6 engine takes ( 4.2 U.S. quarts / 5W-30 PREFERRED )


The cost of a water pump for a 1996 mercury villager?

$49.00 - $89.00


How do you reset the door combination on 1996 mercury villager?

Take it to a dealer.


What is the recommended gap on spark plugs for a 1996 Mercury Villager?

According to one of Fords websites : For the 3.0 liter V6 engine in a 1996 Mercury Villager : The spark plugs are gapped at ( .034 inch )


Where is the fuel pump on a 1996 mercury villager 3.0L?

inside of gas tank.


Where is the OBD in a 1996 mercury villager?

To the right of the steering column under the dash.


Where is the sensor for the rear hatch on a 1996 mercury villager?

That is incorporated with the latch assembly.


What type of AC gas does a 1996 Mercury Villager use?

R-134a


What kind of transmission is in a 1996 mercury villager?

4F20E four speed automatic.


Where is ATF dip stick on 1996 Mercury Villager?

Auto transmission fluid.


How much does a cam sensor on a 96 mercury villager cost?

The cam sensor on a 1996 Mercury Villager cost about $35 to $40. The sensor is actually manufactured by a Nissan subsidiary.


Where is the location of the modulator valve on 96 mercury villager?

The 1996 Mercury Villager modulator valve can be found on the firewall in the engine compartment. The modulator valve will be on the passenger side of the firewall.