0
Saturn S-Series
The first series of Saturn cars, the Saturn S-Series was part of a compact car family produced between 1991 and 2002. It was available in sports coupe, sedan level and sedan wagon variants, with either 4-speed automatic or 5-speed manual transmissions.
2,389 Questions
How do you replace a shifter cable on a 1991 Chrysler New yorker?
Just finished fixing mine today, what a mess. Look at the shifter cable once you get it out. If its just a little bent then stick it in a vice, and tap on it a few times with a hammer to straighten it back out. After my original cable went out I went a bought a $40 aftermarket cable. The aftermarkets are cheap compared to the original, the aftermarket cable broke while installing and could not be salvaged. I ended up having to straighten out the original like i said above and reinstalling it. As for how do you install it? Its pretty simple just look at the way the original one is installed and do it the same way, all I can say is its not much fun, and its not very easy
How do you change the oil filter on a 1993 Saturn SC2?
The oil filter is located on the back of the engine (between the engine and the firewall) and is located on the passenger side above the oil pan. They are relatively easy to get off if you have an oil filter ratchet adapter available at your parts store. Make sure you get the right size if they do not offer and adjustable version.
Why does my transmission fluid in my 95 Saturn sc coupe have bubbles in it?
That is caused by cavitation. The fluid level is too high. Drain out the excess fluid.
How do i clear codes on 1993 Saturn sw3?
You either disconnect the battery for 1 min or remove the PCM B fuse in the unher hood juction box for 1 min
How do you change the coil on Saturn Sl1?
they are located behind radiator and intake muffler. there are a couple of bolts and they come out in sets of 2
What does the crankshaft position sensor on a 98 SL1 Saturn 1.9 SOHC look like?
Its under the intake manifold on the back of the engine. you may want to consider getting a haynes repair manual.
Where exactly is the neutral safety switch located on a 1994 Suzuki Sidekick?
if automatic its on right center line of tranny.
see where shift cable goes. see object with wires. bingo.
Change spark plug wires 2002 Saturn SL?
The Saturn SL, SL1 and SL2 all have spark plug wires. The current advice I have is to replace them one at a time, so that the timing of the engine is not changed. Changing the timing can ruin the engine. But... The wires go through two wiring holding brackets. And that back bracket is hard to get to. The following video gives some good ideas, and some good cautions, and completely fails to tell anyone how to remove those wires. http://www.youtube.com/watch?vGq5hRTjll3E This is also useful, but again, does not completely solve the problem: http://www.saturnfans.com/forums/showthread.php?t136307 I want advice on how to get to that last pair of wires. Here is how to do that:
There is a big plastic piece near the radiator.
It is held on by its shape and a small plastic thumbtack shaped 'pin'.
Remove pin with flat bladed screwdriver, remove plastic, and the spark plug wire harness is easy to get to. I am using a 7mm socket.
Sean
Where is the oxygen sensor in a 1999 Saturn?
You have two.Sensor one is located in the exhaust manifold.Sensor two is located in the exhaust pipe downstream of the catalytic convert.Check related links below for removal of sensor one.
How much should wheel bearing cost to be replaced on a 99 Saturn?
Cost me $50 for both sides. Bought the bearings off eBay and replaced them myself.
For the drivers side...brute force. You need to push the axle into the tranny until it seats flush. Sometimes doing the passenger side first is best so then you can jiggle the passenger side axle and it helps get the drivers side in. However Brute force will
ON the passenger side, push the axle in enough to line the axle to engine bracket up.
Where is the water pump located on a 2001 Saturn?
On the V6 L300 it is in the passenger side of the car directly below the motor mount. The bolts are behind the timing belt cover.
How do i Replace brake bulb on a 1995 Saturn twin cam?
you have to pull the tail light all the way out.The 2 screws are on the inside where you open your trunk.
How to set the timing chain for a 1995 sl2?
I am assuming you already have the timing chain off the vehicle, and you are looking for the timing marks. if not, please note, there is no manual adjustment on the timing chain. I have included a picture of the correct timing placement on my website http://thecommi.angelfire.com/index.html under Timing Chain. I hope this helps you.
How do you change a neutral safety switch on a 1997 Saturn wagon?
The neutral safety switch is located on the back side of the transmission where the trans shift cable is attached. Please visit my Bio for a link to my saturn help site, under transmissions you will find an image of the neutral safety switch.
Oil in spark plug chambers what is the problem?
You need a cam cover gasket and most likely the bolts that hold the cam cover on. The bolts have rubber dowels on them which are likely worn out due to over tightening
Will the rims of a 2002 Cavalier fit a 1999 Saturn SL1?
Cavalier is 5x100 witch is 5 lugs... The Saturn im almost positive is 4x100... Witch is 4 lugs
Where is the radiator fill cap located on a 2001 Saturn s series?
You fill it though the resivoir cap
What can cause a 1993 Saturn to crank but not not turn over?
Many possibilities. Fuel flow problem (fuel pump, clogged line, fuel injectors) Contaminated fuel. No spark or weak spark (bad plug, wires, electronic ignition module) No air flow (Clogged intake, clogged filter) Bad timing belt/chain (I can't remember which one a '93 has).
Where is the starter relay in a 1988 Toyota 4Runner?
On my 88 4Runner 22RE, the relay is located under the hood on the passenger side fender, just behind some sort of resister looking thing with cooling fins, a bit to the rear of the front tire, with a white plastic 4 wire plug.
How do you run a compression test for 2001 Saturn SL?
Running a compression test is pretty much the same for all internal combustion engines.
- Remove all sparkplugs, marking where the wires went; you don't want to connect the wrong wires to the plugs when you're finished.
- Start with cylinder 1, screw in a compression gauge where the sparkplug just came out. Some compression gauges just press in, but I prefer the screw in type.
- Have an assistant engage the starter as though trying to start the engine. Obviously the engine won't start without plugs.
- You should hear and/or feel the engine compression on the single cylinder with the gauge in place; make sure that cylinder goes through compression cycle at least 3 times.
- Read the value on the gauge. The gauge should hold the compression reading, allowing you to record the reading.
- Write down the compression reading and the cylinder number.
- CLEAR THE COMPRESSION GAUGE. You can release the compression reading, usually by pressing a button or turning a knob. It's different for different style gauges.
- Repeat the process for all cylinders.
- Compare the compression value for all cylinders; they should be within a few percent of each other. Any small variance can be attributed to cylinder or valve wear. Large differences indicate severe problems. If any two adjacent cylinders have zero compression, you probably have a blown head gasket.
Does it have a reset switch for the fuel pump on a Saturn sl1 94 model?
There is no reset switch for the fuel pump on any s-series
Where do you find a free cooling system diagram for a 2002 Saturn SC2?
You can find a free cooling system diagram for a 2002 Saturn SC2 in several places online. Websites like AutoZone or RepairPal often provide free repair guides and diagrams with user registration. Additionally, automotive forums and enthusiast sites may have diagrams shared by members. Lastly, you can check out resources like YouTube for instructional videos that may include diagrams.
