Where is crank sensor on 99 jeep 4.0 grand Cherokee?
driver side on the back of the motor
where is crak sensor on 94 jeep 4.0 grand Cherokee
1993 Jeep Grand Cherokee windows don't work?
check the wires that run through the door inside the rubber boot they tend to crack and break if so just solder in a piece of wire done deal...............hey i just had this prob. i had to change the ignition switch but i also had no instrument lights or turn signals.was told all or some of these can go either way i changed the switch and it works again! good luck , wolf
What is the socket needed for the headbolts on a 98 Cherokee straight 6?
12 point 9/16 inch deep wall.
the fluid is a lube it soaks the pully makes the belt slip off. now as far as the leak you need to look around the fitings while the truck is running look at all the hoses you may have a hose that has a hole it it make sure the hoses are not rubbinr on any thing.
How safe is a 1998 Jeep Grand Cherokee with a lift?
Me friend has a 1995 (same model as yours) jeep grand Cherokee with a 4in lift and it seems to be fine. I have a 1998 grand Cherokee and am thinking about putting some spacers in it.
How do you change a rotor on a 1998 Jeep Cherokee Sport?
Jack it up (make sure to use jack stands), remove tire. I assume you are talking about front rotors as the back is a drum. There are 2 12mm bolts on the back side of the caliper that need to be removed then the caliper should be easily removed from the rotor. At this point the rotor will just slide off the hub.
In MOST cases making the repairs suggested or at least checking the connections (loose lamps show up as 'failures') will clear the codes from the DIC the next time you run the vehicle. In other instances you may have to disconnect the negative battery cable, wait 5 minutes and hook it back up. Killing the static power from the battery will erase the computer codes and reset everything. The drawback is you also have to reprogram your radio if you have preset stations.
Will a fuel tank from a Jeep Grand Cherokee fit a 1974 Dodge Ramcharger?
It is not a direct fit, any thing is possible.
How do you program a keyless transmitter on a 1998 5.9 Jeep Grand Cherokee?
According to the owner's manual that came with the car, page 15 says that the programming of the remote keyless entry, to stop the doors from automatically locking is to be done by the dealer. If you are trying to program the garage door opener in the visor to open the garage door, try reading the owner's manual, page 42-46. Very specific. be sure to follow the directions to a T. If all else fails the manual gives a telephone number for Homelink, the company that makes the system and suggests that you call their hotline. .
Where is the crank position sensor in 2000 jeep grand Cherokee with v-8?
It is above the starter. You must remove the started to get at the CPS. There is one bolt that holds the CPS in the block.
What size Allen wrench to loosen the rear disc brake caliper bolts on a 2004 jeep grand Cherokee?
7MM
Airbag and seat belt light stay on after changing a fuse in your 04 grand jeep Cherokee?
Change the computer module with a new one. Tricky one to figure out I had those lights on forever. Enjoy.
How do you remove rear headrest 2000 Grand Cherokee?
On my jeep there is a button to push to go down on the left rod and one on the top of the headrest on the right side to make it go up but on the bottom right rod on the vinyl ring facing the rear window you can push it in and i believe that is the locking mechanism I push that in and the button on the bottom left and it released the headrest came right up...i'm sure you have to push that button back in when you want to put the back in as well. Hope that helps.
How do you install the fuel filter on a 1995 Jeep Grand Cherokee Larado?
The fuel filter is in the gas tank. You have to drop the tank and replace the paper filter
What cylinder is number 1 on a 1998 Cherokee 4.0?
The cylinders are numbered from radiator end to transmission end 1-2-3-4-5-6
I have been looking for the same thing. My mirrors "search" almost every time I use the keypad to open the door locks. They usually need resetting after every door opening sequence. I plan on locating the power source and interrupting it with a switch under the dash so the mirrors are disabled unless the switch is activated. The owners manual has no diagrams and in-fact does not instruct you on how-to set the mirrors for driver 1 and 2--very poor. Is it any wonder our domestic car sales is down and the companies are losing billions of dollars? I'm certain it would cost several hundred dollars for a new circuit board and even though my Jeep has less than 70K miles on it and looks like new that is a big expense.
A short in the brake light circuit.
If the key will not work in the door or the liftgate, you will need to call a locksmith or break a window.
1996 Jeep Grand Cherokee won't stay running?
it most likely is do to the security system being armed. try taking the key and turning it to unlock the door.
Will Jeep Grand Cherokee parts fit a Jeep Cherokee Sport?
Some will, such as wheels from the same year. Others won't , such as fenders.
Where is a neutral safety switch located on a 2007 Jeep Grand Cherokee?
It is on the valve body inside the transmission.