Does the 2009 lancer de have a mivec engine?
YES - standard engine in the Mitsu Lancer is DOHC 2.0L MIVEC making 152HP http://www.motortrend.com/cars/2009/mitsubishi/lancer/de_sedan/543/specifications/index.html
How many horsepower does the engine in the 2014 Mitsubishi Lancer have?
The 2014 Mitsubishi Lancer's engine produces 148 hp @ 6000 rpm.
What kind of transmission does the 2014 Mitsubishi Lancer have?
The 2014 Mitsubishi Lancer has a 5-speed manual.
Go to the Doctor. and they will x-ray you and most likely put you in a cast. Once out of a cast you will want you want to start moving it around as much as possible. Ice if any swelling occurs.
Replacing an automatic transmission how much will it cost?
Write a longer question. We need to know what kind of car. I'm in Reno NV and they replaced mine (Ford Taurus) with a rebuilt transmission. It cost me $3,000 but that includes labor.
How do you change a Mitsubishi lancer dome light?
remove the broken one and replace with a new and working bulbs.
What is the oil capacity for a 1992 Mitsubishi Lancer?
the oil capacity for the lancer model is 3.5 ltrs
How do you disconnect day time running lights lancer?
On a 2008, fuse 13 (10 amp) located inside the fuse box in the engine bay controls your DRL. Removing it should disable your lights.
What is the problem when your car steering wheel vibrate?
Normally it is a tire out of balance. Can also be a bent wheel.
What is the bolt pattern for a 2003 Mitsubishi lancer Is is 4x100 or 4x114?
All Mitsubishi Lancers newer than 1993 models should be 4x100 I believe. I think the only exceptions are Mitsubishi Lancer VRX and EVO models, being 4x414. Refer to site listed in related links for a full list.
You take a bearing by pointing your compass at the target (or direction you want to go) and reading the number on the compass. There are 360 degrees in a circle, with East being at 90 degrees, South-East being 135 degrees, South being 180, West 270, North 360 (or zero) and etc. etc.
What is the best cold air intake for a 09 Lancer GTS?
Well that is really an opinion question. Either the Injen Cold Air Intake or a Short Ram Intake. i forget what the difference is between the two. i know one gives more tq and the other more hp. but you will have to research that. I have an 08 Lancer with the Injen CAI, and i personally love it. But then again i believe it is an opinion question.
What are the tappet settings or valve clearances for a 1999 Mitsubishi lancer?
Intake 0.2
Exhaust 0.3
How much would it cost to replace the front catalytic converter on a 2002 Mitsubishi lancer?
I checked with mineke and for the parts and labor it was 800, the rear is MUCH cheaper! Sucks b/c this is a small car and you wouldn't expect it! Mine has been bad now for months and my engine light stays on but ima ride it till i cant ride it no more!!
Where is the fuel filter located on a Mitsubishi Lancer?
My girlfriends car does not have one, unless there is one built into the fuel pump in the tank. I would suggest just putting an inline filter on a fuel line under the hood, but be advised those hoses have fuel under pressure, usually there is a procedure to remove the pressure, but I dont have a manual handy to check at the moment (my 90 escort had an inline that you had to release the pressure before changing the filter).
they use a carbon cannister(big black cylinder on bulk head above gearbox).however the procedure for easing the fuel pressure is to remove the fuel pump fuse and starting car til it runs dry.
But Be Careful!
Fuel systems with today's fuel injection systems are constantly under pressure when the car is running, so if you do install an inline fuel filter, ensure that it will work with a pressurized fuel system.
This was much easier on the older carburated engines, because their fuel systems did not have the high pressure of today's vehicles.
Replacing motor mounts on Mitsubishi lancer?
I just replaced my back engine mounts on my 2003 mitsh. lancer. It cost me $214 at a Mitsubishi dealership in Queens, NY. Unfortunately, I had to go to the dealership because no other auto store or shop had the parts. My engine & car was jumping/jerking whenever the car was in reverse or drive. Scary. After I got the back mounts on (because there's two - front and back). Now I have a stuttering/jerking problem but based on diagnostic test it's my coils that have to be replaced.. oh boy :)
Why your lancer es got a rough idling when you change the battery?
the computer takes a bit to adjust and resample the air and O2... it should clear up in a few seconds maybe a minute...
Is the Mitsubishi Lancer Evolution a two seater or four seater car?
The Mitsubishi Lancer Evolution is a two seater car. However, if you are willing to fork the extra money over, you may be able to get a four seater car.
What type of oil does a 2004 Mitsubishi Lancer use?
A 10w-30 oil may be used, however a 5w-30 would flow better at start up.
Keep in mind, both are a 30 weight oil. 5w-30 will will also flow better at cold temperatures.
The oil recommended by Pennzoil's Lube Match is 5W30.
Always check your owner's manual or the sticker on the inside of your hood to be sure of the recommended oil type for your particular engine. Using the wrong oil could cause engine damage.
What is the oil capacity for a 2004 Mitsubishi Lancer?
The 2004 Mitsubishi Lancer with the 2004 4-cylinder has an engine oil capacity of 4.5-quarts with the filter. Oils recommended for this application are based on use and temperature from API 5W20, 5W30, and 10W30.
Who will win in a race lancer evo or srt4?
i have an 03 srt4 and i smoke evos all the time but i have a lot of upgrades so it depends on the car and the driver i am puttin about 270 hp at the wheels with 15lbs of boost top speed of over 170mph but that is street racing not track so like i said it depends on a lot of factors
happy motoring
Stock for stock EVO wins by a tiny bit but being that i paid 10k for my SRT that's making a little better numbers than the dude above and mines an 05 with 52k miles on it the SRT wont be beatin money for money bein that the 03 stock evo;s sell for about 8-13k depending on where there at
What metal is used in nuclear reactions?
The following metals are involved in nuclear reactions. The preferred metal is Uranium 235. The next one is Plutonium 239. Important radioactive metals are Thorium and Cobalt 60. Important radioactive elements that are not metals include Radon and Iodine.
Advantage and disadvantage of using cone clutch?
The normal force acting on the contacting surfaces in case of cone clutches is more than axial force ,as compared to in single plate clutch in which the normal force acting on contacting surfaces is equal to the axial force.