answersLogoWhite

0

🚗

GMC Yukon

The GMC Yukon is a full-size sport utility vehicle manufactured by General Motors from 1992 to the present. The car is available as either a two-door or a four-door model. It features a front engine and a rear/four-wheel drive.

1,653 Questions

What is the gross vehicle weight of the 2014 GMC Yukon?

The gross weight of the 2014 GMC Yukon is 7100 lbs..

What is the drivetrain warranty on the 2013 GMC Yukon-XL?

The drivetrain warranty of the 2013 GMC Yukon-XL is 5 yr./ 100000 mi..

How to install a heater blower motor in a 1995 GMC Yukon?

you might need to remove the black air ducting on the inside, and the glove box area the heater core is behide the glove box ( be carefull not to break the black box that is the air duct and your a/c won't work if you do) I think it has two lines that run in to it you will have to work with it to get it out, it takes time and patience it will come out from the under of the glove box on the inside of the truck (I hope this helps you out)

Where is the fuel filter on a 1997 GMC Yukon located?

fuel filter is located on driver's side frame rail about half way back from engine

How long is the 2011 GMC Yukon?

The 2011 GMC Yukon is 16 ft. 10 in. (202 in.) long.

How do you replace marker lights on a 2008 gmc Yukon Denali?

You can replace the marker lights on a 2008 GMC Yukon Denali by removing the retaining screws and disconnecting the wiring harness. The bulb can then be unscrewed and a new bulb put in place.

What is the difference between 10w-30 and 10w-40 engine oil?

The recommended temperature range are as follows

10w30: -13 F to 100 F (-25Celsius to 38Celsius)

10w40: -13 F to no limit (-25Celsius to no limit)

In other words the difference between the two oils You are hesitating is, the 10w40 has same performance at low temperatures, but works well also above 38C/100F

What kind of transmission does the 2013 GMC Yukon have?

The 2013 GMC Yukon has a 6-speed shiftable automatic.

Can you sell your used car to a dealer and not buy a new car from them?

It's legal, but unlikely ... unless you have a very desirable car.

How do you reset the ecm of a 1999 gmc Yukon?

remove the negative battery cable for a minute or two

Picture of fuel filter location 2005 GMC?

You do not need a photo. Just follow the fuel lines from the fuel tank to the engine and you will find the filter. If you find no filter then the filter is a permanent filter inside the fuel tank that is replaced when the fuel pump is replaced.

What is the curb weight of the 2005 GMC Yukon?

The curb weight of the 2005 GMC Yukon is 4975 lbs..

How tall is the 2008 GMC Yukon?

The height of the 2008 GMC Yukon is 6 ft. 4.9 in. (76.9 in.).

2005 gmc Yukon that the front air conditioning comes on when it wants but the back air works great what could be the problem?

The first thing that you should check is the wiring going to the blower fan for the front evaporator. If that's not the case you should unplug the fan turn your key on turn the fan on high then check to see if you got 12.6 volts at the connector. If you do replace your blower fan. If not it is possibly a power control module for the blower fan. You should have a technician verify that before you buy that because it is a coslty item.

Hope this helps.

How do you program your garage door opener in your 2003 infiniti G35?

To begin, press and hold the 2 outer

HomeLink buttons (to clear the memory)

until the indicator light blinks slowly (after

20 seconds). Release both buttons.

Position the end of the hand-held transmitter

1-3 inches away from the HomeLink

surface.

3. Using both hands, simultaneously press

and hold both the HomeLink button you

want to program and the hand-held transmitter

button.

DO NOT release the buttons until step 4

has been completed.

4. Hold down both buttons until the indicator

light on the HomeLink flashes, changing

from a "slow blink" to a "rapidly flashing

blink". This could take up to 90 seconds.

When the indicator light flashes rapidly,

both buttons may be released. The rapidly

flashing light indicates successful programming.

To activate the garage door or other

programmed device, press and hold the

programmed HomeLink button - releasing

when the device begins to activate.

5. If the indicator light on the HomeLink

blinks rapidly for two seconds and then

turns solid, HomeLink has picked up a

"rolling code" garage door opener signal.

You will need to proceed with the next steps

to train the HomeLink to complete the

programming which may require a ladder

and another person for convenience.

6. Press and release the "smart" or "learn"

program button located on the garage door

opener's motor to activate the "training

mode". This button is usually located near

the antenna wire that hangs down from the

motor. If the wire originates from under a

light lens, you will need to remove the lens

to access the program button.

How long is the 2014 GMC Yukon?

The 2014 GMC Yukon is 16 ft. 10 in. (202 in.) long.