Saturn S-Series

To replace the engine mounts on a 1999 Saturn SL2, first, securely lift and support the vehicle with jack stands. Remove any components obstructing access to the mounts, such as the air intake or battery. Unbolt the old engine mounts using a socket wrench, then position the new mounts in place and tighten the bolts to the manufacturer's specifications. Finally, reassemble any components you removed and lower the vehicle.

On a 1997 Saturn SL1, the crankshaft position sensor is located on the engine block, near the oil pan and behind the starter motor. It is positioned towards the rear of the engine, where it can detect the position of the crankshaft. You may need to remove the starter for better access to the sensor during replacement or inspection.

To fix a 1999 Saturn SC2 speedometer, first check the vehicle's speed sensor located on the transmission; a malfunctioning sensor can cause inaccurate readings. Inspect the wiring and connections for damage or corrosion and replace any faulty components. If these steps don't solve the issue, consider replacing the speedometer gauge itself or the instrument cluster, as internal failures can also affect performance. Finally, consult a professional mechanic if the problem persists.

The cost of replacing a timing belt on a Saturn LW300 station wagon typically ranges from $500 to $1,000, depending on the labor rates in your area and whether additional parts, such as the water pump or tensioners, are also replaced. It's advisable to check with local mechanics for specific quotes, as prices can vary significantly. Regular maintenance and timely replacement can help prevent more costly repairs in the future.

To add R134a to a 2002 Saturn SL, first ensure the engine is off and the AC is set to the maximum cool setting. Locate the low-pressure service port, which is typically near the AC compressor; it has a larger diameter than the high-pressure port. Attach the R134a refrigerant can to the low-pressure port, following the manufacturer's instructions, and open the can while the engine is running and the AC is on to allow the refrigerant to flow into the system. Monitor the pressure and avoid overfilling, as this can damage the AC system.

The value of a Saturn S-Series can vary significantly based on factors such as its model year, condition, mileage, and market demand. Generally, prices for used Saturn S-Series vehicles range from a few hundred to several thousand dollars. Older models in good condition may be valued higher among enthusiasts, while those in poor condition will be worth less. It’s advisable to check local listings or automotive valuation websites for the most accurate assessment.

If your 2002 Trailblazer cranks but won't start after the battery died, it could be due to several issues. First, check if the fuel pump is functioning and whether there's fuel in the tank. Additionally, inspect the fuses and relays related to the ignition and fuel systems, as they may have been affected by the battery issue. Finally, ensure that the battery is fully charged and that the connections are clean and secure.

To program a new remote keyless entry for a 2006 Saturn Ion 2, first, sit in the vehicle with all doors closed and insert the key into the ignition. Turn the key to the "On" position and then back to "Off" five times within 10 seconds, ending in the "On" position. After the locks cycle, press and hold the "Lock" and "Unlock" buttons on the remote for about 15 seconds, then release them. Finally, turn the ignition to "Off" to complete the programming process.

For a 1998 Saturn SL2, the oxygen sensor typically requires a 22mm wrench or a 7/8-inch wrench to fit properly. It's often recommended to use an oxygen sensor socket for easier access, especially in tight spaces. Ensure to check the specific sensor type, as some may vary slightly.

The head bolt torque specification for a 2003 Saturn L200 is typically 70 ft-lbs (95 Nm) for the initial torque, followed by an additional 90 degrees of rotation. It's important to follow the correct sequence and procedure outlined in the service manual to ensure proper sealing and avoid warping the cylinder head. Always double-check with the manufacturer's specifications for any updates or variations.