0
Suzuki Forenza
Also known as the Daewoo Lacetti in some markets, the Suzuki Forenza is a car manufactured by GM Daewoo Auto and Technology Company. This vehicle has roomy interior, full power accessories, airbags, and a 2.0 L 4-cylinder engine.
329 Questions
Where is the power steering pump on 2006 suzuki forenza?
on the left side of the engine, right above the A/C compressor. you will have to remove the duct work to gain access to it, it has a big pulley on it
Where do you check the transmission fluid for a 2007 suzuki forenza?
the 2007 suzuki does not have a dip stick you must take it to a professional to get transmission fluid checked.
How do you replace the camshaft position sensor on 2004 suzuki forenza?
One would replace the camshaft position sensor on a 2004 Suzuki Forenza by taking it to a certified auto mechanic. The mechanic would then check out and repair the issue, thereby rendering the car back to a serviceable condition.
What is the box on the throttle body for a suzuki forenza?
I'd been trying to find the answer myself and finally did. It is called the air cleaner housing.
Why Both low beam lights dont work?
As of early 2008, there was a recall on a defective wiring harness that turns the Suzuki Forenza headlights on, the wiring literally frys, but this is covered under the recall, so go to your nearest Suzuki dealership and have the repair done, free of charge.
Why does a car shake only when accelerating?
Only when accelerating, I would suspect a broken motor mount or bad CV joint.
What is speed sensitive power steering?
When the car is driven at low speed, the power steering gives full assist so the driver can
turn the steering wheel easily. Parking or turning tight corners can be done with little effort.
As vehicle speed increases, the mount of power steering assist is reduced and the steering wheel becomes harder to turn. This gives the driver more feedback about road conditions through the steering wheel and better vehicle control. If an emergency arises and the driver needs to turn the steering wheel quickly, the full power assist is provided almost immediately after the wheel is turned only a few degrees.
How much does it cost to repair transmission sensors?
I had to have my transmission range sensor replaced today and it was $207 for parts and labor.
What type engine oil is used for suzuki forenza 2005?
I use 5w-30 in mine. valvaline. depending on what time of the year it is though (winter or summer) you'll want to use a thicker or thinner oil. sometimes in the summer if the oil is too thin, it triggers the engine oil light to come on. if u use too thick of an oil in the winter, you'll have trouble starting it. if been dealing with this for a couple years now. i bought mine in 07. hope this helps.
most motorcycles do not have separate tranny fluid, the motor oil is also lube for tranny.
Is the 2006 Suzuki Forenza engine an interference engine?
Yes , the 2.0 liter four cylinder engine in a 2006 Suzuki Forenza is an
interference engine ( according to the Gates website , they make timing
belts etcetera )
Where do you put the funnel to put transmission fluid in a 2004 suzuki forenza?
If it is an automatic, then there is not a place to put a funnel. The transmission comes from factory sealed with fluid. Unless there is something that I dont know :)...... There is something you don't know. There is a fill plug on the under the vehicle, but you can't fill it unless you can get under the vehicle and you have a special tool.
Where is the fuse box on a 2004 suzuki forenza?
The fuse box under the hood is right above the battery under a cover. Inside the vehicle, open the driver side door and it is on the side of the console.
What does the code P0700 and P1855 mean on a 2005 suzuki forenza?
P0700 is just the engine controller telling you the trans controller has a code.
P1855 is Solenoid 2 output open.
How do you replace the timing belt on a 2004 suzuki forenza?
Timing Belt Removal and Installation
Removal
- Disconnect the negative battery cable.
- Disconnect the Manifold Air Temperature (MAT) sensor connector.
- Disconnect the air cleaner outlet hose from the throttle body.
- Disconnect the breather tube from the camshaft cover.
- Remove the air cleaner housing bolts.
- Remove the air cleaner housing.
- Remove the right front wheel.
- Remove the right front wheel well splash shield.
- Remove the serpentine accessory drive belt.
- Remove the crankshaft pulley bolts.
- Remove the crankshaft pulley.
- Remove the right engine mount bracket.
- Remove the front timing belt cover bolts.
- Remove the front timing belt cover.
- Using the crankshaft gear bolt, rotate the crankshaft clockwise until the timing mark on the crankshaft gear is aligned with the notch at the bottom of the rear timing belt cover.
- Align the camshaft gears with the notch on the camshaft cover.
- Remove the timing belt.
- Loosen the automatic tensioner bolt. Turn the hex-key tab to relieve belt tension. Installation
- Align the timing mark on the crankshaft gear with the notch on the bottom of the rear timing belt cover.
- Align the timing marks on the camshaft gears, using the intake gear mark for the intake gear and the exhaust gear mark for the exhaust gear.
- Install the timing belt.
- Turn the hex-key tab in a clockwise direction to tension the belt. Turn until the pointer aligns with the notch.
- Install the automatic tensioner bolt. Tighten: Tighten the automatic tensioner bolt to 25 Nm (18 ft. lbs.) .
- Rotate the crankshaft two full turns clockwise using the crankshaft pulley bolt.
- Recheck the automatic tensioner pointer.
- Install the front timing belt cover.
- Install the front timing belt cover bolts. Tighten: Tighten the front timing belt cover bolts to 6 Nm (53 inch lbs.) .
- Install the right engine mount bracket.
- Install the crankshaft pulley.
- Install the crankshaft pulley bolts. Tighten: Tighten the crankshaft pulley bolts to 20 Nm (15 ft. lbs.) .
- Install the serpentine accessory drive belt.
- Install the right front wheel well splash shield.
- Install the right front wheel.
- Install the air cleaner housing.
- Install the air cleaner housing bolts. Tighten: Tighten the air cleaner housing bolts to 10 Nm (89 inch lbs.) .
- Connect the air cleaner outlet hose to the throttle body.
- Connect the breather tube to the camshaft cover.
- Connect the MAT sensor connector.
- Connect the negative battery cable.
Airbag light on Suzuki Forenza stays on?
This is a common problem on this model car. First, has your car been involved in an accident? if the answer is no and one day the light was off, and suddenly without impact it is now on, chances are it is the connection under the drivers seat that is the problem.
Another problem with this car is the clock spring. this is a connection between the steering wheel and steering column. the wires in it break from normal driving and thus the light comes on. Either way your going to have to make a trip back to Suzuki to have the error read and cleared. Sorry to have to break the news to you. I personally believe that there should be a class-action lawsuit and a recall for this problem, but I won't hold my breath. GM-DAT won't see any more of my business!!!
By a sheer stroke of grace from God your problem could be as simple as mine was. The fuse inside the car on the far lateral end of the driver's side of the dashboard in that location was blown. I replaced it and the problem was gone! Good luck.
Where is the turn signal relay on the 2006 suzuki forenza?
under driver side by kickpanel,green connetor
Where is oil pump on a 2005 Suzuki Forenza?
Near bottom of engine in oil pan. it has a pick up that draws oil from pan's sump. To access, pan must be removed on bottom of engine.
Where is the transmission dip stick on a Suzuki Forenza?
there is not one open your owners manual and it is all there for you
How do you change Timing belt diagram for 2004 suzuki forenza?
Changing the timing belt is a major undertaking and a mistake in installing the new one could cause severe damage to your engine. This is not a job for a do-it-yourself person. I would highly suggest you take it to a qualified mechanic and let them do the work.
What causes a ticking sound when starting suzuki forenza on cold mornings?
Lack of oil lubrication to lifters
