BMW 7-Series

The oil filter on a 1993 300SE 3.2L is typically located on the side of the engine block, usually closer to the front of the engine. It may be accessed from under the car or from the top, depending on the specific model. It is typically a cylindrical or canister-shaped component that is easily recognizable.

The oil filter on a 2001 Oldsmobile Aurora with a V6 3.5L engine is located underneath the car, towards the front of the engine. It is typically positioned towards the bottom of the engine block, making it accessible from under the car.

you need the special wire tools...they sort of look like big v-shaped paper clips. You need 2, one on each side of the radio. You may have noticed 2 little holes on each side of the radio's front. The radio removal tool is inserted in the holes, and it attaches to little clips inside. You then pull the radio out. I believe that when you remove the radio, the security system scrambles the radio's code, and it must be re-programed in order for the radio to work. I think your local MB dealer can help you with that...or a local radio shop familiar with MB radios.

Open the trunk and pull down the carpet on the left wall. It should be there. It is usually a box about 6" x 3" and about 1.5" high, with a single plug in the center. The plug is virtually square in shape.

Open the hood and look around you will find a small black square box with a cap; open it you will see a small post appx. 1/2 in in diameter. Connect the + (positive) to it and - (negative) to the metal if you can not open the trunk. Other wise the battery is located on the right hand corner (passenger side) in the trunk.

most codes 5 numbers i have the same BMW 740i try this code 16526 does not hurt to try it carlos puchades

behind glove box.

1)get all the remotes you want to program even the ones already programmed(you can program up to 4 remotes)

2)get inside car and close all doors

3)insert key into ignition lock

4)turn ignition on then off and remove the key from the ignition cylinder

in less than 20 sec

5)press and hold the unlock button

6)press the lock button 3 times then release both buttons (the doors should lock then unlock)

to program additional remotes repeat the steps 5 an 6 on the other remotes in the same time interval without opening any doors or turning on ignition

7)open the door or open ignition to finish the programming process

what number fuse for washer jet

497

BMW is a famous automotive brand for high performance cars.

In order to check or change trans fluid on BMW vehicles with no dipstick a hoist or set of ramps is needed. Remove upper plug in drain pan under the vehicle. make sure vehicle is running for level inspections. Do not run vehicle if draining fluid!

proper level of oil when vehicle running is level with opening in side of trans oil pan.

5x120mm

About 8 inches and a slightly slower 0-60 time.

The "I" stands for any gasoline powered engine.

The "L" stands for long wheelbase.

yes they will fit but not vise versa. 15" rims on the 1995 I believe 16" rims with large tires on the 2000.

carbon monoxide

The right offset and a 275 25 24 tire yes.

5x120

the youngest girl to hve a kid was 9 years old!

Do you mean oil separator or oil separator valve?

BUELLGUY

where is oil filter for 2006 Pontiac pursuit

No, generally speaking the transmission ecu communicates with the cars DME.....and they are usually generation specific. The 94 7 series would be an E32 and a different generation than yours. further more, you may find that even within your your generation, there may be 3 or 4 different part #'s for the trans computer. You MUST get the exact same part # as the one that is in the car now, or it will not communicate with the DME properly. Hope this helps