Chevy Cavalier

Squeaking noises are usually suspension concerns, (bushings, sway bar brackets, shocks). especially when decelerating/ accelerating/ turning, I.E. Non steady speed driving.

>Hey Darlene==Use a wrench on the bolt through the idler pulley to raise up on the pulley and take the tension off of the belt. There should be a schematic for the routing of the belt on the fan shroud, If not, draw one before you remove the belt. Don't rely on memory. GoodluckJoe

Comments from KenJudy: Hi. I just had to replace the alternator on my daughter's 1997 2.2 liter Chevy Cavalier. "GoodluckJoe" gives good advice but here are some details that I figured out thay may help. For mine the idler pulley is the one depicted as an X below. Using a 15MM wrench on the bolt in the middle of the idler pulley clockwise loosens tension on the belt. The only way I could get the belt back on was to put it on the idler pulley last.

0 O

X O

O O

serpentine belt

---------------

( 0-1 O-2 )

------- ----

X-3 ) ( O-4

----- --

( O-5 O-6 )

-----------

0-1 power steering

O-2 alternator

X-3 idler pulley

O-4 water pump

O-5 main crankshaft

O-6 air condioner

Regards,

KenJudy

Very good drawing from KenJudy, I looked at mind and had a time till I got it right. Some car shops store will lend out tools if you can find one ask for a serpentine wrench. It's the greats little tool you need, basicly it's a flat bar with a socket on the end. You use the 15mm socket and just put it on the bolt in the middle of the idler pulley and then pull towards the front of the car. Slip the belt off the smooth pulley and release the pully slowly. Pull the belt out and get the new one in place, then pull the wrench towards you again. There is a spring inside the motor you can't see. You may have to just hook it on the power steering pulley abit and move the wrench to pull it again. Once it's on all the pulleys are lined up just release the pully slowly. Get all your stuff out of the way and get the car a quick turn over and check every pulley, if everything looks good start the car. Just let it run for abit, and there you go. I bought a serpentine wrench at a discount auto store for $12. I'll keep the old belt and the wrench in my trunk just in case.

Cheers

Handy63

hello this is Mark the moast important part in changing the serpentine belt is the SERPENTINE WRENCH without it you wont be able to get the tension off belt because you think there is not enought room to get it off with a rachet or wrench

i have a 2003 Cavy but i don't think they change to much. remove your red batter cable first you not only might zap yourself you gotta make sure you don't zap your car either. when i open my doors there are inserts on the drivers side they one has the fuse door. take those bolts out mine are 7mm i used a nut driver all most all of the dash is 7mm. take them out on both sides. also you gotta take off the defroster vent hat way you'll have more room to move without breaking stuff. next open your glove box there's one obvious bolt then another one deeper in a hole make sure you get them both. OK now under your steering heel cover there should be three bolts that hold it togeher take them out and take off the top it takes some wiggling but it'll make the dash easier. there are also two 7mm bolt down right above the storage try in the console there pretty far back three so make sure you get them. after everything's all loosened up mostly the main dash bezel is held by clips rather than pulling the hell out of it get a flat head screw driver cover it in sum kinda tape and slowly pry till they pop out you can feel them all around. once you've got it semi removed you gotta unplug the backing on the cigarette lighter its a semi-simple clip use a screw driver to help if u need it. also you gotta get the dimmer switch its best unclasped right behind the face of it to disconnect the whole thing and remove the bezel there are four 7mm bolts holing you stock radio in there take those out and you'll have access to all the wires which you can get an exact diagram on the web for that stuff. if you didn't already you should buy the adapter too. some people switch the radio with the heat control panel to give it a custom look. personally i wouldn't 'cus if you got a soda in there you can't piss with the radio to each his own i guess anyways that's how you tear it apart yous might be a little different i didn't know anything when i first dived in but not too had just be gently you don't want to have to buy new plastic you want to buy more CDs. o and if your planning on doing any dash painting now's the time for that too. the less times you have its gusts out the less chance of infection or in other words breaking stuff if u want to know how to do that just get 180 grit sand paper sand it smooth. go to advanced auto parts buy more cans then you think you need. tape stuff off and spray away or check youtube. if i didn't help any you can get a Haynes repair manual from advanced too good luck with your system and nice choice in a car, its not hard to do an amp and subs either if your into that.

If auto.

Dipstick should be at the rear passenger side of the engine If you can't find the stick it might be because on the 4 speed auto trans models there is none,check your manual. It may be a sealed unit.

Rims from various models can interchange with the Chevy Cavalier, particularly those from other GM vehicles such as the Pontiac Sunfire, Oldsmobile Alero, and Chevrolet Cobalt, as they often share similar bolt patterns and offset specifications. Typically, the Cavalier uses a 5x100 mm bolt pattern and a center bore of 56.6 mm. It's important to ensure that the rims have the correct specifications, including width and offset, to maintain vehicle handling and safety. Always consult a fitment guide or a professional before making a purchase.

On a 2001 Chevy Cavalier, the cabin air filter is located behind the glove compartment. To access it, you'll need to remove the glove compartment by unscrewing or unclipping it. Once the glove compartment is out of the way, you can find the filter housing, which may require a few additional clips or screws to open. Replace the old filter with a new one, ensuring it's oriented correctly for airflow.

On a 1995 Chevy Cavalier with a 2.2-liter engine, the voltage regulator is integrated into the alternator. To access it, you will need to remove the alternator from the engine bay. Once the alternator is out, the voltage regulator can be found inside the casing of the alternator itself. If you're experiencing issues, it may be necessary to replace the entire alternator, as the regulator is not typically sold separately.

A 2004 Chevy Cavalier typically requires about 6 to 7 quarts of antifreeze when performing a complete coolant system flush and refill. It's important to use a 50/50 mixture of antifreeze and distilled water for optimal performance. Always check the owner's manual for specific recommendations and ensure the cooling system is properly bled of air after refilling.

If your 1995 Cavalier starts but shuts off when you put it in drive, it could be due to several issues. Common causes include a faulty transmission range sensor, which may not be allowing the engine to remain running when in gear, or problems with the idle air control valve, which regulates engine idle speed. Additionally, a fuel delivery issue or a vacuum leak could also lead to stalling when the load changes. It's best to have a mechanic diagnose the problem to pinpoint the exact cause.

The thermostat in a 1998 Chevy Cavalier with a 2.4L twin cam engine should be installed with the spring side facing the engine and the wider, flange side facing the radiator. This orientation allows the thermostat to open properly and regulate the flow of coolant as intended. Make sure to also replace the gasket and ensure a proper seal during installation.

In a 2004 Chevy Cavalier, the warning lights for the alarm system are typically located on the instrument cluster, specifically on the dashboard. Look for a small red or yellow light that may indicate the status of the alarm system. Additionally, the alarm system may have a separate indicator light on the center console or near the rearview mirror. If the alarm is activated, this light will usually flash to signal that the system is armed.

On a 1994 Chevy Cavalier, the PCV (Positive Crankcase Ventilation) valve is typically located on the valve cover. It is often found on the driver's side, connected to a hose that leads to the intake manifold. To access it, you may need to remove any components obstructing the valve cover area. Once located, the PCV valve can be pulled out for inspection or replacement.

Yes, you can flat tow a 2003 Chevy Cavalier, but it's important to take certain precautions. The vehicle should be in neutral with the ignition key in the "on" position to unlock the steering wheel. Additionally, it's advisable to consult the owner's manual for specific towing guidelines and to use a proper towing setup to avoid damage to the transmission. Always check local regulations and guidelines for flat towing before proceeding.

To replace the evap canister on a 2004 Chevy Cavalier, first, locate the canister, which is typically situated near the fuel tank or under the vehicle. Safely lift the car and support it with jack stands if needed. Disconnect the electrical connector and the hoses attached to the canister, then unbolt it from its bracket. Install the new canister by reversing the removal process, ensuring all connections are secure before lowering the vehicle.

To fix the horn on a 2005 Chevy Cavalier 2.2L, first check the fuse box for a blown fuse related to the horn and replace it if necessary. Next, inspect the horn itself, which is typically located behind the front grille; ensure the wiring is secure and free of corrosion. If the horn is still inoperative, you may need to test the horn relay and the horn switch in the steering wheel for functionality. If these components are working, the horn might need to be replaced.

The coolant fan on a 2004 Chevy Cavalier should typically turn on when the engine reaches a certain temperature, usually around 220°F (104°C). It can also activate if the air conditioning is turned on to help maintain optimal engine temperature. Additionally, the fan may engage during heavy driving conditions or when the engine is under load, ensuring the engine remains cool and preventing overheating. If the fan does not operate as expected, it may indicate a problem with the fan, temperature sensor, or related electrical components.

To fix the hood latch on a 2002 Chevy Cavalier, first, ensure the hood is fully closed. Then, inspect the latch mechanism for any debris or rust that may be affecting its operation. If it's stuck, clean and lubricate it with penetrating oil. If the latch is broken or damaged, you may need to replace it by removing the old latch and installing a new one using the appropriate tools.