Chrysler 300 Series

Catalytic converter failure bank one.

Catalytic converter failure bank one.

100,000 miles

There are wiring harnesses all over the vehicle.

OPen the hood and look to your left it should be in the area of the air filter.

Just behind the engine, in the passenger side of the bell housing.

Yes.

yes

Had the same problem and it was the computer chip in the ignition key

You have to have a scan tool.

Use the key???

There are jump start points under the hood.

There are two fuse boxes, one is under the hood on the passenger side. The other is in the trunk under the carpet, next to the battery.

I just changed the fog light bulb on the passenger side of my Chrysler 300c and in my case there is nothing behind the hole that is questioned. No sensors, no wires, no tubes, nothing. So the question remains.

Every car needs a certain type of oil. The manufacturers usually tells you what kind of oil to use. Putting 10w30 oil in a 2005 corvette could really hurt the engine but putting it in a 1999 to 2004 Chrysler 300 M is perfectly acceptable. Considering you didn't say what model of car, this question is very hard to answer. The simple answer is to use the oil grade recommended by the manufacturers of your car.

They didn't make this one easy. My information is based on the 2002 model so it may vary a bit. You have to open the hood and remove the air filter box. The battery is underneath. You then have to remove your tire (yeah, crazy) in order to access the panel that allows you to remove the battery. Once you have the access panel in the wheel well off, you can unbrace the battery and pull it out through the wheel well. I recently had to do this myself and was scratching my head the whole time.

I believe it is fuse #44 located in the trunk Power Distribution Center

Thr engine computer has detected a problem and set a code for the electronic throttle system.

It depends on the radio it was built with, most do.

Pass side 1-3-5

driver side 2-4-6

firing order 1-2-3-4-5-6

The 2012 Chrysler 300 has a 3.6 L base engine size.

They will need replaced. The seat belt retractors have cinching devices that go off during a crash.

grab the front of one side LIFT!.....grab the front of the other side..LIFT! that should do it...then line up then push down for installation

* Disconnect the negative battery cable * Drain the coolant from the radiator and the engine block * On SOHC engines detach the upper radiator hose from the coolant outlet at the intake manifold and the radiator,then unbolt the hose clamp at the timing belt cover and remove the radiator hose.Detach the bypass hose from the thermostat cover * On DOHC engines remove the drivebelts and the idler pulley bracket.Also remove the lower radiator hose and the water pump drain plug from the side of the block which faces the front of the vehicle * Remove the thermostat cover from the engine.Be prepared for some coolant to spill as the gasket seal is broken * Remove the thermostat,noting the direction in which it was installed * Scrape off any old gasket or sealant on the thermostat housing and the thermostat cover,then clean them with lacquer thiner

Just enough to reach the full mark.

Just enough to reach the full mark.

The red circle warning light is the indicator for the sentry key and theft alarm systems.

The 2012 Chrysler 300 is 6 ft. 3 in. (75 in.)12 Months of provided satellite radio service wide.