Electronics Engineering

All communication systems use electromagentic waves which by the law of Superposition of Waves travel independently in any meadium and hence do not interfere but if the frequencies tend to match then the carrier waves with amplitude modulation are more affected and give poor quality sound at the receiving end than the frequency modulated carrier waves.

It depends on how much delay you want, and also on the frequency. If you just need a few nanoseconds, run the square wave through an even number of series connected inverters. If you need 180 degrees, run it through one inverter. If you need something else, you may need a more complex solution, ranging from an RC coupled schmitt trigger to a digital phase locked loop.

You might be able to but why you would want to is questionable. A capacitor could be used in air-con for two reasons. First to start the pump motor if it is a single-phase induction motor. Secondly, as a power-factor corrector. In both cases the two capacitors have probably been correctly selected and there is no point in using a different one.

A replacement capacitor should have the correct voltage rating and the correct VAR rating (or the right capacitance in microfarads).

0.1764 amps

oxygen sensor

Biosensors use ion and gradients to create electrical charges that are sent through nerve cells. For example, when you touch a surface, such as a table This is the reason you can feel hot and cold, pain and pleasure, etc. Ions are the products of salts in a solution. Ion gradients are not always used in this process though. For example, many of the chemoreceptor cells use neurochemicals such as serotonin to send messages to the central nervous system. While these organic molecules are not ions, they are polar and electronegative, giving them a slight charge.

of course you can

One has SL in it name the other has CL plus an S at the end.

No. The PNP and NPN transistors are exactly opposite each other in polarity. You cannot just replace one for the other without redesigning the circuit.

A geranium is a flower, and not a semiconductor. The element Germanium, however, is a semiconductor, which means it has an electrical conductivity somewhere between that of a metal and an insulator.

The term "quantized" means, is divided into discreet sections which are indivisible; or in other words, it is made of small sections that cannot be made into even smaller sections. In the science of quantum mechanics, it turns out that matter, energy, space and time are all quantized. There is a smallest quantity of each of these which cannot be subdivided into an even smaller quantity. One of these tiny, indivisible pieces would be called a quantum.

What is a power limited circuit

The frequency can't be 30 Mhz 30 Mhz is a ham radio frequency but to calculate the wavelength, devide 300 by the frequency in Mhz that will give you 10 meters (300/ƒ)

In order to set an SABC1 on a Mediacom decoder you will need to enter the files using the start button. There should be a selection for settings and select reset.

Air is not a good conductor of heat because it, being a gas with only a few particles in a big space, cannot store much energy by volume as it doesn't have much material in which to store the energy.

However, air can move heat by convection, which means by moving and circulating it can transport the heat from one place to another. Because air moves with very little resistance it can easily move a lot of heat this way.

So air is good insulation only if it is in very small pockets where the air cannot circulate easily. A lot of insulators actually trap tiny pockets of air to create insulation, such as foam or even fine knitted clothing.

The amp is under the drivers dash, below instrument cluster, behind panel.

sometimes we want to select one of two input nibbles,In this case we use nibble multiplexers.

Sinking and sourcing current refers to current going into and out of the MCU (respectively)

no you can not it would ruin your system for good. You have to get a heaters with the same watts

brown, red, yellow , in case of gold its 5% tolerence, silver 10% tolerence, no color 20% tolence..

First it is beyond me as to why you would be painting a capacitor. You also don't give any ratings for the capacitor. By painting over the ratings on the capacitor you will make it difficult for future repairs. Also you don't mention environmental conditions of the type of paint. I have had any number of capacitors fail in different ways and some in spectacular fashion with heat and bubbling surfaces involved which could be a fire hazard. My recommendation would be against painting.

Kindle help me to answer

What is valve point loading effect and its applcation

Death.

rms value of voltage

avr microcontroller can be burnt by using a burner with variety of softwares like AVR BURN O MAT....