0
Chevy Chevelle
The Chevelle was a mid-sized car produced between 1964 and 1977 and was used in many NASCAR races in the 1970s.
761 Questions
How to read casting numbers a small block Chevy?
Drivers side, right in front of the cylinder head, there is a pad on the block, with a series of numbers, starting with 2 letters, usually.
Do 1970 el caminos and chevelles use the same frame?
No station wagons and elcaminos do. chevelles frames are not boxed as elcos and sw are and have different rear sections along with length also different body mount locations if you are good you can make them work but you will need part of your old frame. go to chevelle.com for the right info on this project
Are 1968-72 nova lower control arms the same as early 68-72 Chevelle?
No But they are the same as 1st generation camaro 67-70
Where is the VIN located on a 2004 Yamaha yfz450?
bottom of the left side of the frame by the shifter kinda.
Whatever a buyer is willing to pay that would be acceptable to the seller.
1,8,4,3,6,5,7,2
Will Chevy oem iroc rims fit on a 1970 Chevelle?
Yes, any OEM 5 x 4.75 IROC will fit an early Chevelle. Be careful for aftermarkets, they come in different bolt patterns.
What is the proper spark plug gap for a 71 Chevy Chevelle 350?
Spark plug gap is .035, point gap is .017 to .019 or 30 degrees dwell. Timing with the vacuum advance disconnected and plugged is 4 degrees. If you have a timing light with a dial for total advance then it is 35 degrees at 2,000 RPM.
How do you remove key lock switch-from 2003 Buick century steering column?
On the GM cars I've worked on, you have to remove the steering wheel. There is a vertical retaining bold/pin that has to be remove to allow the tumbler/key lock cylindar. Remove the wheel. Remove the retaining pin. Then remove the tumbler. Reverse the above to install the new one. Hope that helps.
How do you remove the steering wheel off your 1994 mercury tracer?
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
