0
Ford Excursion
The Ford Excursion is a full-size SUV produced between 2000 and 2005 by Ford Motor Company. It was based on Super Duty pickup truck platform and served as the largest SUV in its line up.
364 Questions
How much oil does your 6.8 liter excursion take?
For a 2000 to 2005 Ford Excursion , with the 6.8 liter gasoline V10 engine :
With engine oil filter change :
( 6.0 U.S. quarts / 5.7 litres of engine oil )
Where is the ecm on a 2000 ford excursion?
On the driver side kick panel. Remove dash panel next to fuse box.
What is the engine oil capacity in 2000 ford excursion 7.3 diesel?
oil capacity in 2000 7.3 is 14 quarts
Can you convert second row bench into captain chairs in a ford excursion?
You can switch the bench for captains chairs. The bolt holes are in the floor under the carpet.
Why does your 2002 Ford Excursion keep shutting off and jerking?
vehicle speed sensor or threw a plug; common problem look online under recalls and you will see information on it
You hear a sound in the rear of your expedition when you take off what could it be?
It depends. If the sound is a sharp "Tink!" that only happens when you step on the gas from a standstill then it could be a universal joint getting loose. The universal joint is a connection between the drive shaft and your rear end. No not your rear end, that would be silly. The rear end of your expedition where it goes into the rear axle. I would get it looked at as soon as possible.
Where is the timing sensor located on a 1997 7.3 turbo powerstroke?
it is located on the front of the engine.
crawl under the tuck on the passenger side and look up.
you should see the big pulley and at the top passenger side is a metal piece
that stick out. And right above it is the nut that holds it on the nut size is 10mm.
How do you change a rear turn signal on a 2003 ford expedition?
To replace the rear turn signal on a 2003 Expedition you have to first remove the tail light assembly. There are two screws holding the assembly in place. They are located on the inside of the assembly so you will have to open the rear hatch to get to them. You will need a T20 Torx Driver to remove these screws. Once you remove these screws the tail light assembly will pull out towards the rear of the vehicle. It is held in place by four guide pins but with a minimal amount of force you will be able to pull the assembly out. Once the assembly is out you will be able to twist and pull the light socket out of the assembly. Replace the burnt out light with a new bulb, pop the assembly back into place and replace the Torx screws. Test and your done! I had to do this today with no help. I figured i'd pass on some knowledge to anyone who is in the same boat I was in.
Exactly where is the input for a trailer brake controller on a 2005 Excursion?
Most trailer brake controllers require 3 or 4 "inputs" and have 1 output. Ground, any point on the vehicle metal frame. Power, any fused connection that provides power when the key is on. some controllers don't use a power connection. You'll need to refer to the owners manual that came with the controller. Brake light, a signal from the brakes indicating that the brake pedal has been depressed. The output goes to the trailer plug pin that controls your trailer brakes.
