Ford Transit Connect

To release the spare wheel on a Ford Transit van, locate the spare wheel release mechanism, typically found under the rear of the vehicle. Use the provided crank tool or a wrench to turn the release mechanism counterclockwise, which will lower the spare wheel from its storage position. Ensure to pull the wheel out carefully once it's fully lowered. Always refer to your owner's manual for specific instructions related to your model year.

To release the jack in a Ford Transit Connect van, first locate the jack handle, which is typically stored in the rear of the vehicle. Insert the handle into the jack mechanism and turn it counterclockwise to lower the jack. Once the jack is fully lowered, you can remove it from its mounting location. Make sure to stow the jack and handle securely back in the van after use.

On a Ford Transit Connect, the fuse for the reverse lights is typically located in the fuse box under the dashboard or in the engine compartment, depending on the model year. You can usually find the specific fuse listed in the owner's manual or on the diagram located on the fuse box cover. For many models, it is often a 10-amp fuse, but it's best to verify with the manual for your specific year and configuration. If the reverse lights are not functioning, check the fuse first before considering other potential issues.

On a Ford Transit Connect, the engine block heater plug is typically located near the front of the vehicle, often on the driver's side. It is usually found near the engine bay, close to the grille or front bumper area. Look for a thick cord with a three-pronged plug, which may be secured with clips or tucked away for protection. If you're having trouble locating it, consult the owner's manual for specific guidance.

In a Ford Transit Connect T200, when the diesel warning light comes on, it typically indicates that there is about 5 to 7 liters of fuel left in the tank. This amount can vary slightly depending on driving conditions and vehicle load. It's advisable to refuel soon after the warning light activates to avoid running out of fuel.

Have you had the vehicle code read. if not, check the crank sensor for position they do have a tendancy to move. getting it code read would be the first option though.

The fuse box is located under the dash/instrument cluster to the left of the brake pedal. There is a plastic cover that is held on by about 4 screws on either side that must be removed to expose the fuses. You can get away with only taking off the front side of this "cover" by removing the screws located under the steering column. However make sure you put everything back exactly how it came off because the screws will eventually fall out and you will have plastic hanging down basically from the ash-tray to the parking brake. This happened on my '79 Coupe.

The 2012 Ford Transit-Connect's engine produces 128 ft-lbs. @ 4750 rpm.

Normally just below a hole...