0
Saturn S-Series
The first series of Saturn cars, the Saturn S-Series was part of a compact car family produced between 1991 and 2002. It was available in sports coupe, sedan level and sedan wagon variants, with either 4-speed automatic or 5-speed manual transmissions.
2,389 Questions
Will a 1996 Saturn subframe fit on a 1995 Saturn?
Yes, a 1996 Saturn subframe should fit on a 1995 Saturn, as both models belong to the same generation (the S-Series) and share similar designs. However, it's advisable to check for any specific differences in mounting points or components that might affect compatibility. Always consult a repair manual or a professional mechanic for precise guidance before making the swap.
Where is the ac fuse on a 1997 Saturn SC2?
The AC fuse on a 1997 Saturn SC2 is located in the fuse box, which is typically found under the dashboard on the driver's side. You can identify the correct fuse by checking the diagram on the fuse box cover, where it will be labeled. The AC fuse is usually designated as a 10A or 15A fuse, depending on the specific vehicle configuration. Always ensure the vehicle is turned off before inspecting or replacing any fuses.
What motor oil do you use for a 2002 Saturn sl-1?
The ATF power steering fluid is usually used for the Saturn SL 1. The Mobil 1 automatic transmission fluid can also be used.
Where is the ignition switch relay on a 2000 Saturn?
In a 2000 Saturn, the ignition switch relay is typically located in the fuse box. For most models, this fuse box is found under the dashboard on the driver's side or in the engine compartment. You can refer to the owner's manual for the exact location and identification of the relay. Always ensure the vehicle is off and the battery is disconnected before attempting any inspection or replacement.
How do you change the transmission for a Saturn 2001 SC2?
Behind the bulb you should be able to see the plug assembly; that's where the 3 wires are.
The plug assembly should twist off. Turn it counter-clockwise, it shouldn't turn far, but you will be able to tell, then the bulb should come right out.
When installing the new bulb take great care to not scratch the glass or leave fingerprints or other skin oils on the bulb.
Note that the plug assemblies are notorious for fusing to the headlight assembly, making it difficult to remove the old light.
Depending on which side it is, you may need to remove the battery or other devices that may hinder you access to the plug assembly.
Wiring diagram for Saturn sl2?
You can find a wiring diagram for a 93 Saturn in the vehicle's owner's manual. You can also check with local auto part stores.
Where is the fuse for the brake lights on a 2002 Saturn sc2?
I found it! It is on the passenger side, open door and there is a handle/ round half circle opening on the side of dash which needs to be pulled hard to pop off. I had checked this spot several times but didn't pull hard enough, cuz I didn't wanna break it.
Can you use dex cool in1995 Saturn sl?
No, it is not recommended to use Dex-Cool in a 1995 Saturn SL. This vehicle originally requires a different type of coolant, typically a conventional green ethylene glycol-based coolant. Using Dex-Cool can lead to potential issues, such as compatibility problems and the formation of sludge, which can harm the engine and cooling system. Always follow the manufacturer's specifications for coolant type.
How much does a horn cost for a 1998 Saturn SL-2?
About 50$ Canadian for OE or you can buy an A/M and chop wires If you have Keyless entry spend the $ for OE. It's not worth it
How do you turn the fog lights off on a 1999 SL2 homecoming edition Saturn car?
The switch for the fog lights is above the radio, next to the rear window defrost button and the traction control defeat button.
Where are the belt tension releases on a Saturn?
on my Saturn the tensioner was below ac compressor closer to center of engine you put wrench on bolt in center and turn clockwise and will move to loosen tension and will have to hold it there will removing or installing belt
Where is a airbag sensor on a Saturn SL2?
under the center console between the drier and passenger seats
How do you remove timing cover on 93 Saturn 1.9?
The timing chain cover on you 4 cylinder Saturn is ALSO the oil pump, so it's a significant part of the engine.
To remove the cover/pump:
- Jack up the front of the vehicle and put it on jack stands or other safe supports. Never climb under a vehicle that is not safely supported and never trust a jack.
- Remove the right side (passenger side) tire.
- Remove the mud shield to expose the pulley end of the engine.
- Remove the serpentine belt.
- Remove the dampener pulley (that's the pulley that drives the serpentine belt)
- Remove any peripherals that interfere with removing the cover.
- Support the engine then remove the upper passenger side engine mount.
- Remove the camshaft cover.
- NOW you can finally get to the timing chain cover.
Note that the Saturn 4 cylinder engines (1.9 either the single cam or dual cam) used an oil bath timing chain rather than a timing belt, and generally, if the engine has been properly maintained, there is no need to replace the timing chain until it's time to rebuild the engine.
Where is the blinker relay on a 94 Saturn?
under the radio, in the relay and and fuse box, gray relay
P0446 Evaporative Emission Control System Vent Control Circuit Malfunction. it could be that the evap system purge solenoid is not working properly.
Most likely cause(s):
If you operate the car in a high dust environment, you may have a vent valve and its filter that is plugged or you may have a plugged charcoal cannister (some GMC vent valve filters do not filter dust and dust fills the cannister). If you overfill the gas tank, look for a plugged cannister.
Other causes:
You may have a bad gas tank vacuum sensor or vacuum sensor circuit. Your engine vacuum valve may not open or close all the way, the coil might be open or shorted or its control circuit inoperative. As suggested above, your evap purge (vent) valve may leak when shut, have a shorted or open coil or the electrical control circuit to it might be inoperative. Likely things to check:
The vent valve is always open with electrical power off, so pull the hose off and with a hose and blowing with your breath, insure that gas will easily pass through the valve. If it is restricted, clean or replace the valve.
Pull all three hoses off the charcoal cannister and confirm that air will easily pass from the large vent side to the two smaller tubes and vice versa using a small rubber hose and pressure from your breath. Do not suck on the line. If it is restricted, clean by turning upside down and with low pressure air (block one of the small tubes), blow toward the vent valve side while sharply tapping the cannister and looking for dust coming out. If it is still restricted, replace the cannister. If the vent valve and cannister check out OK, you will have to trouble shoot each remaining component with a scan tool, vacuum gauge and other specialized test equipment.
Where would a starter relay be found on a 1993 Subaru Legacy 4door sedan?
Maybe on top of the starter Follow + battery cable should be connected to same
