answersLogoWhite

0

Buick Lacrosse

The Buick LaCrosse is a mid-size luxury car manufactured by General Motors from September 2004 to the present. Two generations of this car have been produced; both are offered as a four-door sedan.

466 Questions

How wide is the 2011 Buick LaCrosse?

The 2011 Buick LaCrosse is 6 ft. 1.1 in. (73.1 in.)12V front and 12V rear power outlet(s) wide.

How much does a factory standard 2005 Buick LaCrosse weigh?

A 2005 Buick LaCrosse weighs around 3556 lbs. The Buick LaCrosse was first released by General Motors in 2005. The last of the first edition left the assembly line in December 2008.

2005 Buick Lacrosse stalls after engine is started?

Type your answer here... If the engine is not running after starting; yes, it has stalled.

How do you remove a 2006 lacrosse headlamp?

The bright light fitting is the same as the dim so take it apart first to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you more space.

What is the drivetrain warranty on the 2010 Buick LaCrosse?

The drivetrain warranty of the 2010 Buick LaCrosse is 5 yr./ 100000 mi..

What is the rear track of the 2009 Buick LaCrosse?

The rear track of the 2009 Buick LaCrosse is 5 ft. 1.5 in. (61.5 in.).

What is the wheel base of the 2010 Buick LaCrosse?

The 2010 Buick LaCrosse has a 9 ft. 3.7 in. (111.7 in.) wheel base.

The secondary air injection pump is working but the code that came up indicates it is bad What else could it be?

The code is thrown when the exhaust system oxygen sensor does not see a stream of oxygen rich fresh air. I had the same problem and reduced the answer to a secondary air injection shutoff valve. There are two valves that are vacuum actuated, one for each manifold pipe. One valve is located on the drivers side at the front of the engine and the other valve is located on the rear passenger side near the firewall. You will have to remove the radiator surge tank to access this one. Start with the easy front one and remove the vacuum hose from the nipple. Take a spare piece of vacuum hose and attach. Using your mouth to apply vacuum and place your tongue on the end of the hose to maintain vacuum. If vacuum cannot be held then it is a diaphragm leak and cannot be fixed. If this works, do the same to the rear valve. Unfortunately this was my failed valve. This valve corresponds with the right side and is part number AC Delco 214-2114. It comes with the convoluted pipe that connects to the exhaust system but I removed it and used the existing in place pipe as it was near impossible for me to access the fasteners. If this is your problem, then compare the price at AC-Direct through Amazon. This is where I purchased my part.

Note: Left side part number is AC Delco 214-1940 The above response assumes that the existing vacuum hoses are not leaking and that the vacuum solenoid valve is working (rarely the problem).

How often oil change for Buick Lacrosse 2010?

According to the Owner's Manual, when any of the following occur:

1) When DIC Warning comes on: CHANGE ENGINE OIL SOON

2) Once a year

3) Every 3,000 miles (5,000 km)

What is the curb weight of the 2012 Buick LaCrosse?

The curb weight of the 2012 Buick LaCrosse is 3835 lbs..

How do you replace the drivers side mirror for a 2007 Buick lacrosse?

howyou can replace the

passenger side mirror for a 2007 Buick lacrosse?

How do you change rear turn signal bulb on Buick 2006 lacrosse?

take the screws out of the lens and there will be a socket snaped into the inside. push the safety lock and turn counterclockwise and the bulb will come out if its a 1157 or 2057 push the bulb into the socket and turn it and pull it out, if its a 3057 it just snaps in just pull the bulb

How much is a Buick lacrosse?

A 2013 Buick LaCrosse is $31,660. This four door sedan vehicle comes with all wheel drive, a 2.4L 4 cylinder engine, high safety rating, and traction control.