What is the firing order for a 1970 Buick 455?
The firing order for a 1970-76 455 should be 18436572 Enjoy!
SHOW ME A PIcture of a 1992 Buick lesbare security system wire?
SHOW ME A PIcture of a 1992 buick lesbare securty system wire?"
How much is a 1987 Buick Grand National Turbo car with 106000 miles in very good condition worth?
It is a very collectible car. What it is worth depends on some factors. Is is all original, does it have the original engine and transmission, and most of all is what condition is it in. It can be worth up to $22,000.
What is the torque spec's for 2012 Buick Verano hub mounting bolts and the axle nut.?
For the 2012 Buick Verano, the hub mounting bolts should be torqued to approximately 70 ft-lbs (95 Nm). The axle nut typically requires a torque specification of around 150 ft-lbs (203 Nm). Always consult the vehicle’s service manual for the most accurate and specific torque values before performing any maintenance.
How do you change transmission fluid and filter in a 97 Buick Lesabre?
You can purchase a filter and gasket kit from your local auto parts store. Then using a wide drain pan, drop the transmission oil pan, change the filter, reinstall the pan and refill transmission with aprox 4 qts of ATF. Doing this only changes about half of the fluid, the rest of the old fluid stays in the transmission. If you want to change all the fluid it will take a shop with the right equipment to flush the transmission completely.
How do you find a brake fluid leak on a 1998 Buick lesabre?
To find a brake fluid leak on a 1998 Buick LeSabre, start by visually inspecting the brake lines, hoses, and connections for any signs of fluid or corrosion. Check the brake master cylinder for leaks around the reservoir and the brake booster. Look under the vehicle for any puddles or wet spots, particularly near the wheels and under the brake components. If necessary, you can press the brake pedal while observing these areas to help identify the source of the leak.
Where is the low pressure ac valve on 2003 Buick Century?
On a 2003 Buick Century, the low-pressure AC service valve is typically located on the larger diameter aluminum line that runs from the evaporator to the compressor. It is usually positioned near the firewall on the driver's side of the engine bay. To visually identify it, look for a valve with a plastic cap that is usually blue or black. Always ensure the engine is off and the AC system is not under pressure before attempting to locate or service the valve.
Buick is an American automotive brand that is part of General Motors (GM). Founded in 1899 by David Dunbar Buick, it is known for producing luxury vehicles and is one of the oldest automobile brands in the U.S. The name "Buick" has become synonymous with quality and innovation in the automotive industry. Over the years, the brand has gained a reputation for its comfortable, well-designed cars aimed at a more upscale market.
Where is the oil sensor located on a 2001 3.1 Buick century engine.?
On a 2001 Buick Century with a 3.1L engine, the oil pressure sensor is typically located near the oil filter, on the engine block. It is usually mounted on the lower rear side of the engine, close to the oil pump. To access it, you may need to remove some components or work from underneath the vehicle.
How do you install Buick 3800 series 2 motor push rods and pistons?
To install the push rods and pistons in a Buick 3800 Series II motor, start by ensuring the engine is at Top Dead Center (TDC) on the compression stroke for the cylinder you’re working on. Install the pistons into their respective cylinders, making sure to orient them correctly, then use a piston ring compressor to seat them properly. For the push rods, align them with the lifters and rocker arms, ensuring they are seated correctly before tightening the rocker arm bolts to the specified torque. Always refer to the vehicle’s service manual for precise specifications and procedures.
Is 92000 miles good for 2010 Buick enclave?
That's within the range of being considered average usage.
Where is the fan blower on a 1993 Buick century?
The fan blower on a 1993 Buick Century is located inside the vehicle, typically under the dashboard on the passenger side. To access it, you may need to remove the passenger side kick panel and potentially the glove compartment. The blower motor is usually mounted in the HVAC housing. If you're having trouble locating it, consulting the vehicle's service manual can provide detailed guidance.
Where is the fuel cut off switch on 1992 Buick roadmaster?
A 1992 Buick does not have an inertia or fuel cut off switch.
Where is the oxygen sensors located on a 2000 Buick limited 3.8?
They are threaded into the exhaust system at various points.
Where is the Buick Gallery And Research Center in Flint Michigan located?
The address of the Buick Gallery And Research Center is: 303 Walnut St, Flint, MI 48503
What is the drivetrain warranty on the 2010 Buick Enclave?
The drivetrain warranty of the 2010 Buick Enclave is 5 yr./ 100000 mi..