0
Honda ATVs
Honda makes a full line line of ATVs. Some of their models have included the Rincon, FourTrax, and the TRX series.
666 Questions
Where is the fuse box on a Honda rancher 4x4?
The fuse box on a Honda Rancher 4x4 is typically located under the seat. To access it, you need to remove the seat by loosening the latch or bolts, depending on the model year. Once the seat is removed, the fuse box will be visible, usually near the battery or on the left side of the frame. Always refer to the owner's manual for specific details related to your model.
How do you set the timing on a 1985 250sx Honda ATV?
To set the timing on a 1985 Honda 250SX ATV, first, ensure the engine is at top dead center (TDC) on the compression stroke of cylinder one. Remove the timing inspection cap and align the timing mark on the flywheel with the index mark on the case. If adjustments are needed, loosen the ignition timing plate bolts and rotate the plate until the timing mark aligns properly, then tighten the bolts securely. Finally, recheck the timing to ensure it remains accurate.
What is the rear axle nut torque spec for a 1996 handa fourtrax 300 ATV?
The rear axle nut torque specification for a 1996 Honda FourTrax 300 ATV is typically around 50-60 ft-lbs. It's important to use a torque wrench to ensure proper tightening and to avoid damaging the axle or components. Always refer to the owner's manual or a service manual for the most accurate specifications specific to your model.
How do you remove carburetor from 2006 Honda rancher?
To remove the carburetor from a 2006 Honda Rancher, start by disconnecting the negative battery cable for safety. Then, remove the air intake duct and throttle cable, followed by the fuel line and any electrical connectors attached to the carburetor. Finally, unbolt the carburetor from the intake manifold and carefully pull it free. Make sure to keep track of any gaskets or seals for reinstallation.
How do you remove front axel on 1985 Honda ATV big red?
To remove the front axle on a 1985 Honda ATV Big Red, first, lift the front of the ATV and secure it on jack stands. Remove the wheel nuts and take off the front wheels. Next, disconnect the brake caliper and any other components attached to the axle. Finally, remove the axle nut and slide the axle out of the hub, taking care to support any remaining components as needed.
What kind of oil for 420fe Honda rancher?
For a 420FE Honda Rancher, it's recommended to use 10W-40 motor oil, which is suitable for a variety of temperatures and provides good protection for the engine. Honda also recommends using their own brand of oil, such as Honda GN4 or HP4, which meets the necessary specifications. Always check the owner's manual for specific oil recommendations and maintenance guidelines.
