Electronics Engineering

Never probe airbag wiring with a power probe or multi-meter unless you have isolated the circuit by disconnecting both the airbag module and airbag component. As long as you have disconnected these you will be fine.

Yes and no. A capacitor generally does not pass DC current, except for a small "leakage current", but upon the inital application of a DC voltage, the capacitor will pass current until it reaches the full potential of the applied voltage. The simple answer is no it does not. In fact we use that characteristic to "decouple" one circuit from another in amplifiers for example.

It refers to the Interface Switch (IS). it allows the RBS speak to the TRX's.

Consider t resistors with same Ohmic values. If they are in series total resistance Rt = R1 + R2. if they are in parallel then total resistance Rt = 1/R1 + 1/R2. Series connection will have higher resistance.

Yes Many have a time delay adjustment or selector switch to pick how many minutes the delay will be

it means that you digitize analog data for transmission . Like 2 computer that chatting .

barrage jamming

A: It really depends on the load requirement . Example driving a relay hi ripple with no capacitor is an advantage in efficiency for a sensitive amplifier it will cause mayhem with the performance

we use it when we require a variable resistance in a circuit

Type your answer here... a circulator in antinna is used to pass the information in all directions

Hybrid devices are combination of two devices with unique characteristics. for example::--modem mobile phones are hybrid of camera, phones and media player.

Hard to do. If your Ohmmeter battery is just 1-1/2 volts, then you simply put the test leads on the diode one way, then the other way. The way that show a meter reading will have the black lead on the 'cathode', if you assume, as most do, that electrons are issued from the " - " or 'minus' side of the battery.

BUT . . . if your Ohmmeter voltage is above the zener's trigger voltage, then you will get a reading both ways.

A voltmeter measures the voltage present in the circut. Voltage is the amount of energy available to push charges through an electric circut.

A halogen bulb works equally well with AC or DC.

He helped Alessandro Volta in inventing the battery :)

A: Current flow only if there is a return path to the source it does not matter what it is connected to. What leaves at one end of the source will be identical to the return in current

There are .42 amps in 420 mA. Equation 420/1000 = .42 amps

A person can build up a static charge in their body simply be walking over a nylon carpet. If they then touch delicate components on a motherboard, the spark could fry a component, destroying the motherboard. Antistatic mats help prevent static build up. Antistatic wrist straps direct any body static directly to earth before any damage can occur. Touching a water pipe or a computer's chassis has the same affect of getting rid of body static. If children are jumping up and down on a (nylon) trampoline, you will get a spark (static) if they touch you - quite a party trick, especially if the children's hair is also standing up - a sure sign of static electricity!

N- Type and P- Type :)

The potentiometer is the device that is used in the measuring of the potential difference.

A pure resistive load always has a power factor of one. This is because the current and voltage waveforms are in phase in an AC circuit.

Cadmium, Phosphor material and Lead coated glass of CRT that's so TOXIC.

When a capacitor discharges the discharge current flows in the opposite direction to the current used to charge it.