answersLogoWhite

0

📱

Radio

A radio refers to an electronic device that works by receiving radio wave (an electromagnetic wave) that has the capacity to broadcast news, speech, music and other audio through the air.

8,296 Questions

What is the dial for classic FM?

[That depends on where you live. It's different in every city.]

From their website it is available as follows:

Digital channelDAB: 11D England & Wales

DAB: 12A ScotlandAnalogue channelFM: 99.9-101.9 MHzWeb streamWindows Media AudioFreesat721Sky0106TalkTalk TV615Virgin Media922UPC Ireland915

Where is the radio amplifier in 1997 Lexus sc300?

If I remember correctly, in the trunk under the CD changer

What station would have waves with higher energy 90.5 MHz or 107.1 MHz?

107.1 MHz has higher energy photons.

The photon energy increases directly proportional to frequency.

However if the station operating on 90.5 MHz transmitter's power is 1.184 times or higher than that of the station operating on 107.1 MHz transmitter's power, then the 90.5 MHz signal will have higher energy because the additional photons makeup the difference. The total energy in electromagnetic radiation is the product of the energy per photon and the number of photons (i.e. amplitude of the wave) in the radiation.

Why does your aftermarket radio speaer dont work but your factory do?

Most likely the speakers are rated for different 'ohms' (or resistance value) in the car stereo wiring. For example, the stock speakers could be rated for 12 ohm wiring, but your aftermarket ones could be rated for 10 ohm wires. The aftermarket speaker would not work, because there is too much resistance in the existing wires. So, either find replace your stock speakers with an OEM (original equipment - manufacturer) part, find an aftermarket speaker that will work with your current wiring, or rerun your speaker wiring (not terrribly difficult, but should still be done by a professional.) Hope this helps.

Radio in 2003 Kia Sedona?

What is it you want to know about the radio?

answer

I assume , you want to replace the radio in your sedona. follow the steps below.

  • Lift the Kia's hood and loosen the bolt holding the negative battery cable to the battery terminal with the wrench. Lift the cable from the battery and set it away from the terminals. Move to the inside of the car.

  • Pry the dash panel surrounding the gear selector lever away from the dashboard with the trim panel removal tool. Set the panel aside. Remove the two screws at the bottom of the stereo assembly dash panel with the Phillips-head screwdriver.

  • Remove the trim panel surrounding the stereo assembly from the dashboard by hand. Set the panel aside. Remove the four screws around the perimeter of the factory stereo with the screwdriver.

  • Slide the stereo from the dashboard stereo dock. Unplug the stereo wiring and antenna cable from the back of the unit. Plug the stereo wiring connectors into the plastic end connectors of the wiring harness adapter.

  • Insert the installation cage into the Kia's stereo dock. Fold the cage's metal tabs outward with the flat screwdriver. Pull the wiring harness adapter and antenna cable from the back of the dock, through the cage to the front of the dash.

  • Plug the wiring harness adapter leads into the outlets on the rear panel of the new stereo. Plug the antenna cable lead into the antenna input on the back of the aftermarket unit. Slide the stereo into the cage until it snaps into place within the stereo dock.

  • Place the larger of the two removed dash panels onto the dashboard around the stereo assembly. Press against the panel to snap it into place. Replace the two screws at the bottom of the panel with the Phillips-head screwdriver.

  • Place the remaining dash panel onto the dashboard below the stereo. Press against the panel to snap it back into place on the dashboard. Return to the Kia's engine compartment.

  • Place the battery cable's clamp back onto the negative battery terminal. Tighten the bolt on the cable's clamp with the wrench. Close the hood.

When was DYBN created?

DYBN was created in 1997.

How do you remove radio from a 1991 jaguar xj6?

How to Install and Remove Car Stereo Instruction for a 1991 Jaguar XJ6

1) Lift center console cover.

2) Remove two exposed screws attached to ash tray assembly.

3)Gently lift assembly, pull away from front of dash allowing tabs to clear from under next panel.

4)Reach up under next panel to remove two plastic wing nuts from next panel.

5) Set Parking Brake and shift to lower gear.

6) Lift back edge of panel up to allow wing nut screws to clear from panel.

7) Lift back edge of panel high enough to allow front edge along gear shift trim to clear.

8) Pull panel away from car stereo and dash.

9) Remove screws securing car stereo and control panel to dash.

10) Gently lift gear shift trim releasing three clips.

11) Pull car stereo and control panel from dash. It is a tight squeeze under top of dash panel and over gear shift.

12) Disconnect antenna and connector.

13)Push two clips on top of car stereo down to release car stereo and push out of front of mounting sleeve.

14) See your local dealership for exchange on this car stereo. We no longer repair Jaguar car stereo.

When was Realitatea FM created?

Realitatea FM was created in 2007.

What happened to rick zurick from wlit FM?

Rick was among the 2500 people let go in budget cuts by Clear Channel on 1/20/09. At this posting he is living in the Chicago area and searching for a new radio job.

Where is the radio fuses for a 2000 solara?

Your owners manual contains that information. The radio fuse is in the cabin fusebox under the left side of the dash. Inside the fusebox lid is a diagram that labels each fuse. Cheers

Why em waves are called as radio waves?

We have several names for E&M waves, depending on their wavelength.

"Radio" is one of the names ... typically the name we use for the longest

class of waves.

How are you supposed to deactivate the antitheft radio in an s-10?

go to a Chevy dealer and they can get the code from your serial# of your truck

What do CB call letters mean?

They identified you and your station as a separate indivual and where your business was located. Virtually no one used these licenses so the system was dropped by the FCC. for 11 meters citizen band.

When was DXZA-AM created?

DXZA-AM was created in 1995.

How do you add satellite radio to a Mercedes Benz E320 2004 factory radio?

You need to install a sat radio control unit. You then need to put it into the fiber optic loop. Then you have to program comand head unit and configure the fiber optic specified values.