John Deere

Fram PH7575 is what I use on my STX38.

Purolator L34361

There are several numbers

492056

492932

492932S

5049

696854

842921

All of which can to fulfilled using one Wix Filter 57035

15w40

No the drive belt and Deck belt are two different belts, one powers the rear wheels, the other powers the deck.

though if you are asking if they are the same belt as in same size, I don't know, you'll have to check your owners manual or talk to someone who repairs or can get parts for Cub Cadet mowers.

I've checked a number of cross references and did not find anything. It does not appear that an aftermarket part is currently available, probably because the filter rarely needs changing.

Briggs & Stratton makes the 190 cc 4-cycle engines for these units, and B&S recommends their own oil, which is SAE 30W for use in the engines. As it is almost impossible to find motor oil on the market that isnot SAE rated, just about any SAE 30W motor oil will work. It's up to you. Just be sure to follow the manufacturer's recommendations regarding draining and replacing the oil. And Mother Earth will appreciate it if you recycle that (approximately) 20 ounces of oil you (carefully) drain out into an appropriate container. A link can be found below so you can check facts and learn more.

Fram PH8170 or PH3656. Also crosses to Briggs and Stratton 492932 (Available at Home Depot and Lowe's). AC Delco PF1279

8 qt>

year model of kubota m9000 sn 50482

Oil weight for John Deere 826 snowthrower

so you can see the battery after dark!

Around 95 to 100.

if it is the 3 cyl. disel motor. mine was made by YANMAR hope that helps.

It uses a 12 volt lawn mower engine battery.

PH8A or Wix 51515

Find the starter and follow the heavy gauge wire from the starter. It will go to the starter relay or battery. If it goes to the relay then follow the heavy wire from the relay which will go to the battery.

There is a four-sided inset plug on the underside of the JS30 John Deere lawnmower. You'll see it near the blade shaft. That is your oil drain plug. You need to loosen the belt guide nut a little to swing the belt guide out of the way. A 3/8" ratchet extension exactly fits this plug. Place a plastic bag underneath the lawnmower to catch the oil. There isn't much. To get all the oil, drop the mower down completely for a minute or so. Remember, before you do this, pull the spark plug wire to keep the mower from starting unexpectedly.

no, but there is an inline filter.

M150949

10w-30

I just did this today. Remove the drain plug located on the bottom of the rear axle. The reservoir contains 5 qt's when full. Add transmission fluid to the filler hose located just above the dash under the hood.

PH4386

hd 30 weight oil of your choice.

1.9 Qts.