0
Chevy Chevelle
The Chevelle was a mid-sized car produced between 1964 and 1977 and was used in many NASCAR races in the 1970s.
761 Questions
How remove door panel 67 Chevelle?
take arm rest off, take inside door handle and window handles off and then take screws out around the bottom of the panel and get something that will fit between the door and panel and pop the clips out all the way around and the panel comes off.
How much did a gm Chevelle cost in 1969?
Roughly $3000. The cost could vary wildly depending on the model and options. A base model 2 door with a six cylinder and 3 speed manual trans obviously was a LOT cheaper than an L78 SS 396 loaded to the gills with options.... Not to mention the COPO cars equipped with L72 427's.
What is 1963 Chevelle El Camino worth?
Trick question , there were no el caminos produced in 1963 . The El camino was produced in 1959 and 1960 but then was not produced again until 1964. There is no 1961,1962,or 1963 el caminos
How do you shorten the throttle cable length on a 72 Chevelle to fit an edlebrock carb?
You can go to some parts stores--Advance, Auto zone, Napa, and buy you an aftermarket throttle cable bracket that you can bolt onto the carb. bolts are intake manifold that will hold the throttle cable and the transmission d-tent cable.
How do you install 1964 Chevelle gas tank?
hoist it into place and tighten the 2 straps, hook up your fuel line to the tank and the hot and ground wires for the fuel gauge and your ready to roll.
Gross vehicle weight for a Chevy Chevelle?
it depends on the year but i know a 1970 chevelle weighs about 3,700 lbs
What engine was in a 1969 Chevelle?
If it's a mailbu, It could have been a stright 6 cylinder or a 307 V8 or a 350 V8
If it's a SS ( super sport ) It could have a 396 big block or a 454 big block, maybe
even a 427 big block depending on what type of SS it was.
How do you remove a 1970 Chevelle's front bumper?
Two ways. Either remove the bolts holding the bumper to the brackets, or remove the bolts holding the brackets to the frame and remove them with the bumper. Make sure you unplug the turn signal lights as well. It's pretty simple and straight forward.
Bore and stroke of stock 350 Chevy motor?
A 350 Cubic inch Chevrolet engine has a 4.00 inch bore with a 3.48 inch stroke to produce 349.67 cubic inches of displacement that is rounded up to 350 cubic inches.
I know it is splitting hairs, but the displacement is slightly more than (due to rounding errors): 4.00 (bore) * 3.48 (stroke) * 3.14159 (pi) * 8 (cylinders) = 349.84
This knowledge might be useful for a bar-bet at the local watering hole.
get a chiltons repair manual from the library for your year chevy.
How do you remove the dashboard in a 1971 Chevelle?
You need to purchase a book, possibly a Haynes Manual. it is more detailed than could be explained here.
