Flooring

when starting from a wall you first need to make sure the wall is square to perfect. use the 3-4-5 method to find the perfect square-- this will tell you if the wall is perfectly squared or not.

In this case I will be starting with my right shoulder-- Stretch your tape measure and point the metal tip into the eight side corner of the room. now measure out to the left 3 feet and make a mark at the 3 ft. point with a magic marker or pencil.

now measure from the corner along the wall down to a 4 foot mark and mark a 4 ft. point

now measure diagonally from the 3 foot point to the 4 foot point and you should have a 5 feet reading-- if you have a 5 ft reading then you found the perfect square starting point and now cut a tile in a diagonal / half and set it in the corner of your calk line square. The rest is way too indepth so my advice is to "GOOGLE" How to lay ceramic tile to find your favorite how to video.

Good luck.

Measure the same length at a corner and snap a chalk line between the two points. Or start with a row of tile split corner to corner and lay off of them. It's really no big deal.

There are 10 yards in 30 feet.

Rubber Cove Molding or Cove Base. It can be found at Lowe's Home Improvement Center and other retailers even though it is commonly used in commercial applications such as restaurant kitchens, public restrooms, and other places liquids need to be contained.

yes--I am not sure how to reply on here, just signed on--I need one or two boxes of the laminate, shipping to NC, 28072--what is your price, and can you ship to me?

lac

I don't know why gin stains vinyl tile, but we've found that Magic Eraser does the job of removing it. However, it leaves a dull spot, so you need to apply some floor wax after removing the stain.

It really depends but it can get up to 100 dollars a month.

I like to wait 24 hrs after they are set in te thin set before grouting then another 24 hrs after grouting before everyday use. Hope this helps.

yes, but use carefully

difference between the manufacture of bricks and manufacture of tiles

when Venetian craftsmen discovered a new use for discarded marble chips. Terrazzo is made by mixing pebbles or chips of stone or glass in cement, then polishing the surface to make it smooth

the installation of asphalt tile, carpeting, linoleum, and resilient flooring. The industry also includes special trade contractors engaged in laying, scraping, and finishing parquet and other hardwood flooring.

Yes you can lay over travertine as long as they are stuck well , there are products available such as ultrabond which combined with the correct glue makes job less messy and totally guaranteed

15 tiles exactly.

Area of hallway = 5ft * 4ft = 20 sq ft Cost of carpet = 2.50 per sq ft So cost of 20 sq ft = 2.50*20 = 50.00

Usually depends on type of tile, pattern, etc. Generaly 4/6$ a sq ft.

A FLOOR PRODUCED FROM A MIXTURE of calcareous or silicious aggregates bonded with coalter pitch

For a 12' x 10' area you would need 13.33 square yards of carpet.

12 x 10 = 120 / 9 = 13.33 sy

I was shocked when this happened to me - in a panic, I grabbed the Windex and cleaned the floors, then went over them again with the Bona. This seemed to do the trick.

fabric that are made of

Dricore claims it will raise the temperature 6F degrees, Barricade 15F degrees. There are some reports that Dricore can retain water in the plastic dimples (like a bathtub). Barricade on the other hand, due to its solid foam design, does not appear to channel water as well, despite a claim of x grooves.

Get magic eraser and rub on floor until gone. If you get permanent marker on granite, get nail polish remover and rub until gone. If you get permanent marker on your skin, get a magic eraser and rub.

168

You should buy 122 sq ft of tile. Since a 12" x 12" tile are 1 sq ft you will need 122.