answersLogoWhite

0

Saturn S-Series

The first series of Saturn cars, the Saturn S-Series was part of a compact car family produced between 1991 and 2002. It was available in sports coupe, sedan level and sedan wagon variants, with either 4-speed automatic or 5-speed manual transmissions.

2,389 Questions

Where is the battery on a 2007 Saturn outlook?

It is located behind the passenger seat in the floor under a panel (under the floormat).

Will 205-70-15 fit in the fender wells of a 1999 Saturn SC2?

"Fit" is a relative term. Yes, they'll go into the space provided, but they will rub whenever you turn the wheel.

How do you turn off car alarm in 1997 saturn sl?

We got it off had to move the battery around in the remote keyless entry...then the doors unlocked and the car will start now...Thx anyway :)

Why does your tire wobble?

If you mean it's running "untrue" at low speed, it's either a bent rim or a "slipped belt", meaning that the internal structure of the tire has a problem.

What happens when an automatic Saturn SC2 1999 transmission overheats and buckles while in first gear and wont shift into second?

Few possible problems. Most likely a loose input shaft nut. A new one torques to 110 ft/lbs along with fluid and filter changes every 10K miles should fix the issue.

How do i check the Manual transmission fluid in a 99 Saturn sl?

If you look straight down,standing on the driver side by the wheel, between the battery and the brake fluid reservoir, you will see a red handle dip stick, this is also the refill hole.

Have a 95 Saturn sl2 what causes the car to do a little backfire then check engine light comes on starts to shake and lose power changed every sensor in it?

You have changed ever sensor? That's expensive! I had a similar problem on my SL1 and it was the coolant sensor. The little pin inside (where the wires were attached) was broken off, so the problem exhibited different symptoms when it jiggled around (making contact whenever it wanted to!!!). So...sensors are good...maybe check the connectors? Sorry I cant be of more helpRon

Answera buddy had a 91 its was doing evedrything under the sun wouldn't shift rough idle turn off back fire everything turn out to be the computer $40 at local junk yard 15mins of work all fixed

What do you need to do if the security light on your 2001 Grand Am keeps coming on?

this happens to me every time i wash the car...solution is to put the key in the on position and wait for 10 minutes. it will clear the path lock sensor and turn off the light.

What would cause a rich reading on the O2 sensor 93 Saturn SL2 Have replaced sensor reading persists?

Have you replaced your air filter lately? If not, try that, reset the computer by unplugging the battery and see if it clears the code.

2001 s that will not shift to 2nd runs fine in first and reverse?

assuming you have an automatic transmission, the most probable cause of your shifting issue is a faulty valve body. The valve body houses the control solenoids for shifting. The valve body also directs fluid to its correct location when needed. there are some instances when replacement of the solenoids can cure the issue. If you have access to a OBD II scan tool. check for stored codes for faulty solenoids. The Saturn dealer sells a valve body package complete with instructions on how to replace the unit for around $700

How do you replace the battery on a navman s90i?

1. Remove the 2 small screws on the base of the unit

NB: The base does not detach.

2. Carefully remove the 2 side Grey side strips. They clip on. Use a watchmakers screwdriver to prise them off if required.

3. Remove the four screws that have been exposed.

4. Gently separate the two halves of the unit.

5. The battery is visible. Gently remove and unclip the battery. and replace with a new battery.

CG: Factory batteries are ahered to base by a very good thin layer of double-sided sticky tape. Best to take a sharp knife and cut the old battery plastic casing in half, remove the old battery, then carefully remove the old casing from the base. Otherwise you might crack the electrical board trying to pry off old battery. You can then peel the sticky tape off the old battery case and use to adhere the new battery to the unit.

Note: The red battery wire should be furthest away from the battery when you reconnect it.

Note: I followed the above and it does work - it's very difficult removing the grey sides of the unit and I made quite a mess of the appearance of mine trying! They are quite firmly clipped on there.

What kind of antifreeze coolant would you use on a 1996 Saturn SL1?

Autozone/ advanced auto usually has antifreeze that goes with either kind. I suggest that.

How do you adjust the clutch on a 1995 Saturn sc2?

The SC uses an hydrolic setup, therefore there are no adjustments. However, some of the slave cylinders come without a bleeder screw, thus making difficult to bleed. The solution is to disconnect the connection line to the slave cylinder and pressure bleed the system, in addition, be sure to bleed the master first.

How after replacing strut due to accident damage do you adjust rear driver's side wheel or suspension to resolve excess negative camber on a 93 Saturn SC2?

there is a special tool to adjust the rear camber, as far as i know its only available through Snap-On. Most service garages do not carry this tool, but a dealer would.

What causes a car to jerk when driving?

There are several possibilities.

One: Transmission trouble...slipping bands(simple adjustment) or worn out parts (needing a rebuild or replacement).

Two: Motherboard controlling the engine operation could have a short in it or a crack causing confused signals to the engine.

Three: Bad Oxygen Sensor in the exhause pipe.

Four: Bad PCV Valve on the rocker arm cover.

Five: Very unlikely but it happened to me just once- broken spring controlling the return of the gas pedal. But that made the engine race more than anything else.

Should the trac button be engaged for normal driving conditions in a 1997 Saturn SC2?

"Trac" stands for traction. If/when the drive wheels slip the computer causes a deliberate misfire of the engine to reduce power to the wheels. The purpose of that power reduction is to prevent more wheel slippage since once the wheels start slipping, you have considerably less control.

Leave "Trac" engaged, it doesn't cause any problems during normal driving.

Why does the check engine light flash when accelerating and the car sputters and jerks?

AnswerA flashing check engine light means that something serious is wrong with the vehicle and you should not be driving it. Being that the vehicle sputters and jerks under acceleration, I would assume that you have a failure in your ignition system. Always have the car scanned when your check engine light comes on to obtain diagnosetic computer codes. Most common failure is basic maintenance items, Spark plugs and wires. Simple enough to replace, and relativly cheap. Ignition coils, ignition module, and crankshaft sensor would also cause a severe misfire. again... both pretty simple to change, but these items cost more. Start by having the vehicle checked with a scan tool first.

I had the same problem. It was the timing belt. If your Miata has around 100000 miles on it and the belt has never been changed it's most likely it. Timing belts are expensive to replace. You can change it yourself and save a ton of cash but be prepared to spend a few days working on it. Check out the Miata fan sites for step by step instructions!