Chevy Tracker

Tune up time with fuel and air filters, spark plugs and wires.

I was driving around an 03 tracker for a few years that had about 175,000 when I first started driving it. I drove it till the timing chain gave @ appros 220,000. I now own an 04 with approx 93k. So with that I should if taken car of properly get approx another 130k + out of it.

where is the oil pump located in chevi tracker 2.0 L

Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1)

symptoms
Other than the MIL light illuminating you may not notice any performance issues.

cause
A short in the O2 sensor heater circuit or the sensor itself
A faulty O2 sensor heater
Wiring or connectors are broken or frayed to the sensor or relay
Bad PCM or ECM

The fix
Correct wiring short or loose connector found in inspection.
and/or
Replace the bank 1 sensor 1 O2 sensor

The force of the collision has to be great enough

To replace the left front axle shaft on a 1999 Chevy Tracker, first, raise the vehicle and secure it on jack stands. Remove the wheel, then detach the brake caliper and rotor for better access. Unscrew the axle nut and disconnect the lower ball joint, allowing you to pull the axle out of the hub. Finally, remove the old axle shaft from the transmission, install the new axle shaft, and reverse the steps to reassemble everything.

at the rear of the engine on 2001 2.L also

By law, this work must be performed by an ASE certified technician in an EPA approved shop. When the AC system is opened up for repairs, the refrigerant must be evacuated and stored, and you'll also have to replace your receiver-drier (if it's a Thermal Expansion Valve system) or your accumulator (if it's a Fixed Orifice Tube system).

The axle on a 1991 Suzuki Tracker is a semi-floating design, meaning it has a shaft that is supported at both ends but relies on the wheel hub for additional support. To remove the axle to replace the outer seal, first, remove the wheel and brake components, then disconnect the axle from the wheel hub and the differential. Finally, pull the axle out of the housing, taking care to replace the outer seal before reassembling everything.

The PCV sits in a rubber grommet in the top of the valve cover.

If you can't find out the size of the speakers in your car on the internet or other sources, just take the existing speakers out and measure. the measurement of speakers is from the edge of the suspension on the speaker itself through the center of the speaker and to the other edge of the suspension of the speaker itself, NOT from the edge of the housing, edge of the metal or screw holes.

check the ground wire stemy. from the batter neg to the neg on the head light neg side

what kind of cd player is in a 2001 checy tracker

i have heard it will but i am not totally sure because i dont have a 350 to try it with

You can as long as it is a four-wheel drive unit with a transfer case. Two wheel drives are not towable four wheels down. To tow place transfer case in neutral and transmission in 2nd gear if standard and leave it in park if automatic. Ignition key switch is put in "ACC" position. Max towing speed is 50mph and you must stop every 200 miles and run the engine to circulate oil in the transfer case. We have been towing a '99 Tracker without problems for numerous years.

is this a joke?

ok, drain it

fill it

change filter.

done.

look under pan, see the drain.

look on left side of motor, see oil filter.

look on top of motor ,see filler cap with oil can logo.

i bet there are like 10000000 google links on how to change oil.

I have a 2001 tracker with a 2.0 & my dipstick is located on the right hand side of the valve cover about 1/2 way back. the handle sticks up.

Chevrolet doesn't use reset switches. The system is computer controled with relays.

Since the majority of vehicles today have sensors throughout, the dependency for a well-working electronic system is required for them to properly function. It looks as though your airbag might be sensing that you've either hit something or that you will hit something if you don't get work done to your vehicle. AI in vehicles has basically taken on a mind of its own, if you don't mind the pun. The work required could be a number of things, but most common are your wheels being either out of balance, not properly aligned, or the engine drinking too much water in ratio to the oil intake. The horn has stopped working because of the sensor for the airbag light being triggered to prevent you from falsely thinking somebody is driving recklessly when in reality it is your vehicle that has something wrong with it. My recommendation? Try taking it to a professional and tell them to give your car 'the works'. They'll know what you mean.

Without having it checked for codes, It is impossibe to answer.

Make sure your parking break is off when you're removing the break drums or they won't come off.

model year and engine size are relevant to the question.

To adjust the emergency brake on a Chevy Tracker, first, ensure the vehicle is on a level surface and the wheels are chocked. Locate the adjustment screw or lever, typically found under the center console or near the rear brakes. Tighten or loosen the adjustment mechanism until the brake engages appropriately when pulled and releases fully. Finally, test the brake to ensure it holds the vehicle securely when applied.

Brake lines on a 2001 Chevy Tracker cost between $200 and $400. Labor to install the lines typically runs from $150 to $300.

you could have a leaky or damaged transfer case.